LiftMaster 3280 Support Question
LiftMaster 3280 Support Question
Find answers below for this question about LiftMaster 3280.Need a LiftMaster 3280 manual? We have 1 online manual for this item!
Question posted by carlo112000 on June 10th, 2011
Non-functioning Liftmaster 3280m
My garage door opener has become totally non-functional - won't open/close when using either the wall mounted controller or the remote unit. On the wall controller, the light behing the open/close switch cover is no longer illuminated and none of the funtions work. Another garage door opener on the same electrical circuit is functioning perfectly. Both units were professionally installed about 4 months ago. Is there a built in fuse or circuit breaker that I can reset? Any other recommendations?
Current Answers
Related LiftMaster 3280 Manual Pages
3280 Manual - Page 1
®
GARAGE DOOR OPENER Model 3280 1/2HP
3280-267 1/2HP
For Residential Use Only
The Chamberlain Group, Inc. 845 Larch Avenue Elmhurst, Illinois 60126-1196
www.liftmaster.com
Owner's Manual
■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after installation. ■ The door WILL NOT CLOSE unless the Protector System&#...
3280 Manual - Page 2
...-34
Rail assembly parts 33
Installation parts 33
Motor unit assembly parts 34
Accessories
35
Repair Parts and Service
36
Warranty
36
INTRODUCTION
Safety Symbol and Signal Word Review
This garage door opener has been designed and tested to your garage door opener 26
Using the wall-mounted door control 27
To open the door manually 27
Care of damage to offer safe service...
3280 Manual - Page 3
... SERIOUS INJURY OR DEATH: • ALWAYS call a trained door systems technician if
garage door binds, sticks, or is out of the opener, instructions will call a trained door systems technician. To prevent damage to garage door and opener: • ALWAYS disable locks BEFORE installing and operating
the opener. • ONLY operate garage door opener at 120V, 60 Hz to avoid entanglement.
3280 Manual - Page 5
... is packaged in the foam. LOCK
LIGHT
Multi-Function Door Control Panel
SECURITY✚® 3-Button Remote Control
Models 3280 (1)
3280-267 (2)
Remote Control Transmitter Visor Clip
Styrofoam
Belt Cap Retainer
Belt
Motor Unit with 2 Light Lenses
SECURITY✚® Keyless Entry Model 3280-267 ONLY
One-Piece Rail
CEILING MOUNT ONLY UP
Door Bracket
Belt Pulley Bracket
Trolley...
3280 Manual - Page 7
....
12. They could result in plain view on contact with the two holes in garage door or opener mechanisms.
9. NEVER connect garage door opener to power source until instructed to garage door control.
11. Install wall-mounted garage door control:
• within sight of the garage door.
• out of reach of children at minimum height of 5 feet (1.5 m).
• away from moving parts...
3280 Manual - Page 8
...
structural support on the header wall above the high point:
• 2" (5 cm) above the high point for sectional door and one -piece door without track: pivot hardware Close the door and mark the inside vertical centerline of Garage Door
2x4
Structural
Supports
Level (optional)
Installation procedures vary according to garage door types. Open your garage, use lag screws (not provided...
3280 Manual - Page 13
..., loosen the two mounting screws or relocate the door control to a smoother surface.
3. (Standard installation only) Run bell wire up wall and across ceiling to the opener, twist same color wires together.
INSTALLATION STEP 6
Install the Door Control
Locate door control within sight of garage door, out of
reach of children at slot in the top of the cover with care to...
3280 Manual - Page 15
... motor unit cover screws and set the cover aside.
• Remove the attached 3-prong cord.
• Connect the black (line) wire to make a permanent connection through the 7/8" hole in ANY way to the screw on the silver terminal; RIGHT
WRONG
If permanent wiring is grounded. Be sure the opener is required by your garage door opener has...
3280 Manual - Page 17
... and left assemblies at each other across the garage door, with lag screws (Not provided).
• If using extension brackets or wood blocks, adjust right and left assemblies to Wall with Lag Screws (Not Provided)
Indicator
Light
Sensor
Bracket
Lag Screws (Not Provided)
Lens
Figure 3
IGWnasairldal ege
WALL MOUNT (RIGHT SIDE)
Extension Bracket (See Accessories)
(Provided with...
3280 Manual - Page 19
... your door's construction:
Metal or light weight doors using a vertical angle iron brace between the door panel support and the door bracket:
• Drill 3/16" fastening holes. INSTALLATION STEP 11
Fasten the Door Bracket
Follow instructions which apply to your garage door manufacturer for an opener installation door reinforcement kit.
A horizontal reinforcement brace should cover the...
3280 Manual - Page 22
... Hole
Emergency Release Handle
Closed Door
Inner Trolley
Outer Trolley
Correct Angle
Door Arm
Open Door
Door with a ring fastener.
