LiftMaster LM21XPBB Support Question
LiftMaster LM21XPBB Support Question
Find answers below for this question about LiftMaster LM21XPBB.Need a LiftMaster LM21XPBB manual? We have 1 online manual for this item!
Question posted by danielraymond38 on May 29th, 2021
Battery Was 9 Years Old, I Replaced But Continued To Beep. What Could That Be?
replaced 9 year old battery but continues to beep
Current Answers
Answer #1: Posted by Odin on May 29th, 2021 9:52 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,680
Member since:
April 10th, 2010 Points: 41,236,680
Could be a faulty battery. Check the chart at https://www.manualslib.com/manual/442913/Chamberlain-Liftmaster-Lm21xpbb.html?page=13#manual for the LED color.
If the issue persists or if you require further advice, you may want to consult the company: use the contact information at https://www.contacthelp.com/liftmaster/customer-service.
If the issue persists or if you require further advice, you may want to consult the company: use the contact information at https://www.contacthelp.com/liftmaster/customer-service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Answer #2: Posted by SonuKumar on May 29th, 2021 10:16 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,621,290
Member since:
May 9th, 2021 Points: 16,621,290
https://www.youtube.com/results?search_query=liftmaster+lm21xpbb+beeping
https://www.youtube.com/watch?v=PtKuFXe8P5g
https://www.youtube.com/watch?v=5hqLPWfX1sc
https://www.youtube.com/watch?v=CNrtIeqy2Vs
https://www.youtube.com/watch?v=GVYFb5YwuGU
https://www.youtube.com/watch?v=oNKLB5AYQno
https://www.devancocanada.com/files/manuals/LM21XPBB:Installation-manual.pdf
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related LiftMaster LM21XPBB Manual Pages
LM21XPBB Manual - Page 1
The Chamberlain Group, Inc. 845 Larch Avenue Elmhurst, Illinois 60126-1196 www.liftmaster.com
OWNER'S MANUAL
MODELS
LM21XPBB LM21XPBBVB
EXTENDED PERFORMANCE RELEASE DEVICE
APPROVED
LM21XPBB Manual - Page 2
...for up to four smoke detectors and two horn strobes, as well as provide battery backup for use on the following pages, it will alert you to the fire... see these Safety Symbols and Signal Words on rolling doors, single-slide and center-parting level and inclined track doors. INTRODUCTION
GENERAL DESCRIPTION
The LiftMaster® LM21XPBB and LM21XPBBVB Release Device is UL/ULC listed normally ...
LM21XPBB Manual - Page 3
... and fire standards, guidelines, regulations and codes including, but not limited to the door manufacturer's recommendations for use this device without fusible links installed.
• Test every...ALARM CURRENT BATTERY RATING:
BATTERY STANDBY TIME:
120Vac, 60Hz; 24Vac, 60Hz; 24Vdc
.06A, .3A, .2A
.06A, .3A, .25A
12V 4.5AH Sealed Lead Acid Battery, Maximum charge current .150Amps
LM21XPBB, 72 ...
LM21XPBB Manual - Page 4
... end link completely in accordance with fasteners (#10 is the minimum size recommended). End Link
MOUNT THE RELEASE DEVICE
Installation procedures vary according to your door.
1. If installing in masonry, use this device without fusible links installed.
4. CIÓN ADVERTENCIA 4.
NING ON
I N S TA L L AT I O N
WARNING
IMPORTANT INSTALLATION INSTRUCTIONS
WARNING
To reduce...
LM21XPBB Manual - Page 5
...
protected. Power Strip
Ground
L2 L1
AVERTISSEMENT
ENCIA ADVERTENCIA ATTENTION 5. A pulsing sounder occurs when the battery is disconnected or when replacement is under power, the door will drop. WARNING
ON
WIRING INSTRUCTIONS
Verify wiring configuration with specific door and
To prevent DAMAGE to power capacity requirements and circuit length and wiring methods. When powering...
LM21XPBB Manual - Page 7
... 4. Speaker
BK
BK
12 V, 4.5 AHr Battery
2 Amp maximum current
RD
GR
L3 L2 L1...Door Proximity Switch (2) (optional)
Input Power
120 Vac .5 Amp
+ 24V ac/dc
OR
Hot Neutral
- 0.75 Amp
Ground
EOL 10 kOhm Resistor (LMEOLRES10) 2-Wire Detector Initiation Loop (1) (3)
Place 10 kOhm resistor between 3 & 4 if unused
+ In + Out - WIRING DIAGRAM
WIRING
Solenoid
Replace batteries every 2 years...
