LiftMaster 3585 Support Question
LiftMaster 3585 Support Question
Find answers below for this question about LiftMaster 3585.Need a LiftMaster 3585 manual? We have 1 online manual for this item!
Question posted by snenno on February 17th, 2014
How To Reprogram Liftmaster Opener?
can i reprogram my liftmaster opener? (not a remot control. a main unit)
Current Answers
Related LiftMaster 3585 Manual Pages
3585 Elite Series Manual - Page 1
®
GARAGE DOOR OPENER Model 3585 3/4 HP
For Residential Use Only
The Chamberlain Group, Inc. 845 Larch Avenue Elmhurst, Illinois 60126-1196
www.liftmaster.com
Owner's Manual
■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after installation. ■ The door WILL NOT CLOSE unless the Protector System®...
3585 Elite Series Manual - Page 2
...
26-31
Operation safety instructions 26
Using your garage door opener 26
Using the wall-mounted door control 27
Using the remote control 28
To open the door manually 29
Care of your opener 29
Having a problem 30
Diagnostic chart 31
Smart Control PanelTM messages 32
Programming
33-34
To add or reprogram a hand-held remote control . . . . .33
To erase all codes from electric...
3585 Elite Series Manual - Page 3
... under EXTREME tension.
• Disable ALL locks and remove ALL ropes connected to garage door BEFORE installing and operating garage door opener to avoid entanglement. To prevent damage to garage door and opener:
• ALWAYS disable locks BEFORE installing and operating the opener.
• ONLY operate garage door opener at 120V, 60 Hz to see if there is not sticking or binding: 1.
3585 Elite Series Manual - Page 4
Torsion Spring
Extension
Spring OR
Motor Unit
--- --- --
See page 19 for lightweight garage doors (fiberglass, steel, aluminum, door with the installation of your installation.
See page 12. See page 12. You may be required. Motor Unit
Header Wall
Wallmounted Door Control
Access Door
ONE-PIECE DOOR WITH TRACK
Safety Reversing Sensor
Gap between floor and bottom of
Safety...
3585 Elite Series Manual - Page 5
...DPeatneecltTMing Door Control Console
SECURITY✚® 3-Button Remote Control Model 373P (1)
Remote Control TVrisaonrsmCliitpter Visor Clip
Belt
Belt Cap Retainer Styrofoam
2-Conductor Bell Wire White & White/Red
Motor Unit ... will depend on the model purchased. Carton Inventory
Your garage door opener is packaged in the foam. Parts may be stuck in two cartons which contain the motor...
3585 Elite Series Manual - Page 6
Liftmaster Synchro Drive
• Cut tape from the top of the motor unit.
• Place rail onto the bolt mounted on the motor unit and align the back ...securely. The Chamberlain Group, Inc.
ASSEMBLY STEP 1
Attach the Rail to the Motor Unit
To avoid installation difficulties, do not run the garage door opener until instructed to do so.
• Remove the bolt and lock nut from rSapirlin,...
3585 Elite Series Manual - Page 7
... door or opener mechanisms.
lubricated garage door. Place manual release/safety reverse test label in mounting plate. HARDWARE SHOWN ACTUAL SIZE
To avoid possible SERIOUS INJURY to garage door control.
11. READ AND FOLLOW ALL INSTALLATION WARNINGS AND
8. ALL repairs to the installation section. Hex Screws 8x3/8"
Belt Cap Retainer
Motor Unit Sprocket
Mounting Plate
Hex Screw #8x3...
3585 Elite Series Manual - Page 8
...used if mounting header bracket or 2x4 into masonry. • NEVER try to garage door types. Open your door.
1. NOTE: If the total number of inches exceeds the height available in the way...the maximum height possible, or refer to structural
support on header wall or ceiling, otherwise garage door might not reverse when required. This height will provide travel as shown here and on the...
3585 Elite Series Manual - Page 10
... Pulley Bracket
INSTALLATION STEP 3
Attach the Rail to the Header Bracket
• Position the opener on a temporary support to allow the rail to secure. NOTE: If the door spring is in the way you'll need help.
Garage Door
Header Bracket
Ring Fastener
Clevis Pin 5/16"x2-3/4"
Belt Pulley Bracket
Rail
Temporary Support
HARDWARE...
3585 Elite Series Manual - Page 11
... panel hits the trolley when you raise
the door, pull down on the trolley release arm to garage door, rest garage door opener rail on 2x4 placed on the top section of the door beneath the rail.
• The top of the door should be level with the top of door.
You will need help at this point if...
3585 Elite Series Manual - Page 12
... the distance from a falling garage door opener, fasten it SECURELY to structural supports of the rail surface where the trolley slides with 5/16"-18x7/8" hex bolts, lock washers and nuts.
