LiftMaster 3595 Support Question
LiftMaster 3595 Support Question
Find answers below for this question about LiftMaster 3595.Need a LiftMaster 3595 manual? We have 1 online manual for this item!
Question posted by tommyreynolds1 on February 19th, 2013
Liftmaster 3850 Elite SeriesDate 06/07Part # 41ac075-2a
Wont open with remote. Remote opens 2 other doors no problem but wont open 3rd
Current Answers
Related LiftMaster 3595 Manual Pages
3595 Elite Series Manual - Page 1
.... 845 Larch Avenue Elmhurst, Illinois 60126-1196 www.liftmaster.com
®
GARAGE DOOR OPENER Model 3595 3/4 HP
For Residential Use Install on the left side panel of the opener are required to ensure safe operation. ■ The model number label is located under the light lens on Sectional Doors ONLY THIS OPERATOR IS INTENDED FOR USE ONLY...
3595 Elite Series Manual - Page 2
... pages, they will alert you to the possibility of damage to your garage door opener 26
Having a problem 26-27
Smart Control Panel™ messages 28
Programming
29-30
To add or reprogram a hand-held remote control .....29
To erase all codes 29
3-Button remotes 29
To add, reprogram or change a Keyless Entry PIN 30
Repair...
3595 Elite Series Manual - Page 3
..., it should stay in place, supported entirely by its springs. 2. To prevent damage to garage door and opener:
• ALWAYS disable locks BEFORE installing and operating the opener.
• ONLY operate garage door opener at 120V, 60 Hz to avoid entanglement. Preparing your garage door
Before you begin: • Disable locks. • Remove any binding or sticking. An unbalanced...
3595 Elite Series Manual - Page 4
Planning
Identify the type and height of your opener.
Header Wall
FINISHED CEILING
Support bracket & fastening hardware is closed.
Slack in chain tension is normal when garage door is required.
Torsion Spring
Extension Spring OR
Motor Unit
--- --- -- You may find it helpful to refer back to this page and the accompanying illustrations as ...
3595 Elite Series Manual - Page 5
... (2) Lock Nut 1/4"-20 Lag Screw 1/4x1-1/2" (4) Rope Handle
5
Straight Door Arm Section Parts may be stuck in two cartons which If anything is missing, carefully check the packing material. Hardware for installation
Accessories will depend on the model purchased.
is also listed below .
Carton Inventory
Your garage door opener is packaged in the foam.
3595 Elite Series Manual - Page 6
... the Rail to the Motor Unit
To avoid installation difficulties, do not run the garage door opener until instructed to do so.
• Remove the bolt and lock nut from moving garage door opener: • ALWAYS keep hand clear of sprocket while operating opener. • Securely attach chain spreader BEFORE operating. Any other bolts/fasteners will cause...
3595 Elite Series Manual - Page 7
....
5. NEVER wear watches, rings or loose clothing while installing or servicing opener. Install wall-mounted garage door control:
• within sight of the garage door.
• out of reach of the door.
10. Install garage door opener 7 feet (2.13 m) or more above floor.
7. Door MUST reverse on contact with the door closed. If the chain returns to secure the adjustment. NOTE...
3595 Elite Series Manual - Page 8
Open your door to the highest point of travel clearance for the top edge of the door. INSTALLATION STEP 1
Determine the Header Bracket Location
To prevent possible SERIOUS INJURY or DEATH: • Header bracket MUST be used if mounting header bracket or 2x4 into masonry. • NEVER try to loosen, move or adjust garage door, springs...
3595 Elite Series Manual - Page 9
... for positioning only. Optional Wall Mounting Holes
Header Wall
2x4 Structural Support
Header Bracket
CEILING MOUNT ONLY UP
Vertical Centerline of Garage Door
Lag Screws 5/16"-9x1-5/8"
Door Spring
Horizontal Line
Highest Point of Garage Door Travel
Garage Door
Vertical Centerline of Garage Door
9 Finished Ceiling - The bracket can attach the header bracket either to the wall above the...
3595 Elite Series Manual - Page 10
... Bracket
Ring Fastener
Clevis Pin 5/16"x2-3/4"
Chain Pulley Bracket
Rail
Garage Door
Temporary Support
INSTALLATION STEP 4
Position the Opener
SECTIONAL DOOR ONLY
A 2x4 laid flat is convenient for setting an ideal door-to garage door, rest garage door opener rail on 2x4 placed on top section of door.
The trolley can remain disconnected until Installation Step 12 is used to...
3595 Elite Series Manual - Page 11
... in the structural supports.
4. Check to the hanging brackets with the header bracket if the bracket is not centered above the door).
7. Operate the door manually. Concrete anchors MUST be different. Hanging brackets should be angled (Figure 1) to the structural support.
2. Measure the distance from a falling garage door opener, fasten it SECURELY to required lengths.
3.
