Maytag MAH5500BWW Support Question
Maytag MAH5500BWW Support Question
Find answers below for this question about Maytag MAH5500BWW - Neptune Series 27'' Front-Load Washer.Need a Maytag MAH5500BWW manual? We have 2 online manuals for this item!
Question posted by danjo29 on February 10th, 2019
Maytag Mah5500bww - Neptune Series 27'' Front-load Washer
My Neptune washer cycles and agitates through the rinse cycle but once the timer reaches 5 min or less in any setting, the entire cycle time restarts and it starts filling again without spinning out the load. The water drains but spin does not occur. It starts to spin but then the time goes back up and it begins the cycle again.
Current Answers
Answer #1: Posted by Odin on February 10th, 2019 7:46 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MAH5500BWW Manual Pages
Use and Care Guide - Page 3
... 15 to damage and deterioration over time.
c. HYDROGEN GAS IS EXPLOSIVE. Keep all laundry aids such as vinegar or rust ...do not fill the tub completely, such as directed by itself.
7. Do not use an open flame during this time.
Do not...the cycle has started to be loaded completely full with controls.
10. d. Service is very important to avoid overloading the washer to ...
Use and Care Guide - Page 5
...minimal tumbling before the regular cycle. The Quick setting offers a quick cycle time. rinse -
A fourth rinse at the end of wrinkle free fabrics, the Max Extract options are not recommended. Removes more completely remove laundry additives and perfumes. Automatically provides a fourth rinse. quick - Make the appropriate selection for your load, then press the delay wash...
Use and Care Guide - Page 7
... for top-loading washers, it is best if both laundry products are in their respective dispenser compartments.They will be added with detergent to the detergent compartment for most effective cleaning.
If color-safe bleach is to be used, it is filling.
2. After loading the laundry additives into the detergent compartment before starting the clothes washer or as...
Use and Care Guide - Page 9
... is possible for a rinse and spin cycle to remove any excess laundry additives. CLEANING THE INTERIOR
Clean the interior of dirt, soil or bacteria being run through a complete cycle using hot water. 5. Failure to follow the illustrations in unsatisfactory conditions, including unpleasant odor and/or permanent stains on the panel.
Fill the bleach dispenser with...
Use and Care Guide - Page 11
... filling, you may start the clothes washer.
Hose filter screens may change as the washer determines the temperature of Cycle
• Use max extract option. • Try using cold water. • Reduce detergent amount for that specific load size, soil level and water hardness. • Use high efficiency or low sudsing detergent specially formulated for front load washers...
Use and Care Guide - Page 15
... not to be dispensed in my Maytag® Neptune® washer? A. Select the hot wash/cold rinse temperature setting and put
3/4 cup of chlorine bleach in which too much detergent was used . (See pg. 3 for optimal whitening. Pretreat the stains with dry, unfolded clothes. How large of the cycle. Q. A. Wash white loads using the cotton/sturdy fabric...
Service Manual - Page 11
... the option switches, and starts the washer. Timer motor. - This continues until the cycle is rotated to the motor control. -
In general, the timer dial is complete. (See Figure 1-7 & 1-8 for the specific timer setting, it energizes the timer motor output to advance the timer to the motor control and other equipment in the Neptune horizontal axis washer generally consists of these...
Service Manual - Page 14
... the washer is energized.
The Timer Motor Output is started with the timer set in a Prewash Tumble, Main Wash Tumble, Light Wash Tumble, or Rinse Tumble increment, the machine control will continue to coast from the final speed.
16008373-01
© 1998 Maytag Corporation
SECTION 1.
NOTE: The washer will not begin the cycle sequence timing until the water level reaches the...
Service Manual - Page 16
... (Series 10 to tumble the washer until 50 seconds after each cycle sequence. CYCLE SEQUENCE DEFINITIONS
NOTE: Refer to Section 2: Timer Input Charts for information on the timing of the spin cycle sequence and will remain energized to advance the timer through a cam on the timer. The machine control will tumble at 51 rpm in the following the third rinse...
Service Manual - Page 19
... routine, consisting of a series of additional rinse and partial drain cycles to retract at End of the cycle.
3. The washer will vary based on -M...Maytag Corporation
SECTION 1. The main wash time is affected significantly if the machine control detects an excessive amount of bleach fill and tumble time.
2.
The main wash times listed include 2 minutes of suds.
N on water fill times...
Service Manual - Page 35
... OFF:
During the wash cycle, the machine control communicates with timer input circuits. (See the following section on the motor control board. If the machine control board sees the switch OPEN during the spin cycle, the machine control board will shut down . If the required fill time exceeds the time limit, the washer will shut off . An...
Service Manual - Page 36
... selection. Machine Operation Does Not Match Cycle Description:
The machine control board monitors where the timer is in the wash cycle. Four input wires from the washer. TROUBLESHOOTING 3 - 2 You can verify this information to start different operations, such as drain, fill, tumble and spin. When the third and fourth rinse are tightened up against the cabinet. Apply...
Service Manual - Page 48
... per cycle, when using the Regular cycle with nominal running amperage at a maximum of 5.0 amps. MISCELLANEOUS INFORMATION
Energy Usage: The energy usage averages up to high speed spin, with Normal wash. Washer Wattages: The following wattages are approximate and without clothes:
Function: Delay Tumbling (empty) & water fill Tumbling (Full-Wash level) Tumbling (Full-Rinse Level...
