Maytag CWG3100AAB Support Question
Maytag CWG3100AAB Support Question
Find answers below for this question about Maytag CWG3100AAB - 24"Gas Single Oven.Need a Maytag CWG3100AAB manual? We have 4 online manuals for this item!
Question posted by lila3072 on June 16th, 2013
F3 Error
I was getting a F3 error message and was told we needed to replace the sensor. I am still getting this error message and my repair man saId it is probably the board, which is discontinued for this model. My oven is over 10 years old. According to the denifition of the error code, it is the sensor..no mention of a bad board.
Current Answers
Answer #1: Posted by waelsaidani1 on June 16th, 2013 11:14 PM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,797
Member since:
May 12th, 2013 Points: 19,501,797
The F3 E2 error code indicates that the electronic oven control board in the range senses an over-temperature condition in the oven.
This can be caused by a failed temperature sensor probe, a wiring problem between the sensor and the control board, or a failed electronic oven control board.
If the oven is apparently not overheating when this error code appears, then your likely failure is the temperature sensor probe.
If the oven is overheating, then you likely have a failed electronic oven control board due to a stuck relay not cycling the oven heating element off properly.
This can be caused by a failed temperature sensor probe, a wiring problem between the sensor and the control board, or a failed electronic oven control board.
If the oven is apparently not overheating when this error code appears, then your likely failure is the temperature sensor probe.
If the oven is overheating, then you likely have a failed electronic oven control board due to a stuck relay not cycling the oven heating element off properly.
Related Maytag CWG3100AAB Manual Pages
Installation Instructions - Page 1
... 24" (61.0 CM) GAS SINGLE AND DOUBLE BUILT-IN OVEN
Table of Contents
BUILT-IN OVEN SAFETY 1 INSTALLATION REQUIREMENTS 3
Tools and Parts 3 Location Requirements 3 Electrical Requirements 4 Gas Supply Requirements 5 INSTALLATION INSTRUCTIONS 6 Prepare Built-In Oven 6 Make Gas Connection 6 Install Oven 7 Complete Installation 8 GAS CONVERSIONS 9 LP Gas Conversion 9 Natural Gas...
Installation Instructions - Page 3
...; Proper gas supply connection must be sealed.
■ Cabinet opening in Cabinet
A
B
F
D
E C
A. 24" (61...Single Oven A
E
B
D
C
A. 22¹⁄₄" (56.8 cm) max. bottom of upper cabinet
door C. 14" (35.6 cm) min. Check existing gas supply and electrical supply. The model...needed
Check local codes and consult gas supplier. Given dimensions provide minimum clearance with oven...
Installation Instructions - Page 4
...Single Oven
A B
E
C
D
D
C
A. 22¹⁄₄" (56.8 cm) max. recessed width B. 46 117.6 cm) max. Recessed oven...) cutout height
NOTE: For gas supply pipe, provide a 3"...Oven A
B E
Cabinet Side View - recessed depth E. 44³⁄₄" (113.4 cm) recessed height
A. 24" (61 cm) min. Do not remove ground prong. Do not use an adapter. Oven front D. Double Oven Double Oven...
Installation Instructions - Page 5
... from the supply and fuel lines so oven will be conducted according to the oven. latest edition or CAN/CGA B149 -
It is needed for turning on the types of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. See "Gas Conversions" section. The model/serial rating plate located behind the...
Installation Instructions - Page 6
... thread ends of the flexible connector adapters (see B and G in the following illustration).
2. Burner Input Requirements
Input ratings shown on the model/serial rating plate.
Locate existing
wiring to remove oven doors. 1. Securely tighten all gas connections. Tighten both hands to avoid drilling into the notches on the final location for elevations up .
Installation Instructions - Page 7
... outlet. 3. Check that connector is indicated. Use pipe-joint compound.
WARNING
Electrical Shock Hazard Plug into cabinet cutout.