3595 Elite Series Manual - Page 12
...clearly, is properly adjusted and there are desired to operate the same garage door opener, it is not connected BEFORE installing door
control. • Connect ONLY to use the anchors provided. HARDWARE SHOWN... at the lower/middle portion of the cover with door control push buttons or remote control transmitters. • Activate door ONLY when it can be mounted to avoid cracking plastic ...
3595 Elite Series Manual - Page 13
... procedure to close the lens.
• Use A19, standard neck garage door opener bulbs for approximately 4-1/2 minutes when power is necessary to cut the rope, heat seal the cut end with a match or lighter to disengage trolley ONLY when garage door is in the fully open door falling rapidly and/or unexpectedly.
• NEVER use halogen bulbs...
3595 Elite Series Manual - Page 14
...compliance with a third grounding pin. RIGHT
WRONG
If permanent wiring is required by your garage door opener has a grounding type plug with all local electrical and building codes.
• NEVER...• Connect the black (line) wire to establish permanent wiring connection.
• Garage door installation and wiring MUST be grounded.
• Reinstall the cover. To prevent possible ...
3595 Elite Series Manual - Page 15
... and reverse to the receiving eye (with a green indicator light). Either can be installed on the wall, the brackets must be securely fastened to the garage door opener BEFORE installing the safety reversing sensor.
Extension brackets (see accessories) are designed to avoid drilling extra holes in masonry if repositioning is closing, the...
3595 Elite Series Manual - Page 16
....
• Carefully measure and place right and left assemblies to the opener is recommended.
Floor installation:
• Use wood blocks or extension brackets to elevate sensor brackets so the lenses will be used.
• Use bracket mounting holes as follows:
Garage door track installation (preferred):
• Slip the curved arms over the rounded...
3595 Elite Series Manual - Page 18
...WILL REQUIRE reinforcement BEFORE installation of Garage Door
UP
Figure 4
18 Center the door bracket on your garage door manufacturer for an opener installation door reinforcement kit. Note correct UP placement, as the horizontal brace. Secure the door bracket using the two 1/4"-14x5/8" self-threading screws. (Figure 2A)
• Alternately, use on the following page. For the vertical...
3595 Elite Series Manual - Page 32
... Line cord End panels w/all labels
41A2826 41A2825
NOT SHOWN Motor shaft bearing kit Opener assembly hardware kit (includes screws not designated by a number in illustration)
32 kit ...41A5633-13 Cover
15 41A5532 Gear case
16 41A2822-1 Interrupter cup assembly
17 41C4398A RPM sensor assembly
18 41AC075-2 Receiver logic board assy. NO.
Motor Unit Assembly Parts
1
5
8
7
19 18
2
3
...
3595 Elite Series Manual - Page 33
...fastening strip.
Single-Button Security✚® Remote Control: Includes visor clip.
Garage Door Monitor: Security for the largest door of garage door opener from their car with their home with NO access door.
ACCESSORIES
1702LM
Outside Quick Release:
Required for a garage with an additional LiftMaster Security✚® remote. Combine up to three controls into one...
3595 Elite Series Manual - Page 36
...LIFTMASTER/CHAMBERLAIN dealer. THIS LIMITED WARRANTY DOES NOT COVER ANY PROBLEMS WITH, OR RELATING TO, THE GARAGE DOOR OR GARAGE DOOR HARDWARE, INCLUDING BUT NOT LIMITED TO THE DOOR SPRINGS, DOOR ROLLERS, DOOR... Club Road
Tucson, Arizona 85706
SERVICE INFORMATION TOLL FREE NUMBER:
1-800-528-9131
LIFTMASTER® FIVE-YEAR LIMITED WARRANTY LIFETIME MOTOR LIMITED WARRANTY
The Chamberlain Group, Inc. ...
Similar Questions
Garage Door Opens After Shutting.
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
(Posted by BONNIECA92 2 years ago)
How To Program New Car To Open Garage Door
where is the learn button to program my car to open garage door
where is the learn button to program my car to open garage door
(Posted by lrothberg 6 years ago)
Garage Door Wont Close
garage door starts to come down but then stops and lights flash
garage door starts to come down but then stops and lights flash
(Posted by djsyencer 6 years ago)
Mh Liftmaster Garage Door Will Not Open Intermittently.
On the occasion when the garage door will not open, there is power to the opener. Both leds on the p...
On the occasion when the garage door will not open, there is power to the opener. Both leds on the p...
(Posted by kellhowarda 11 years ago)
Dog Chewed Through Sensor Wires, Wont Close On Own.
Hi, My puppy decided it would be fun to chew through the sensor wires, as well as break one o...
Hi, My puppy decided it would be fun to chew through the sensor wires, as well as break one o...
(Posted by tjmims 11 years ago)