LiftMaster 3585 Support Question
LiftMaster 3585 Support Question
Find answers below for this question about LiftMaster 3585.Need a LiftMaster 3585 manual? We have 1 online manual for this item!
Question posted by robrielly1 on January 16th, 2020
Remote Operation Seems Weak
When we are in our cars and leaving, we push the remote to close the door. The signal seems weak as it will not close the door unless our car is nearly up against the door and centered. I put fresh batteries in our remotes, but this has no effect. Any suggestions? Thanks, Rob Rielly
Current Answers
Related LiftMaster 3585 Manual Pages
3585 Elite Series Manual - Page 1
®
GARAGE DOOR OPENER Model 3585 3/4 HP
For Residential Use Only
The Chamberlain Group, Inc. 845 Larch Avenue Elmhurst, Illinois 60126-1196
www.liftmaster.com
Owner's Manual
■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after installation. ■ The door WILL NOT CLOSE unless the Protector System® is ...
3585 Elite Series Manual - Page 2
...Signal Word Review
This garage door opener has been designed and tested to offer safe service provided it . Mechanical Electrical
When you see this Signal Word on the following pages, it will alert you to your opener...
Operation
26-31
Operation safety instructions 26
Using your garage door opener 26
Using the wall-mounted door control 27
Using the remote control 28
To open the door...
3585 Elite Series Manual - Page 3
... you begin: • Disable locks. • Remove any binding or sticking. To prevent damage to garage door and opener:
• ALWAYS disable locks BEFORE installing and operating the opener.
• ONLY operate garage door opener at 120V, 60 Hz to avoid entanglement. Carpenter's Level (optional)
12
Tape Measure
Pencil Wire Cutters
Drill
3/16", 5/16" and
5/32" Drill Bits
Pliers...
3585 Elite Series Manual - Page 5
... on the model purchased. LOCK
LIGHT
SmLCarDt CMoontitoronl DPeatneecltTMing Door Control Console
SECURITY✚® 3-Button Remote Control Model 373P (1)
Remote Control TVrisaonrsmCliitpter Visor Clip
Belt
Belt Cap Retainer Styrofoam
2-Conductor... check the packing material.
Carton Inventory
Your garage door opener is packaged in the foam. If anything is also listed below .
3585 Elite Series Manual - Page 7
... moving garage door opener: • ALWAYS keep hand clear of 5 feet
3. Attach with 8x3/8" hex screws provided.
installing or servicing opener. Place entrapment warning label on contact with the two holes in SEVERE
INJURY or DEATH.
• within sight of the garage door. • out of reach of children at minimum height of sprocket while operating opener. •...
3585 Elite Series Manual - Page 12
... the garage. Operate the door manually. Remove the 2x4. NOTE: DO NOT connect power to structural supports before installing the opener.
Measure the distance from a falling garage door opener, fasten it SECURELY to the structural support.
2. To avoid possible SERIOUS INJURY from each bracket to a support with the header bracket if the bracket is centered over the door (or...
3585 Elite Series Manual - Page 13
...door. • NEVER permit children to operate or play with door control push buttons or remote control transmitters. • Activate door ONLY when it can be connected to secure. To release or insert wire, push... white/red wire to operate the same garage door opener, it may damage the LCD screen. To prevent possible SERIOUS INJURY or DEATH from end of door control by inserting top ...
3585 Elite Series Manual - Page 14
... and/or unexpectedly. • NEVER use emergency release handle unless garage doorway is CLOSED. If rope knot becomes untied, you could result in the fully open or closed. Weak or broken springs or unbalanced door could fall. NOTE: Use only standard light bulbs. To prevent damage to pull door open position. Secure with an overhand knot at least 1" (2.5 cm...
3585 Elite Series Manual - Page 21
... opener at a 45° angle so that the trolley release arm is operated. INSTALLATION STEP 12
Connect Door Arm to Trolley
Follow instructions which apply to your door type as shown.
• Bring arm sections together.
• Find two pairs of holes that line up and join sections.
SECTIONAL DOORS ONLY
Make sure garage door is fully closed...
3585 Elite Series Manual - Page 23
... are flashing, the Safety Reversing Sensors are necessary unless the reversing test fails (Adjustment Step 3, page 25).
Test the door for a trained door systems technician. If the door is adjusted, the other control may cause the motor to Adjustment Step 2. To operate the opener, press the door control push bar. NOTE: To prevent the trolley from hitting the...
3585 Elite Series Manual - Page 24
.... Test the UP (open) force
• Grasp the door bottom when the door is about 3/4 of power required to open ) force by a closing garage door.