Service Manual - Page 88
... 4. CYCLE REVIEW 4
Stain Cycle 4 Cycle Times 6 SECTION 6. WATER CARRYING COMPONENTS 9 WATER VALVE 9 DISPENSER ASSEMBLY 9 RECIRCULATION PUMP 10 DETERGENT HOSE 11 SECTION 9. INTRODUCTION
Attached is supplement three (16008373-03) for reference.
Models covered in this manual, including safety issues, contact:
Maytag Appliances Sales Company 240 Edwards Street, S.E. WASHER CONTROLS...
Service Manual - Page 92
... water fill times, due to types of clothing loads and the time for the door lock system to reduce the suds present. (See Troubleshooting & Diagnosis - Cotton/Sturdy
Easy Care/ Perm Press
Delicates
Hand Washables
7/3
5/3
6/24
3/27
16010199 (16008373-03)
5
Revised 7/00
©2000 Maytag Appliances Sales Company Clothes Wet at End of additional rinse and partial drain cycles...
Service Manual - Page 93
...
2nd Rinse 2 Minutes Fill & Tumble
4 Minutes Fill & Tumble
3rd Rinse 2-1/2 Minutes Fill & Tumble
4 Minutes Fill & Tumble
4th Rinse
4-1/2 Minutes Fill & Tumble
Final Spin
Total Run Time:
6-1/2 Minutes __________ 46 Minutes
6-1/2 Minutes _________ 74 Minutes
Suds detection during the first 3 minutes of Wash cycle after the washer is set during stain cycle: 1. Stain Cycle:
General...
Service Manual - Page 110
... door will have recirculation of time.
4) The water fill will be used.
1) The wash cycle is selected and started . For this cycle, less detergent should be allowed in this initial period. The stain cycle option also adds rinse time to the main wash. The temperature of rinses and spin speeds will be dispensed.
8) The washer will then drain and spin...
Service Manual - Page 115
... may not be changed if there is selected, the water input temperature, the wash time, the tumbling pattern, speed, and amount of rinses may be dynamic. When the stain cycle key is less than 2 minutes time remaining in the wash cycle (Bleach Fill). When the door is finally unlocked, the door locked LED is recalculated and...
Service Manual - Page 117
...will log appropriate service codes. The motor runs at 14 times the speed of the switched reluctance motor. If unsuccessful,...start /pause input is turned back on the solenoid. On the MAH7500, the signal sounds then the door is opened right at the end of the cycle or during the main wash until the temperature reaches the targeted main wash temperature. Washer Controls Overview ©2001 Maytag...
Service Manual - Page 119
... wash portion of the spinner basket.
LCD Washer: If four out of seven cycles have suds detected, “Too many Suds detected” should be unlocked until the water reaches high water level or for 4 additional rinses.
If the Start/Pause key is selected then bleach fill and final rinse are based on the user selections. If...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Loads are wrinkled - Neptune® front-load washer
... wrinkled. What can result in warm rinse water setting wrinkles into the fabric. It is connected to the cold-water faucet. Did the wrinkling occur while washing a large load? An overloaded washer keeps the laundry items from the dryer to reduce wrinkles. Did the wrinkling occur during a cycle with a reduced spin speed, warm wash, and cold... -
Dispensers are not working correctly - Front-load Neptune® washer with rear-mounted console
... softener. As you begin to ensure best performance. How do I clean my front-load washer dispensers? Do not fill past the Max-fill lines on the dispenser. front-load washer Manually remove the dispenser and clean any excess laundry additives. Is water left in the dispenser: Liquid chlorine bleach automatically dispenses during the last rinse of water through the dispenser. There... -
Washer continues to fill or continues to drain - Top-load washer
... the drainpipe or laundry tub. Drain hose form Is the drain hose taped onto the drainpipe? Do not seal the drain hose into the drainpipe? Is the drainpipe (standpipe) less than 8" (20.3 cm) into the drainpipe with Dispensers in Corners Not draining, not spinning out water, wet loads - My top-load washer continues to fill or continues to drain - This will...
Similar Questions
I Have A Mhwe500vw It Will Load Water And Then Stops.
I have a MHWE500VW it will load water and then stops. I get a SUD and then F3 error codes. Is it the...
I have a MHWE500VW it will load water and then stops. I get a SUD and then F3 error codes. Is it the...
(Posted by kathegit 5 years ago)
Maytag Neptune Mah Front Load Washer Will Not Drain
(Posted by cuB1Bobs 10 years ago)
I Have A Maytag Neptune Mah8700aww Front Load Washer And Looking For The Manual.
this is the closest number to what i have.....how can i get the manual for MY washer?
this is the closest number to what i have.....how can i get the manual for MY washer?
(Posted by ljfankhauser 11 years ago)
The Washer Fills With Water And The Water Drains Out. It Does Not Tumble. It Spi
The washer fills with water and the water drains out. It does not tumble. It goes into spin and the ...
The washer fills with water and the water drains out. It does not tumble. It goes into spin and the ...
(Posted by felixfthecat 11 years ago)
Water Drain
I wanted to know where is the tube to drain the water?
I wanted to know where is the tube to drain the water?
(Posted by olganarvaez 13 years ago)