LiftMaster 3800 Support Question
LiftMaster 3800 Support Question
Find answers below for this question about LiftMaster 3800.Need a LiftMaster 3800 manual? We have 1 online manual for this item!
Question posted by gbobko92 on July 26th, 2012
Can You Use A Std Door Bell Switch For A Seconddary Door Opener Switch
SECOND SEPERATE DOOR BUTTON FOR A LIFTMASTER 3800
Current Answers
Related LiftMaster 3800 Manual Pages
3800 Manual - Page 1
®
GARAGE DOOR OPENER Model 3800
For Residential Sectional Doors With Torsion Assemblies Only
Com Details
The Chamberlain Group, Inc. 845 Larch Avenue Elmhurst, Illinois 60126-1196 www.liftmaster.com
patible with
See Page 13 for
Owner's Manual
■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after installation...
3800 Manual - Page 2
... safety instructions 21 Using your garage door opener 21 Using the wall-mounted control console 22 Care of serious injury or death if you do not comply
with the cautionary statements that accompany them carefully.
2 Read the warnings carefully. The
WARNING hazard may come from something mechanical or from motor unit memory 26 3-Button remote 26...
3800 Manual - Page 4
... place, supported entirely by its springs.
2.
Sectional Door
Tools needed
During assembly, installation and adjustment of the door. If your garage door is balanced and is not sticking or binding:
1. CAUTION
To prevent damage to garage door and opener: • ALWAYS disable locks BEFORE installing and operating the
opener. • ONLY operate garage door opener at 120V, 60 Hz to avoid...
3800 Manual - Page 5
...Door Control Console
Remote Control Visor Clip
SECURITY✚® 3-Button Remote Control (1)
Remote Light with Hardware Bag
2-Conductor Bell Wire White & White/Red
Power Door Lock 2-Conductor White & White/Black Bell...Access Door)
5
Note that accessories will depend on the model
purchased. Carton Inventory
Your garage door opener is missing, carefully check the packing material.
3800 Manual - Page 6
...torsion bar).
• Tighten both sides of the motor unit as the collar, using self-threading screws provided. The door may not reverse
correctly or limits may be properly tightened. NOTE: Do not ...Collar to the Motor Unit
To avoid installation difficulties, do not run the garage door opener until instructed to do so.
• Loosen the collar screws.
• Attach collar to either the ...
3800 Manual - Page 7
... garage door.
11. Check to help assure proper alignment of installation, test safety reversal system. It may not reverse when required and could be used if mounting bracket into masonry. • NEVER try to prevent antenna from being entangled in SEVERE INJURY or DEATH.
3. of SEVERE INJURY or DEATH:
1.
INSTALLATION STEP 1
Position the Opener...
3800 Manual - Page 9
... service calls. It is supplied as a device to the wall using the wall anchors (2) and the #8 hex head screws (2) provided in cable on opposite side of the cable.
5. NOTE: There must be connected and properly installed before the garage door opener will reverse the door when excessive slack is shipped for anchors).
4. Attach the cable...
3800 Manual - Page 10
.../red wire to the R (1) (Figure 2).
2. Use insulated staples to secure wire in place.
3. (For standard installations ONLY) Run bell wire up wall and across ceiling to motor unit. The door will travel .
• ALWAYS keep garage door in sight until the sensor beams are desired to operate the same garage door opener, it may damage the LCD screen...
3800 Manual - Page 12
...sure power is not connected to the opener, and disconnect power to circuit BEFORE removing cover to establish permanent wiring connection.
• Garage door installation and wiring MUST be in ...compliance with ALL local electrical and building codes.
• NEVER use an extension cord, 2-wire adapter...
3800 Manual - Page 17
... where you may toggle the door back and forth using the black and purple buttons. Door MUST reverse on contact with proper operation of the door by a closing the door. Figure 2
Push and hold the purple button until the door reaches the desired UP (open) position (Figure 2). Black moves the door UP (open ) limit and begins closing garage door. • NEVER learn forces...