• Too much force on garage door will reverse. The maximum force adjustment range is about halfway through a complete travel cycle.
• If the door doesn't open at least 5 feet (1.5 m), INCREASE UP (open and close ) force by turning...
3585 Elite Series Manual - Page 25
... push button to close from a remote if the indicator light in either sensor is off (alerting you to or adjustment of the garage floor. • Any repair to the fact that the sensor is misaligned or obstructed).
ADJUST • If the door stops on the floor, centered under the garage door. • Operate the door in the down direction.
The garage door opener...
3585 Elite Series Manual - Page 26
... reversal system MUST be programmed before use handle to pull garage door open , the door will operate with garage door control push buttons or remote controls.
3. ALL repairs to cables, spring assemblies and other control may be tested.
11. Your opener will not close . when the opener is CLOSED. WARNING
OPERATION
IMPORTANT SAFETY INSTRUCTIONS WARNING
To reduce the risk of...
3585 Elite Series Manual - Page 27
...works by detecting body heat. Otherwise, they will open or close from LOCK hand-held remote controls. Lock feature
Designed to prevent operation of the remote control to be changed to 1-1/2, 2-1/2, or ...remote controls to the unit. Using the Wall-Mounted Door Control
THE SMART CONTROL PANELTM
Press the push bar to open and close the door.
The Lock feature will show 'Learn Remote...
3585 Elite Series Manual - Page 29
... prevents the trolley from a falling garage door: • If possible, use handle to pull door open door falling rapidly and/or unexpectedly. • NEVER use emergency release handle unless garage doorway is clear of operation.
FORCE CONTROLS
9
1
7
3
5
KG
9
1
7
3
5
KG
Pages 23 and 24 refer to the opener, press the door control push bar. Follow the instructions carefully...
3585 Elite Series Manual - Page 30
... before the garage door opener will not activate the door:
• Verify your door, check diagnostic LED for balance or any obstructions. Refer to Programming.
• If remote will not turn off when door is open:
• The garage door opener is blinking, deactivate the Lock Mode following the instructions for flashes on the motor unit then refer to Operation section; Bell...
3585 Elite Series Manual - Page 31
...garage door opener is programmed with jumper wire. Consult Diagnostic Chart below.
1 FLASH
Safety reversing sensors wire open (broken or disconnected).
If motor unit activates,
replace door control. • If motor unit does not activate, disconnect door...needed . • Disconnect wires at door control, touch wires together. the motor unit does not operate or trolley is not lit on stop...
3585 Elite Series Manual - Page 33
... clicks will open and close when you wish to confirm Learn Mode.
3. To Add or Reprogram a Hand-held remote that you wish to use.
*3-Button Remotes
If provided with your garage door opener, the large button is operated with a non-rolling code transmitter, the technical measure in the garage door opener does not authorize the purchaser or supplier of the garage door opener, which...
3585 Elite Series Manual - Page 34
...close is deactivated.
34 Release the button when the motor unit lights blink. Press the four buttons for the present PIN, then press
and hold the ENTER button.
2. After a programmed number of hours or number of accesses, this temporary PIN will work , press the number of your garage door opener.... Press the PROG button again to operate your choice on the Smart Control PanelTM...
3585 Elite Series Manual - Page 37
... sensor for homes with multiple garage doors.
902LM/903LM
2 & 3 Door Multi-Function Wall Control:
Ideal for visitors or service persons. Also can be limited to a programmable number of your garage door is designed to 4 garage doors
CLOSED
by entering a password on a lamp, television or other appliance from their car with their garage door opener remote or from lightning and power...
Similar Questions
I Have Installed A Chamberlan Garage Door Opener And The Remote I Was Using Is
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
(Posted by donweera42 7 months ago)
How To Program New Car To Open Garage Door
where is the learn button to program my car to open garage door
where is the learn button to program my car to open garage door
(Posted by lrothberg 6 years ago)
How To Replace Battery On Garage Door Back Up Battery
(Posted by bawvilif 9 years ago)
How Do I Change The Batteries In The Keyless Entry Pad For The Garage Door?
how do i change the batteries in the keyless entry pad for the garage door?
how do i change the batteries in the keyless entry pad for the garage door?
(Posted by lisaager 10 years ago)
Programming My Car To Garage Door Opener
I am unable to program garage door to 2012 Acura, is my system to old.
I am unable to program garage door to 2012 Acura, is my system to old.
(Posted by Vherd84 11 years ago)