Maytag MFW9800TQ Support Question
Maytag MFW9800TQ Support Question
Find answers below for this question about Maytag MFW9800TQ - 27" Front-Load Washer.Need a Maytag MFW9800TQ manual? We have 2 online manuals for this item!
Question posted by russell87441 on September 18th, 2012
Washer Noisey During Spin. Likely Bearings Or Clutch Issue?
The person who posted this question about this Maytag product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by majorapplirepair on September 20th, 2012 5:41 PM
majorapplirepair
Member since:
October 7th, 2011 Points: 139,880
Member since:
October 7th, 2011 Points: 139,880
Related Maytag MFW9800TQ Manual Pages
Use and Care Guide - Page 3
... killed or seriously injured if you what the potential hazard is the safety alert symbol. This symbol alerts you to reduce the chance of others . WASHER SAFETY
Your safety and the safety of injury, and tell you don't follow the safety alert symbol and either the word "DANGER" or "WARNING." Always...
Use and Care Guide - Page 4
...instructions before using the washing
have been previously cleaned in, washed in, soaked in the washer drum.
HYDROGEN GAS IS
servicing unless specifically recommended in
EXPLOSIVE. This will be exposed to... gas may be
■ Do not tamper with gasoline,
supervision of children is necessary when the washer is
flammable, do not smoke or use an open to 1 39.5 mm])
■ Flashlight ...
Use and Care Guide - Page 5
... or Service" section. Parts supplied: A
B C
Options
Pedestal A pedestal will need to Buy
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system (if not already available)
Overhead ...
15.5" (39.4 cm)
Blue
MHP1500SK
Stack Kit
Are you are interested in purchasing one of the washer for Part Number 8212640.
5 Ask for a total height of fill hoses
2 longer water fill hoses...
Use and Care Guide - Page 6
...shown are for your washer improves performance and minimizes noise and possible washer "walk."
Your washer can cause damage in a basement, laundry room, closet, or ... a maximum slope of the washer is your washer in temperatures below 32°F (0°C). Washer only
■ Additional spacing should also be fully opened.
Washer Dimensions
51" (129.5 cm)
27" (68.6 cm)
Companion...
Use and Care Guide - Page 7
... * (155 cm2)
3"* (7.6 cm)
1"* (2.5 cm)
6"* (15.2 cm)
76" (193 cm)
1" (2.5 cm)
27" (68.6 cm)
1"
1" 31¹⁄₂" 4"
(2.5 cm) (2.5 cm) (80 cm) (10.2 cm)
A
B
A. Recessed... spacing for recessed or closet installation, with stacked washer and dryer
The dimensions shown are for the recommended spacing. closet or confined area B. Washer on pedestal
18" min. (45.7 cm)
...
Use and Care Guide - Page 8
... can result in the top are
required.
7" (17.8 cm) 7" (17.8 cm)
Laundry tub drain system (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity.
Select the drain hose installation method ...(76.2 cm)
28" min. (71 cm)
4"
31½" 1" 1" 27"
1"
(10.2 cm) (80.0 cm) (2.5 cm) (2.5 cm) (68.6 cm) (2.5 cm)
Drain System
The washer can be at least 30" (76.2 cm) above the floor. Do not ...
Use and Care Guide - Page 9
... providing a path of its final location. GROUNDING INSTRUCTIONS
For a grounded, cord-connected washer: This washer must be connected to your local service center. Do not modify the plug provided with... bolt,
including the plastic spacer covering the bolt.
3.
For a permanently connected washer: This washer must be plugged into an appropriate outlet that the ground path is to be ...
Use and Care Guide - Page 12
... suspension system and controls are specially designed to five different spin speed choices. You are also able to detect load size and the amount of all the laundry products before they touch any garments. Spin Speeds This washer automatically selects the spin speed based on when a cycle is heated. This enables stepped cleaning, a process in and...
Use and Care Guide - Page 13
...cleaning. ■ The washer can completely remove oil. The package for this manual for small items.
13 HE detergents are dampened with less water, will likely result in a mesh garment... Without Laundry
Before washing clothes for a medium-size load.
Sort laundry according to ensure the interior is recommended that has ever had any type of this appliance. Starting Your Washer
WARNING...
Use and Care Guide - Page 14
... desired Options, such as Soil Level, Water Temp, Spin Speed and Cycle End Signal. Not all options are available... the wash cycle is complete.
Laundry products are made to produce the right amount of detergent will likely result in the dispenser drawer slowly...load can be opened and then closed before a new cycle can be removed from the washer as soon as it stops.
Do not put laundry...
Use and Care Guide - Page 16
... Options or Modifiers after the Add a Garment period, press PAUSE/OFF twice. Select DRAIN/SPIN. 3. They also indicate when you can be changed anytime before HOLD TO START is complete...water pressure, water temperature, detergent and clothes load. Adding items This washer allows an 8-minute period in which portion of the cycle the washer is selected and before the door unlocks. Select...
Use and Care Guide - Page 17
... addition of bleach. Drain without drum movement improve the removal of the laundry, and a soaking time without spin assures gentle treatment, even for the selected cycle.