7 Use the oven opening as shown in the "Cabinet Dimensions" illustration in the gas supply line. Closed valve B. Plug into a grounded 3 prong outlet. Failure to the adapters. H. Open valve
2. Do not remove ground prong...
Installation Instructions - Page 8
...your oven.
Initial lighting and gas flame adjustments This oven is...single oven, 6 for 5 minutes, feel heat or if an "F" followed by a number appears in the display.
12. Securely fasten oven... before driving screws.
Insert screw.
4. Replace oven racks.
5. Close door.
9. Reconnect ...oven and contact a qualified technician.
5. When oven has been on the hinges.
8. If you need...
Installation Instructions - Page 9
... Hazard Use a new CSA International approved gas supply line. Unplug oven or disconnect power. Gas supply line
G
F
E
D
A. Manifold pressure tap
IMPORTANT: Do not remove the gas pressure regulator.
2. A
B
A. Regulator cap
9 If connected to Natural gas must be done by a qualified installer. To oven B. Shutoff valve (closed position. 2. Manual oven valve F. Unscrew the hex-shaped...
Installation Instructions - Page 10
...position
4. Do
not overtighten. B
A C
A.
Manifold pressure tap
IMPORTANT: Do not remove the gas pressure regulator.
10
To oven B. Gas supply line
To Convert Gas Pressure Regulator 1. Locate gas pressure regulator in bottom compartment. Gas pressure regulator
B. Flip the regulator pin over and snap pin firmly into place. It is important that will not cause the flame...
Installation Instructions - Page 11
... and snap pin firmly into place. 2. Unscrew the hex-shaped regulator cap from inside the broiler cavity. 2. Burner orifice hood
NOTE: On units using Eaton Oven Safety Valve, screw the burner orifice hood away from the pins. Screw the hex-shaped regulator cap securely back into place. Regulator cap
3. B A
A. Do not...
Dimension Guide - Page 1
...is designed to change on Demand (775) 833-3600
This Data Sheet Includes Information On
Maytag
•
Product Model Number (s):
•
24" Single Gas Wall Oven with Broiler: CWG3100AAB and CWG3100AAE
24"
22"
24"
•
Dimensions (Actual Size)
•
Minimum cabinet width: 24"
Cutout width: 22"
Cutout height: 38"
Minimum cutout location from floor : 14"
Minimum cabinet depth...
Dimension Guide - Page 2
...be level and straight and capable of oven console. Regulator supplied with built-in an accessible location. - This system is shipped from oven opening .
• CWG3100AAB : Black. • CWG3100AAE : ... 2
This Data Sheet Includes Information On Maytag
•
Product Model Number (s):
•
24" Single Gas Wall Oven with 1/2" NPT female inlet on regulator. Data Sheets are no...
Warranty Information - Page 1
...model number information for factory specified parts and repair labor to correct defects in materials or workmanship. Repairs to parts or systems resulting from unauthorized modifications made to repair or replace...including scratches, dents, chips or other than normal, single-family household use your complete model number ready. This major appliance is designed to Maytag within 30 days...
Use & Care Guide - Page 1
...1-800-688-9900. Always read and obey all safety messages.
GAS BUILT-IN OVEN USER INSTRUCTIONS
THANK YOU for additional information. If you ...messages will need assistance, call us at www.maytag.com for purchasing this manual and on your model and serial number located on some models 6 OVEN CARE 6 General Cleaning 6 Oven Light 6 TROUBLESHOOTING 7 ACCESSORIES 7 WARRANTY 8
OVEN...
Use & Care Guide - Page 2
... also trap heat, causing a fire hazard.
■ WARNING: NEVER obstruct the flow of California to children in
cabinets above an oven -
Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier.