6. Cut both pieces of the motor unit to a support with the header bracket if the bracket is centered over the door (or in the structural...
3585 Elite Series Manual - Page 13
...-connect terminals on screw head and slide down to use the anchors provided.
Fasten with door control push buttons or remote control transmitters. • Activate door ONLY when it is recommended to secure. INSTALLATION STEP 6
Install the Door Control
Locate door control within sight of garage door, out of reach
of children at a minimum height of 5 feet (1.5 m), and away from all...
3585 Elite Series Manual - Page 14
... hinge is necessary to cut the rope, heat seal the cut end with a match or lighter to close the lens.
• Use A19, standard neck garage door opener bulbs for approximately 4-1/2 minutes when power is clear of the red handle so "NOTICE" reads right side up as shown. Weak or broken springs or...
3585 Elite Series Manual - Page 15
...unit:
• Remove the motor unit cover screws and set the cover aside.
• Remove the attached 3-prong cord.
• Connect the black (line) wire to the screw on the silver terminal;
The opener.... To avoid installation difficulties, do not run the opener at this time.
Be sure the opener is required by your garage door opener has a grounding type plug with all local electrical...
3585 Elite Series Manual - Page 16
... eye lens.
Be sure power is necessary to mount the units on the left or right of sectional garage doors without additional hardware. If it is not connected to the receiving eye (with an amber indicator light) transmits an invisible light beam to the garage door opener BEFORE installing the safety reversing sensor. If installing in...
3585 Elite Series Manual - Page 30
... move away from the remote control or door control. The need for occasional adjustment for Using the Wall Mounted Door Control.
• Reprogram remotes following page. My lights will not close and the light bulbs blink on when the safety sensor beam has been obstructed. My door will not turn off when door is open:
• The garage door opener is normal. The trolley...
3585 Elite Series Manual - Page 33
... owner of the copyright in the receiver of the non-rolling code transmitter to circumvent that technical measure. Your garage door opener has already been programmed at the factory to operate with your garage door.
3. To Add or Reprogram a Hand-held remote control. PROGRAMMING
NOTICE: If this Security✚® garage door opener is factory programmed to confirm Learn Mode.
3.
3585 Elite Series Manual - Page 34
... steadily for your garage door opener. USING THE "LEARN" BUTTON
USING THE SMART CONTROL PANELTM
1. LOCK
...unit lights blink. The door should move . When the motor unit lights blink, it has expired. Release the button.
3.
The learn " button on the Smart Control PanelTM.
2. Press the PROG button on motor unit...Opener can be used up to 255), then press ✽.
To Add, Reprogram...
3585 Elite Series Manual - Page 37
... with an additional LiftMaster Security✚® remote. Also can be limited to three controls into one wall control panel for homes with up to 4 garage doors
CLOSED
by entering a password on or off from the door control.
975LM
Laser Park Assist:
Laser enables homeowners to precisely park vehicles in their garage door opener remote or from anywhere in the garage.
990LM
Surge...
3585 Elite Series Manual - Page 40
...THIS PRODUCT), LABOR CHARGES FOR REINSTALLING A REPAIRED OR REPLACED UNIT, REPLACEMENT OF BATTERIES AND LIGHT BULBS OR UNITS INSTALLED FOR NON-RESIDENTIAL USE. UNDER NO CIRCUMSTANCES SHALL ... Road
Tucson, Arizona 85706
SERVICE INFORMATION TOLL FREE NUMBER:
1-800-528-9131
LIFTMASTER® GARAGE DOOR OPENER FIVE-YEAR LIMITED WARRANTY
LIFETIME MOTOR AND BELT LIMITED WARRANTY
The Chamberlain Group, ...
Similar Questions
Garage Door Opens After Shutting.
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
(Posted by BONNIECA92 2 years ago)
How To Program New Car To Open Garage Door
where is the learn button to program my car to open garage door
where is the learn button to program my car to open garage door
(Posted by lrothberg 6 years ago)
How Do I Change The Batteries In The Keyless Entry Pad For The Garage Door?
how do i change the batteries in the keyless entry pad for the garage door?
how do i change the batteries in the keyless entry pad for the garage door?
(Posted by lisaager 10 years ago)
Programming My Car To Garage Door Opener
I am unable to program garage door to 2012 Acura, is my system to old.
I am unable to program garage door to 2012 Acura, is my system to old.
(Posted by Vherd84 11 years ago)
Mh Liftmaster Garage Door Will Not Open Intermittently.
On the occasion when the garage door will not open, there is power to the opener. Both leds on the p...
On the occasion when the garage door will not open, there is power to the opener. Both leds on the p...
(Posted by kellhowarda 11 years ago)