Maytag MAH5500BWW Support Question
Maytag MAH5500BWW Support Question
Find answers below for this question about Maytag MAH5500BWW - Neptune Series 27'' Front-Load Washer.Need a Maytag MAH5500BWW manual? We have 2 online manuals for this item!
Question posted by framorrow on December 6th, 2014
What Causes My Washer, Model Mah5500www To Have Improper Wash Times?
The person who posted this question about this Maytag product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by Odin on December 6th, 2014 1:22 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,640
Member since:
April 10th, 2010 Points: 41,236,640
Sorry for your problems. On this repairclinic page, click the link that best describes the improper wash times you've experienced.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MAH5500BWW Manual Pages
Use and Care Guide - Page 2
.... Always contact your purchase of a Maytag® Neptune® washer! Hazards or unsafe practices which is not grounded adequately...washed in, soaked in minor personal injury. Date of these substances.
Install and level washer on your manufacturer about safety instructions Warning and Important Safety Instructions appearing in the washer until all traces of Purchase Model...
Use and Care Guide - Page 3
... more . Use laundry aids only as detergents, bleach, etc., out of the reach of children, preferably in the same wash. Small particles can stick to avoid slamming. Inlet hoses are soiled with vegetable or cooking oil.These items may reduce washing efficiency and possibly cause creasing or wrinkling of the load.
• When washing big bulky...
Use and Care Guide - Page 5
... not overload the washer.
4 Spins only.
Use for cleaning lightly soiled loads. Use for better stain removal. spin - Allows the start of the cycle to 9 hours in one or more completely remove laundry additives and perfumes. Can be appropriate for one hour or press the pad again to increase the delay wash time up to...
Use and Care Guide - Page 6
... water and energy. Step 7
START YOUR MAYTAG NEPTUNE® WASHER
• Close the door. • Add detergent and additives to open easily. Do not attempt to the dispenser (See page 6). • Push the start /pause pad to better indicate the wash time left in the cycle.The estimated time remaining may fluctuate to stop the...
Use and Care Guide - Page 7
granular or liquid.
All laundry products can be added at the appropriate time for best results. • When adding color-safe bleach with small or lightly soiled loads. If color-safe bleach is important to use a ..., it is best if both laundry products are trademarks of the load, load size, and water hardness**. FEATURES
DETERGENT
Your Maytag Neptune® washer is filling.
2.
Use and Care Guide - Page 9
... will shut off the water faucets after finishing the day's washing. Run the washer through your washer interior.
Follow illustration #3 to clean and freshen your washer, or the use abrasive powders or cleaning pads. Do not use of damage from the washer before doing a load of laundry.
1
2
3
OFTENER
BLEACH FILL
AX M
S M
AX FILL
8 We recommend taking the...
Service Manual - Page 19
... a suds reduction routine, consisting of a series of additional rinse and partial drain cycles to retract at End of the cycle.
3. The washer will vary based on -M ax Ex t.../3 1.0 50 0/5.0
Notes: 1.
The main wash time is affected significantly if the machine control detects an excessive amount of clothing loads, available water pressure and the time for the door lock system to reduce the...
Service Manual - Page 31
...rapidly accelerate for integrity of the tachometer harness between the motor and motor control board. Set the washer into the back side of a White, Blue and Black wire.
2.
The following table indicates...checks of the connections on the motor control and insert the meter probes into the Delay Wash cycle and press the start without activating the motor. The harness is to tell the motor...
Service Manual - Page 35
....
16008373-01
© 1998 Maytag Corporation
SECTION 3. Replace timer if necessary (See Section 2: Timer Input Circuits). If reversed, the washer will shut down .
SECTION 3. If the required fill time exceeds the time limit, the washer will shut off . This is to prevent flooding in the button of the problem is programmed to allow a maximum...
Service Manual - Page 91
... Fabrics switch now list the cycles according to the Option Switch which adds cycle wash time, various tumble patterns and an additional rinse with the pressure switch, also an ...(Figure 4-2). At series 11 the timer was changed, wire harness revised and the schematic was done to force the washer to fill with water prior to select the cycles in series with longer tumble times during the rinse...
Service Manual - Page 92
...
Easy Care/ Perm Press
Delicates
Hand Washables
7/3
5/3
6/24
3/27
16010199 (16008373-03)
5
Revised 7/00
©2000 Maytag Appliances Sales Company The main wash times listed include 2 minutes of Spin)
Tumble Pattern - The washer will vary based on water fill times, due to types of clothing loads and the time for the door lock system to reduce the...
Service Manual - Page 93
...
4 Minutes Fill & Tumble
4th Rinse
4-1/2 Minutes Fill & Tumble
Final Spin
Total Run Time:
6-1/2 Minutes __________ 46 Minutes
6-1/2 Minutes _________ 74 Minutes
Suds detection during Wash/
Fill cycle. 3. Torque baseline is set during the first 3 minutes of Wash cycle after the washer is an example of the 6/24 tumble action during stain cycle: 1.
Suds detection...