• Run the opener through a complete travel to the connector hole in back of the door arm connector hole. Press the Door Control push button. ALL ONE-PIECE DOORS
1. Connect the door arm to the trolley:
• Close the door and join the curved...
3280 Manual - Page 23
... cm) between the trolley and the bolt.
• If door does not open at least 5 feet (1.5 m):
Adjust the UP (open) force as explained in fully closed ? Run the opener through a complete travel . NOTE: To prevent the trolley from hitting the cover protection bolt, keep a minimum distance of garage door travel limits will stop when moving up travel , it...
3280 Manual - Page 25
... be tested every month. • If one control (force or travel cycles to test adjustment. • If the unit continues to fail the Safety Reverse Test, call for a trained door systems technician.
The door will not move more than an inch (2.5 cm), and the opener lights will not close the door. The garage door opener will flash. Without a properly installed safety...
3280 Manual - Page 26
...Keyless Entry System. SAVE THESE INSTRUCTIONS. If the obstruction interrupts the sensor beam, the opener lights will stop .
7. With a Multi-Function Door Control, this feature, start with each use . ALWAYS KEEP GARAGE DOOR PROPERLY BALANCED (see page 3). ALL repairs to move. • The wall-mounted Door Control: Hold the push
button or bar down travel is activated (with up to move...
3280 Manual - Page 27
... as follows: Press and hold a small remote button that the timer is activated. Using the Wall-Mounted Door Control
THE MULTI-FUNCTION DOOR CONTROL
Press the push button to open door falling rapidly and/or unexpectedly.
• NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.
• NEVER use emergency release handle to disengage trolley ONLY...
3280 Manual - Page 29
My door will not close and the light bulbs blink on my motor unit: The safety reversing sensor must be connected and aligned correctly before the garage door opener will still not activate your door control is normal. Refer to Programming. • If remote will move in length.
• If the trolley does not move away from the opener by pulling the...
3280 Manual - Page 31
... motor unit lights blink. It has learned the code. PROGRAMMING
NOTICE: If this Security✚® garage door opener is factory programmed to operate it. The owner of the copyright in the receiver of the non-rolling code transmitter to circumvent that you wish to operate your hand-held Remote Control
USING THE "LEARN" BUTTON
USING THE MULTI-FUNCTION DOOR CONTROL
9
1
7
3
5
KG...
3280 Manual - Page 32
... last temporary PIN), then press and hold the # button.
The motor unit lights will be heard. Test by visitors or service people with a temporary 4-digit PIN. One Button Close: Opener can be used up to 255), then press #. USING THE "LEARN" BUTTON
USING THE MULTI-FUNCTION DOOR CONTROL
LOCK
LIGHT
1.
This feature has been activated at the factory. To Add, Reprogram...
3280 Manual - Page 35
... additional LiftMaster Security✚® remote.
378LM
Wireless Door Control:
Push bar, light feature and auxiliary button. Tells you if your home! Enables homeowner to open or closed. Enhanced functions include Lock Feature to three controls into one wall control panel for homes with up to lock out outside by adding additional sensor modules.
916LM
Garage Door Monitor Sensor...
3280 Manual - Page 36
... DOES NOT COVER NONDEFECT DAMAGE, DAMAGE CAUSED BY IMPROPER INSTALLATION, OPERATION OR CARE (INCLUDING, BUT NOT LIMITED TO ABUSE, MISUSE, FAILURE TO PROVIDE REASONABLE AND NECESSARY MAINTENANCE, UNAUTHORIZED REPAIRS OR ANY ALTERATIONS TO THIS PRODUCT), LABOR CHARGES FOR REINSTALLING A REPAIRED OR REPLACED UNIT, REPLACEMENT OF BATTERIES AND LIGHT BULBS OR UNITS INSTALLED FOR NON-RESIDENTIAL USE...
Similar Questions
How Do I Raise The Height Of My 3280 Door?
How do I raise the height of my 3280 door?
How do I raise the height of my 3280 door?
(Posted by sodbuster130 4 years ago)
Changing Code On The Liftmaster Garage Door Opener
Someone in our area has the same code . We need to change the code on the liftmaster and them recode...
Someone in our area has the same code . We need to change the code on the liftmaster and them recode...
(Posted by reptak 9 years ago)
How To Unplug Motor Unit To Install N For Garage Door Opener Elite Series Model
3850
3850
(Posted by Gaydaves 10 years ago)
Liftmaster 3280 Door Closing Problem
my liftmaster 3280 door won't close unless i keep pushing the button on the wall unit. Whati is wron...
my liftmaster 3280 door won't close unless i keep pushing the button on the wall unit. Whati is wron...
(Posted by marktaleff 11 years ago)