NordicTrack Exp3000 Support Question
NordicTrack Exp3000 Support Question
Find answers below for this question about NordicTrack Exp3000.Need a NordicTrack Exp3000 manual? We have 1 online manual for this item!
Current Answers
Answer #1: Posted by BusterDoogen on November 5th, 2015 6:40 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,407
Member since:
October 30th, 2011 Points: 28,565,407
Without the model # all I can suggest is that you go here & input the model info in to get the manual for the start up procedure.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related NordicTrack Exp3000 Manual Pages
English Manual - Page 3
... hand weights and not holding the handrails may affect the accuracy of clearance behind it is turned off switch.)
19. Place the treadmill on any surface that the storage latch is being ...unattended while it . Do not use an extension cord.
11. Wear appropriate exercise clothing when using the treadmill.
15. Use only a UL-listed surge protector, rated at least eight...
English Manual - Page 5
...at 1-888-825-2588, Monday through Friday, 6 a.m. until 6 p.m.
And when you're not exercising, the unique EXP3000 can be folded up, requiring less than half the floor space of your home. To help you ..., read this manual for selecting the revolutionary NordicTrack® EXP3000 treadmill. The model number of this manual carefully before calling. BEFORE YOU BEGIN
Thank you for...
English Manual - Page 6
... replacement Base Pad (99) may be included.
If there is coated with two Screws (100) as shown.
Make sure that the
69
Extension Leg is turned so the Base Pad (99) is in the position shown
1
Insert one of the packing materials until the treadmill is on the Lock Pin. Do...
English Manual - Page 7
...pulse sensor.
1.
Tighten all parts are not put in the Console Base (see page 27). Turn the Receiver so the cylinder is a thin sheet of clear plastic on the back of the ... (88). Remove the indicated Screws from damage, place a mat under the treadmill. Turn the Handrail Bushings so they fit against the Upright with Handrail Washers (77) into the bottom of the Handrail Spacers ...
English Manual - Page 8
...on or off. Some 2-pole receptacle outlet box covers are in your tread-
1
mill being turned on a nominal 120-volt circuit,
and has a grounding plug that looks like the plug ... a properly grounded outlet (drawing 1) can be installed by a metal screw.
Such substances will not fit the outlet, have a proper outlet in drawing 2 may be grounded. Important: The treadmill is properly...
English Manual - Page 9
... www.iFIT.com
that will help you get even more from your workouts as a personal trainer guides you exercise, the console will provide continuous exercise feedback. Note: The fitness
you get the most from your relative fitness level and a pulse- To purchase iFIT.com CD's or videocassettes or an
The console also features new...
English Manual - Page 10
... key from the display.
To enter your clothes. To use the fitness test program, see page 12. To use the manual mode of ... precautions.
• Do not stand on the walking belt when turning on the power.
• Always wear the clip (see the...Various factors may automatically calibrate itself-the treadmill will affect your exercise hart rate.
• Using hand weights and not holding ...
English Manual - Page 13
ments of the columns to page 24 and turn off position and unplug the power cord.
13
The speed setting for
the first segment
will be shown in the Current Segment column are lit, ...
English Manual - Page 14
... the Stop button.
To use the custom program, see HOW TO USE CUSTOM PROGRAMS on the button will then move one to page 24 and turn off switch near the power cord to start the walking belt. Refer to forty segments. tor will show the elapsed time instead of the custom...
English Manual - Page 15
... the custom pro- The Time display will begin walking.
The Time display shows both the Current Segment column and the column to page 24 and turn off position and unplug the power cord.
15
English Manual - Page 16
...is not detected 4 minutes after the buttons are
not shown in - If you have already exercised during the day. Your age will appear in the Time display.
The speed setting
Current ... is followed by a 2-minute
cool-down segment has begun. Follow the steps below to use the fitness test program.
Test Indicator
mode will show an "L 3." gram, the program display will be used ...
English Manual - Page 17
...medication will affect your exercise heart rate. If your workout. Follow the steps below to enter your fitness level will appear in memory.
17 To se- After the fitness test program is ...Heart Rate/Calories display.
Remember, the fitness program is not detected during your pulse is intended only to indicate your age to page 24 and turn off switch near a target level ...
English Manual - Page 18
... any further.
A moment after the key is removed, the console is raised to page 21 and turn off position and unplug the power cord.
18 cline will move the on page 11.
7 When ... settings for the second segment will automatically change as needed to start the program.
If you exercise, the speed and/or incline of the treadmill is divided into several time segments
of tones ...
English Manual - Page 21
... appear in a secure place. For the most accurate heart rate reading, continue to page 24 and turn off the demo mode. The incline must be resting on /off position and unplug the power cord.... when the treadmill is raised to change from the console and put it . When you are finished exercising, stop the walking belt and remove the key. The Time display will change the unit of the ...
English Manual - Page 22
... the iFIT.com indicator is lit and that the incline of your CD player or VCR. The Time display will begin to page 24 and turn off the demo mode. Note: If the displays and indicators on the console remain lit after the key is removed, the console is not wrapped...
English Manual - Page 23
... program from our internet site. A list of specific system requirements will begin to your specific exercise goals. To use programs from the internet. CAUTION: Always listen for using the treadmill, move...next "chirp" is not flashing.
When the program is removed, refer to page 24 and turn off
position and unplug the power cord.
23
By adding an optional upgrade module to the...
English Manual - Page 24
.../Laps display will appear in a preset sequence, although the buttons on and turn off the demo mode.
In addition, the information mode allows you to kilometers... call toll-free 1-888825-2588.
Press the Speed + button to the console. This mode is intended to turn on the console will not operate. THE INFORMATION MODE/DEMO MODE
THE OPTIONAL CHEST PULSE SENSOR
The console features ...
English Manual - Page 26
.... c. Raise the Uprights (69) and carefully remove
39
the hood.
69
83
b. Turn the Pulley until 6 p.m. Top View
26 Important: The treadmill is about 1/8".
Remove the...applies, and follow the steps listed. c Tripped
Reset
Tripped
d On
Position
Reset
PROBLEM: The power turns off during use
SOLUTION: a. above).
c. Re-attach the hood, and run , please call our ...
English Manual - Page 27
... on , first remove the key and UNPLUG THE POWER CORD.
Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of a turn . Remove the key and UNPLUG THE POWER CORD. PROBLEM: The walking belt slips when walked on
SOLUTION: a. Repeat until the walking belt is changing, remove...
English Manual - Page 34
.... Remember to do the periodic maintenance requirements specified in USA © 2000 ICON Health & Fitness, Inc. Before shipping, always obtain a Return Authorization Number (RA No.) from our Customer ...They will replace the Product.
LIMITED WARRANTY
WHAT IS COVERED-The entire NordicTrack® EXP3000 treadmill ("Product") is warranted to be free of all other rights which vary from ...
Similar Questions
Controls Not Working On Exp3000
Bought a used exp3000, it seemed to work fine. Took it home, plugged it in and only the display ligh...
Bought a used exp3000, it seemed to work fine. Took it home, plugged it in and only the display ligh...
(Posted by bentley92142 3 years ago)