Service Manual - Page 110
... and the washer would be dependent on the MAH7500A model. General Information ©2001 Maytag Appliances Sales Company
1-2 The door lock mechanism was added to the sump area of the door. Heater with a special tumble pattern to non-heavy cycles and some warmer rinses. Soil level and quick wash selections determine wash time. A Wash Tumble Flush...
Service Manual - Page 111
... 2nd Rinse - 2 minutes*
d) Rinse
All Rinses - 3 minutes
*Note: The final rinse time does not include the Tumble Flush time. CYCLE SEQUENCES
Wash Time Tumble: Wash Selections
Tumbling Time
a) Extra Heavy (LCD Model Only)
32 minutes wash tumble 2 minute bleach fill.
d) Light
8 minutes wash tumble 2 minute bleach fill. Tumble Flush time will add a minimum of 30 seconds to a maximum of 60...
Service Manual - Page 115
... unlocked, the door locked LED is selected, the water input temperature, the wash time, the tumbling pattern, speed, and amount of rinses may be restarted with the new selections. USER INTERFACE SELECTIONS:
(LCD Washer)
All selections described under the LED washer section are familiar except in minutes. OPTIONS MODE When the extra rinse key...
Service Manual - Page 117
...models.)
TACH INPUT The tach input is used for monitoring speed and out-of-balance detection (See Tachometer Circuit Diagnostics). HEATER OUTPUT (LCD Washer... for locking and one for both washers. The end-of-cycle signal sounds when a wash cycle is initially selected the machine control...the start /pause input is turned back on at 14 times the speed of cycle signal will not occur unless the...
Service Manual - Page 118
... relays on if the following conditions exist: 1. This output is energized when the washer door is open. 3.
Low level of the signal outputs.
Selecting the energy saver, will turn off periodically to 105°F if
wash time
necessary
During a warm wash the cold may be in the heater assembly. When water fill is required...
Service Manual - Page 120
... door lock switch check shows that the door is logged into the control memory. When the wash cycle is engaged with the slider and slides the slider toward the door lock mechanism and inhibits... control board for 30 seconds and lock again.
The lock lever in the locked position and the washer will show the door has not locked.
2. The slider will actuate the door lock/ unlock microswitch...
Service Manual - Page 121
...When a power loss occurs during a cycle the washer will finish the spin cycle.
MAH5500B:
Information Saved:
Cause:
The beginning of a main wash cycle, the cycle will be placed into an Advertising... power-up after a power-loss during a main wash cycle. After 10 minutes of the Neptune washers. The LCD display will not automatically time-out and cancel a cycle while paused. The display...
Service Manual - Page 130
...Cancel & exit quick spin test: this returns you to the service tests screen. If the washer is not in a wash cycle, the following screen will stop the current cycle.
To toggle outputs, press PAUSE and ...Codes
cycle count XXXX
diagnostic codes: 1... 2... 3... 4... 5... 6... 7... 8.... 9...
At the same time, the screen will display the current status of diagnostic codes.
help codes.
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How do I remove odors from my Top-loading HE washer?
... beginning the cleaning process. Open the washer lid and remove any detergent or load to Clean Washer cycle. 5. Turn the cycle control knob to this cleaning cycle. If your Use and Care Guide for other causes. Add one Affresh washer tablet to maintain washer freshness. Use of the washer. The following to the bleach... -
The cycle time is not correct - Front-load washer
... increase. Are you see "Sud" and the Done status light is not correct - Front-load washer Display shows Sud or Sd - On some models) cycles, wash small loads to spin out water. During this problem. See the animation below for a long time? See: Why HE High Efficiency detergent is not able to provide your... -
Damaged clothing - Top-load washer
... the manufacturer's recommended amount for loose items that could snag fabrics. Use less with less wash time and/or lower wash speeds. Do not place load items on top of the bleach dispenser when loading and unloading the washer (on load - Top-load washer Agitator is damaging my clothes. Empty pockets, zip zippers, and snap or hook fasteners before...
Similar Questions
Maytag Mah5500bww - Neptune Series 27'' Front-load Washer
My Neptune washer cycles and agitates through the rinse cycle but once the timer reaches 5 min or le...
My Neptune washer cycles and agitates through the rinse cycle but once the timer reaches 5 min or le...
(Posted by danjo29 5 years ago)
Unreliable Washing Time
The washer sometimes significantly exceeds the originally estimated time, even seemed to stuck, as t...
The washer sometimes significantly exceeds the originally estimated time, even seemed to stuck, as t...
(Posted by petergalan 7 years ago)
I Have A Maytag Neptune Mah8700aww Front Load Washer And Looking For The Manual.
this is the closest number to what i have.....how can i get the manual for MY washer?
this is the closest number to what i have.....how can i get the manual for MY washer?
(Posted by ljfankhauser 11 years ago)
Maytag Neptune Mah5500b Front Load Washer Stops Running
Stops running after 20-30 minutes displaying OF
Stops running after 20-30 minutes displaying OF
(Posted by Bavaria 11 years ago)
My Maytag Neptune Model #mah65000aww Beeps Three Times And Wont Work.
The circuit board lights up, start/pause button blinks and will beep three times when pushed. I have...
The circuit board lights up, start/pause button blinks and will beep three times when pushed. I have...
(Posted by msctnf 12 years ago)