■ The preset...you can reduce the spin speed by selecting the speed you want from the SPIN SPEED modifier. Drain/Spin Use this cycle to drain and spin your washer or to wash small loads of synthetics, delicate ...
Use and Care Guide - Page 18
... can add or change the preset cycle settings Press the selector of normal washer operation. Between changes in wash actions, there will then be momentary pauses. Options
You can customize your cycle selections. Laundry will be soaked by phases without spinning. ■ Add detergent to the main wash cycle. Oxi Prewash Use this...
Use and Care Guide - Page 19
... SPIN SPEED button until the cycle is paused before the selected modifier begins. Modifiers
Preset cycle settings of your laundry when a load cannot be removed from garments. Cold rinses save energy.
You can be difficult to remove. In cold climates, a warm rinse makes the load more comfortable to finish the cycle and unload the washer...
Use and Care Guide - Page 20
.... ■ Tie strings and sashes so they will likely result in component failures and noticeable mold or mildew. ... cotton, linen, polyester or nylon
✔
Drain/Spin
Fabrics made to produce the right amount of detergent ... Follow these washer cycles.
Extra Rinse
✔ ✔
✔ ✔ ✔
✔
LAUNDRY TIPS
Preparing clothes for suggested load types and ...
Use and Care Guide - Page 21
...10 hand towels
Mixed Load 3 sheets (1 king, 2 twin) 4 pillowcases 3 shirts 3 blouses
Loading
2 sweatpants 2 sweatshirts
14 washcloths
9 T-shirts 9 shorts 10 handkerchiefs
WASHER CARE
Cleaning Your Washer
Cleaning the exterior Use... be on a Drain/Spin cycle. 3. Cleaning the interior To keep it will be
washed together.
Run washer on vacation or not using your washer for proper use or...
Use and Care Guide - Page 22
...on a Drain/Spin cycle.
2. Follow the "Installation Instructions" to faucets. Unplug washer or disconnect power.
This routine removes extra suds and assures proper rinsing of your washer, it must ... to inform you that Suds Routine was activated. Reinstalling the washer 1.
If the problem remains, call for a medium-size load, to cancel the cycle. Is the drain hose frozen? Is...
Use and Care Guide - Page 23
... held for flooring requirements. Cycle will complete once extra suds are removed.
■ Is the load balanced? As water is drained from the washer. The plywood may hear air being pulled through the pump. Washer won't drain or spin
■ Is the drain hose clogged, or the end of ¾" (19.1 mm) plywood underneath...
Use and Care Guide - Page 24
...Did you unload the washer promptly? Dispensers clogged or leaking
■ Are the laundry products in the drum, and start a Drain/Spin cycle. Select a cycle with a low spin speed to the dispenser...rust) in pockets?
■ Did you properly sort the load? Residue or lint on load
■ Did you overloaded the washer? Follow the manufacturer's instructions to determine the amount of ...
Use and Care Guide - Page 25
... your correspondence. During the imbalance routine, the time displayed may save you wash a large load using the Quick Wash cycle? ASSISTANCE OR SERVICE
Before calling for your request. Door locked at the end of the washer during the spin? It may pause until this cycle, wash time will be increased.
■ Did you...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Dispensers are not working correctly - Front-load Neptune® washer with rear-mounted console
... manufacturer's directions. Enter Model Number How do I find my model number? Front-load Epic Z washer Not draining, not spinning out water, wet loads - Front-load Neptune® Is liquid chlorine bleach remaining in the correct dispenser compartment? Always use any excess laundry additives. Follow illustration 3 to this compartment. Color-safe bleach is normal. Do... -
Will Affresh tablets damage my clothing?
... spinning out water, wet loads - For additional information on Affresh washer cleaner, click What happens if I don't clean my HE washer? No. Affresh tablets will not damage clothing if placed in with Dispenser Drawer - video Will Affresh tablets damage my clothing? Will Affresh tablets damage my clothing? Top-load HE washer with a load of laundry. ... -
Lint is on the load - Front-load washer
... to create more likely to trap lint. Did you washing new clothing or linen items? Sort loads before starting a new load of lint o n my clothes. video Top-load HE washer with darks. Turn denim jeans and khaki pants inside out to tumble freely. Make sure that there are not any laundry items ...
Similar Questions
How To Replace Bearing On Bravos Top Load Washer
(Posted by kjfpd 9 years ago)
Maytag Mfw9800tk0 Making Loud Knocking Sound During Spin Cycle, Is It The Bearin
I don't overload my wash, when it spins really really fast, the knocking sound is not as load, or so...
I don't overload my wash, when it spins really really fast, the knocking sound is not as load, or so...
(Posted by Dchamp327 9 years ago)
What Does It Cost To Replace Bearings On Maytag Top Loading Bravos Washer
(Posted by kcingw 9 years ago)
Does My Maytag Epic Washer Have A Reset Button
The control is locked on my washer, is there a reset button or buttons?
The control is locked on my washer, is there a reset button or buttons?
(Posted by Alchar 10 years ago)
