Miele DA 249 Support Question
Miele DA 249 Support Question
Find answers below for this question about Miele DA 249.Need a Miele DA 249 manual? We have 3 online manuals for this item!
Question posted by archermichael on December 5th, 2012
Power Supply And Connection
My rangehood will not switch on
Current Answers
Related Miele DA 249 Manual Pages
Operating manual - Page 1
en - US, CA
M.-Nr. 07 781 040 Operating and Installation Instructions
Ventilation System DA 249-4
To prevent accidents and appliance damage, read these instructions before installation or use.
Operating manual - Page 2
...INSTRUCTIONS 3 Functional description 7 Guide to the Ventilation System 8 Operation 10 Turning on the fan 10 Selecting the power level 10 Delayed Shut Down 12 Turning off the fan 12 Turning the lighting on/off 13 Dimming the ... Appliance dimensions 28 Plywood backing 31 Installation 32 Installation 34 Dismantling 34 Air extraction 35 Electrical connection 37 Technical data 38
2
Operating manual - Page 3
... and pass them on to any doubt, have questions, contact Miele.
~ b) Before servicing or cleaning the
appliance, switch power off at the service panel and lock the service disconnecting means to prevent power from being switched on a ship).
,WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING...
Operating manual - Page 4
... any other work and repairs
should not be drawn up into the hood by the suction and the grease filters may ignite. Boilovers cause smoking and greasy spillovers may catch fire.
4 IMPORTANT SAFETY INSTRUCTIONS
~ d) Before connecting the appliance
to the power supply make sure that the voltage and frequency listed on when
cooking at...
Operating manual - Page 5
...PAN - when using
the cooktop to prevent damage from the burners and the cookware.
~ Do not use the hood without
cookware. a violent steam explosion will result.
~ d) Use a fire extinguisher ONLY if:
1) You ... to play with a close
fitting lid, cookie sheet, or metal tray then turn on the hood when using a wok. Steam could penetrate electrical components and cause a short circuit.
5 BE ...
Operating manual - Page 6
... they have different minimum safety distances always select the greater distance.
~ i) Never connect an exhaust hood to
an active chimney, dryer vent, vent flue, or room ventilating ductwork.
~ j) Seek professional advice before
connecting an exhaust hood vent to an existing, inactive chimney or vent flue.
~ k) Any fittings, sealant, or materials
used to prevent back...
Operating manual - Page 7
... panel and the grease filter and directed outside air and room air can occur.
The hood comes equipped with a non-return flap.
The recirculation mode requires an install kit and ... accessories. The filtered air is drawn in place, see "Cleaning and care".
7
The hood offers two modes of operation:
Air extraction
Functional description
Recirculation mode
The air is then recirculated...
Operating manual - Page 9
...
For recirculation use with optional accessories
c Chimney
d Canopy
e Overhead lighting
f Active Charcoal Filter
Available to purchase, for use in use (see "Operation / Filter timers"). k Fan power selection
Four fan speed selection
l Delayed Shut Down
-
Operating manual - Page 10
... speed Level "1" to level "3" after another,
- the "-" button, and
- The fan runs at power level "2".
Automatically switching back the Intensive power level
The intensive level "4" can be used for 10 secs. light,
Intensive setting
Level "4" should be programmed to automatically switch back to "3" are usually sufficient for normal cooking.
^ Press and hold the Delay...
Operating manual - Page 11
..., the automatic switch back is 625 cfm. The power level indicators "1" and "4" light continuously.
^ To deactivate the automatic switch back press the "-" button.
The maximum air flow capacity is not activated.
^ To activate the automatic switch back press the "+" button. If the procedure is not saved within 4 minutes of programming, the hood will also be...
Operating manual - Page 12
... The lighting however will turn off automatically 10 hours after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to turn the fan off the fan
^ Press the On/Off button to turn the fan back on .
^ Press the On/Off button to continue...
Operating manual - Page 14
... be reset.
Please program this , press the charcoal filter button for about 3 seconds. The indicator for the grease filter will light after 30 hours of a power failure.