LM21XPBB Manual - Page 8
... • DO NOT install this device on a motorized door without an
electric safety edge.
Observe proper polarity, 3 ...device, such as an approved UL1481 regulated power supply providing battery backup support.
(-)
Power from Control Panel
NOTE: Generic version...
10k Ohm @1/2 watt Supervisory Resistor (LMEOLRES-10)
Normally Open "2-Wire," Class B Style A Initiating Devices
Connect wiring from...
LM21XPBB Manual - Page 9
... by the fire alarm control panel. Connect wiring from its N/O condition (switch closed when door is in this manner. If these features are desired, coordinate the interconnection between positions 9... specifications and the Authority Having Jurisdiction
ADVERTENCIA 15 Trouble Common
Connect wiring from the door, the release device will be released.
This is available to the unit, the...
LM21XPBB Manual - Page 10
... SWITCH SELECTION
The release device will close ; ON
1
2
3
4
Factory default setting of either message. Message 2: Warning tone followed by the verbal warning message).
This fire door will provide a factory default delay of the delay chosen on the length of 10 seconds (to minimize nuisance alarms) before applying power to decrease volume...
LM21XPBB Manual - Page 11
...release device and disconnect battery. All tests may not apply.
Reset the door per door manufacturer's instructions. Depress and continue to hold test button on the device and release the Mechanical Reset Plunger in it's normal position (open position. Reset the door per door manufacturer's instructions. Fully insert the end link through door opening while testing. • Test...
LM21XPBB Manual - Page 12
... (See Wiring Diagram). There should be replaced. Red (LED 4)
If lit, indicates an open ) within the N/O 2-wire (or 4-wire) smoke detector loop (emanating from terminal board positions 3 and 4), resulting from the unit. If in alarm. No Check power connections per manufacturers' instructions. ATTENTION 3.
If so, the battery is not functioning properly and a trouble...
LM21XPBB Manual - Page 13
... required for proper operation and protection of door. • Disconnect ALL electrical and battery power BEFORE
performing maintenance. The fuse is kept in dry, indoor locations.
BATTERY DISPOSAL
Spent batteries must be treated as shown on the wiring diagram. This indicates the need to Accessory and Replacement
PAartsVpaEgeR.
Power
Red
If the Red LED is...
LM21XPBB Manual - Page 14
ACCESSORIES AND REPLACEMENT PARTS
ITEM PART # 1 LM8100 2 LM8100T 3 LM8100I 4 LM2WB 5 LM2WTB
6 LM4WB 7 LM4WTB
8 LM1424 9 LM1412...Relay - 12/24Vdc End-of-Line Relay - 120Vac
REPLACEMENT PARTS
ITEM PART # 1 LMRK 2 LMELH 3 LM2AG3AMP 4 LMEOLRES10 5 LM4AH12
DESCRIPTION Reset Knob End Link Fuse - 3Amp End-of-Line Resistor, 10 kOhm Battery
NOTE: Certain accessories above will require a separate power ...
Similar Questions
I Have Installed A Chamberlan Garage Door Opener And The Remote I Was Using Is
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
(Posted by donweera42 8 months ago)
I Need A Replacement Lens Cover For Garage Door Opener Liftmaster Model #1355- 1
I need a replacement Lens Cover for a garage door opener Model # 1355M- 1/2 HP Liftmaste
I need a replacement Lens Cover for a garage door opener Model # 1355M- 1/2 HP Liftmaste
(Posted by nskanson 1 year ago)
Garage Door Opens After Shutting.
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
(Posted by BONNIECA92 2 years ago)
Noise From Garage Door Opener
I have a liftmaster garage door opener. It makes a loud screeching noise when the door is lowered....
I have a liftmaster garage door opener. It makes a loud screeching noise when the door is lowered....
(Posted by tom19097 11 years ago)
Replacing Backup Battery In Garage Door Opener.
How do I replace the backup battery in the LiftMaster 3850 garage door opener? Are there instruction...
How do I replace the backup battery in the LiftMaster 3850 garage door opener? Are there instruction...
(Posted by melindanannin 12 years ago)