SAVE THESE INSTRUCTIONS
2 Do not store or use any phone in your building. • Immediately call the fire department...
Use & Care Guide - Page 3
SAVE THESE INSTRUCTIONS
FEATURE GUIDE
This manual covers several models. Refer to begin the countdown. WARNING
Food Poisoning Hazard Do not let food sit in food poisoning or sickness. Press and hold the Oven Control Lockout keypad for 5 seconds.
1. A tone will sound, and "Loc" or "Controls Locked" will come on during the Self...
Use & Care Guide - Page 4
... automatically. The display will appear on the display.
To exit mode, press CANCEL. Do not attempt to give incorrect readings. This oven is heavily soiled. IMPORTANT: The health of some models), repeating each minute after pressing a keypad, that are audible signals, indicating the following: Basic Functions One tone ■ Valid pad press...
Use & Care Guide - Page 5
...temperature will appear on the racks as shown.
4
3 2 1
A. It is pressed, the oven will glow red when cycling on grid in the recipe.
Control panel B.
The lower the temperature, ...are level. C
Baking and Roasting
The bake element or burner will begin preheating.
Oven door
Oven Vent
The oven vent releases hot air and moisture from front to the stop position, raise the ...
Use & Care Guide - Page 7
... the display? Turn on the bottom? Contact a trained repair specialist or see cover for contact information.
Oven will operate
WARNING
Oven burner flames are yellow or noisy
■ Is propane gas being used ? Oven temperature too high or too low ■ Does the oven temperature calibration need adjustment? Display shows messages ■ Is "BAKE" or "LOCK" flashing in...
Use & Care Guide - Page 8
....
9. Cosmetic damage, including scratches, dents, chips or other than normal, single-family household use or when it is used in a manner that have access to the Internet and you need further assistance, you do not have been removed, altered or cannot be repaired in the home and only in-home service is covered...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Proposition 65 Warnings
...the warning when a listed chemical is present. Product Recall Information Display shows an error code - Error messages - To comply with this warning is available on the list of chemicals identified by...Whirlpool has provided the warning because a chemical covered by the State of California. Oven Therefore, Whirlpool has elected to comply with California State law. The warning ... -
Display shows HC - Top-load washer with Dispensers in Corners
This error code indicates that the cold and hot water inlet hoses are turned on. Make sure to completely...water faucets are switched. Top-load washer with Dispensers in Corners washer display shows HC. If the error remains on . If an error code does not appear, but you are experiencing poor wash performance, check to indicate that the cold and hot water ... -
FAQs Knowledgebase search tips
... and understand your question, then you are not sure how a word is not heating," "oven shows an error code e-0." Always be sure to be included in the result set. Some of the answers will ... such as Owner's Manuals, Repair Manuals and Installation Manuals, can be sure to select different methods of searching, including by model number. With this, it easier to get the most of the words...
Similar Questions
Double Oven Cwe5800ace Error Code F7
Oven kept beeping and displayed error code F7 - please help.
Oven kept beeping and displayed error code F7 - please help.
(Posted by theresagleeson 3 years ago)
How Do You Clean The Sensor Probe On A Cwg3100aae Gas Wall Oven?
We are able to start the oven and it runs for a short period of time then we get a fault code. I'm s...
We are able to start the oven and it runs for a short period of time then we get a fault code. I'm s...
(Posted by imakinuw8 10 years ago)
Fault Code Reads F3
oven had a fault code of f5 then fault code of f3
oven had a fault code of f5 then fault code of f3
(Posted by salluz64 10 years ago)
My Maytag Oven Will Not Get Hot
My oven will not get hot and the thermostat does not work. When i go to start it, it just stays at 7...
My oven will not get hot and the thermostat does not work. When i go to start it, it just stays at 7...
(Posted by sandiesheesley 12 years ago)
Wall Oven Three Years Old. Not Working. No Support From Maytag
Oven has not worked for over two months. Tried contacting Maytag and offered no help. Local Maytag s...
Oven has not worked for over two months. Tried contacting Maytag and offered no help. Local Maytag s...
(Posted by jbrule 12 years ago)