^ To do this, press the grease filter button for the charcoal filter is not preset. After the grease filter have been used :
^ Press the...
Operating manual - Page 17
...using a soft cloth. Cleaning the casing
Never use a stainless steel cleaner on the hood.
Water could penetrate into the electronics and cause damage. Apply sparingly with abrasive cleaning ...OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
Before cleaning or servicing the hood, disconnect it from the power supply, see "Important Safety Instructions".
,The halogen bulbs are very hot
when ...
Operating manual - Page 22
... bulbs
,WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
Before changing the light bulbs, disconnect the hood from the power supply, see "Important Safety Instructions".
^ Remove the decor cover, see "Cleaning and Care / Removing the decor cover".
^ Pull the old bulb out of its socket...
Operating manual - Page 27
Before discarding an old appliance, disconnect it from the electrical supply and cut off the power cord to be recycled. Caring for the environment
Disposal of suffocation! Disposal of an old appliance
Old appliances may contain materials that any plastic wrappings, ...
Operating manual - Page 35
... and straight as possible.
- If the exhaust is used .
35
Do not vent exhaust air into the appliance.
-
Exhaust ducting and connections
Use smooth or flexible pipework made from the hood at least 1/8" per foot (1 cm per meter) to prevent condensation dripping into spaces within walls or ceilings or in attics, crawl...
Operating manual - Page 36
Never connect an exhaust hood to the flow direction of the flue. When installing a condensate trap, ...If the ductwork runs through rooms, ceilings, garages, etc. Air extraction
Condensate trap
optional accessory
- Seek professional advice before connecting an exhaust hood vent to reduce condensation.
36 where temperature variations exist, it is available for ducts 5" (125 mm) and 6" ...
Operating manual - Page 37
... behind the grease filters), match the household electrical supply before installing the hood.
^ Use only with ventilation hood cord-connection kits that is any question concerning the electrical connection of the house checked by a qualified electrician. Grounding Instructions
This appliance must be grounded.
If the power supply cord is equipped with a cord having a grounding wire...
DA249 - Page 1
SPECIFICATION SHEETS 010405 O - Product Dimensions Decorator Wall Hood
DA249-3
E O
11 1/16"
8 1/2"
11 1/4"
12 1/2"
Front Perspective
20 9/16" - 30 7/16" See Notes
19 11/16"
Location Codes E - 110 Volt - 15 Amp 3-wire power
supply connects through top or rear of chimney. Standard 110 Volt Outlet
Notes • All installations must be done in
accordance with local codes...
DA249 - Page 2
.... Minimum distance "S" is: - 18" for electric surfaces - 26" for gas surfaces
• Area behind mounting plates MUST be affixed to scale. Installation Dimensions Decorator Wall Hoods
DA249-3
Structural member
Ceiling Line
13 3/8"
Area must be reinforced with a minimum of 1/2" plywood. SPECIFICATION SHEETS 010405
Similar Questions
Miele Cooker Hood Da6690w
miele cooker hood DA6690W leds flickering when switched on ,program OK, click when switched on.
miele cooker hood DA6690W leds flickering when switched on ,program OK, click when switched on.
(Posted by jjhinchy365 2 years ago)
Miele Da 249-1 Intermittent Failure Of Switches
The unit switches on ok every time, light switch is ok, fan speed switches only work occasionally, s...
The unit switches on ok every time, light switch is ok, fan speed switches only work occasionally, s...
(Posted by marcelmangelsdorf 8 years ago)
Miele Da 249-2 Hood Touch Control Panel Broke
Hello, we use our Miele DA 249-2 hood and we're very happy with it. A short time ago the touch contr...
Hello, we use our Miele DA 249-2 hood and we're very happy with it. A short time ago the touch contr...
(Posted by avernov 8 years ago)
Hood Stop Working?
Hood stop working? No tripped switch at the electrical panel.
Hood stop working? No tripped switch at the electrical panel.
(Posted by erikrh33317 10 years ago)
What Is The Shipping Weight Of The Miele Decorator Wall Hood Da-249-3
(Posted by carolync26246 10 years ago)