3800 Manual - Page 19
... adjustment of limits, or force controls. • Any repair to or adjustment of the garage door
(including springs and hardware). • Any repair to or buckling of the door. • Press the remote control push button to close the door. If the opener closes the door when the safety reversing sensor is obstructed, do not operate the...
3800 Manual - Page 21
...MUST be programmed before use. Using Your Garage Door Opener
Your LiftMaster Security✚® opener and hand-held remote control have been factory programmed to disengage door ONLY when garage door is activated (with the... the light button and the incandescent light bulbs will not close from a hand-held Remote Control: Hold the large push button down until the door starts to ...
3800 Manual - Page 22
..., resetting the timer to Learn Remote.'
A single blink indicates that you disable the motion sensor when using the opener lights as follows: Press and hold the Light button on automatically when a person enters the garage. See Automatic Light Feature, below. However, the door will come on the LCD display.
(LANG) Language Feature
Press this side...
3800 Manual - Page 23
...car.
• Check to be frozen to a metal door, foil backed insulation, or metal garage siding.
23 Opener operates from the remote, but not from either the Control ...button.
• Program the opener to match the remote control code. (Refer to 5 years. The lithium battery should produce power for up (+)
NOTICE: To comply with FCC Standards FOR HOME OR OFFICE USE. To replace battery, use...
3800 Manual - Page 24
... hums briefly, then won 't close the door manually. The door can be locked. The door doesn't open the power door lock.
• Use the emergency release handle to operate door:
• The door may be out of the opener, door may be opened and closed manually. The door opens but won 't work:
• The garage door springs may be broken. For an existing installation, see...
3800 Manual - Page 25
... not operate or trolley is programmed with jumper wire. Try to wall and does not move.
Symptom: Door reverses while closing. • Check for the sensors. Installed Safety Reversing
Sensor
Your garage door opener is stuck on door control. • Inspect door control/wires for a short (staple in wire), replace as needed . • Disconnect wires at...
3800 Manual - Page 26
... the hand-held remote* that you wish to use.
*3-Button Remote
If provided with your garage door opener, the large button is operated with a non-rolling code transmitter, the technical measure in the garage door opener does not authorize the purchaser or supplier of the garage door opener, which provides security against code-theft devices, will be programmed to operate other Security...
3800 Manual - Page 27
...garage door opener. To activate or deactivate this temporary PIN will be heard. LOCK
LIGHT
2. Release the button when the motor unit lights blink. The opener light will blink three times. If light bulbs are not installed, two clicks will open the door....
2. Release the # button.
4. It can be used to a certain number of openings, remember that the test has used up to 0 in step...
3800 Manual - Page 28
... has already been programmed at the factory to be programmed.
1. Activate the garage door using the hand-held remote, wall control or keyless entry.
3. Reprogramming Light or Additional Light
Your garage door opener remote work lights will need to operate with your opener. Press the "learn button" on .
28 It has learned the code and the light turns...
3800 Manual - Page 32
...BE LIABLE FOR CONSEQUENTIAL, INCIDENTAL OR SPECIAL DAMAGES ARISING IN CONNECTION WITH USE, OR INABILITY TO USE, THIS PRODUCT. NO PERSON IS AUTHORIZED TO ASSUME FOR US ANY ...Country Club Road
Tucson, Arizona 85706
SERVICE INFORMATION TOLL FREE NUMBER:
1-800-528-9131
LIFTMASTER® GARAGE DOOR OPENER FIVE-YEAR LIMITED WARRANTY LIFETIME MOTOR LIMITED WARRANTY
The Chamberlain Group, Inc. ("Seller")...
Similar Questions
I Have Installed A Chamberlan Garage Door Opener And The Remote I Was Using Is
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
(Posted by donweera42 8 months ago)
Garage Door Opens After Shutting.
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
(Posted by BONNIECA92 2 years ago)
How To Install Cable Wire For Garage Door Opener Model 3800
(Posted by laedmhrink 10 years ago)
Will A Door Bell Switch Work For A Garage Door Push Button
(Posted by fedppoli 10 years ago)
