KitchenAid KFXS25RYMS Support Question
KitchenAid KFXS25RYMS Support Question
Find answers below for this question about KitchenAid KFXS25RYMS.Need a KitchenAid KFXS25RYMS manual? We have 3 online manuals for this item!
Question posted by bethwolf2010 on October 12th, 2015
Kitchenaid Model# Kfis29pbms00 Freezer Evap Fan Motor Not Working, Need Access
I have a KitchenAid Model# KFIS29PCMS00 and the freezer evaporator fan motor is not working, I need to know how to remove the drawers to access the motor. I have removed the drawer front and do not see any screws that may be holding the drawers in place.
Current Answers
Answer #1: Posted by TechSupport101 on October 12th, 2015 10:27 PM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
Hi. See the replacement videos here www.youtube.com/watch?v=QaaVeMAm5QI and here www.youtube.com/watch?v=sQRSSambJWU
Related KitchenAid KFXS25RYMS Manual Pages
Use & Care Guide - Page 1
....kitchenaid.ca or call us at 1-800-422-1230. You will need assistance, call us at 1-800-807-6777. W10336224A Table of Contents / Índice / Table des matières
REFRIGERATOR SAFETY...all safety messages.
WARNING
You can be killed or seriously injured if you still need your model and serial number, located on your appliance. This symbol alerts you don't immediately ...
Use & Care Guide - Page 2
... these basic precautions:
■ Plug into many small, pebble-size pieces. Remove the Packaging
■ Remove tape and glue residue from surfaces before turning on some models). ■ Do not hit the refrigerator glass doors (on the refrigerator. These products can damage the surface of your refrigerator before installing ice maker (on ice maker
kit ready...
Use & Care Guide - Page 4
...models with water pressure of copper tubing are cut square.
5. Copper tubing D. Shutoff valve G. Place the free end of the refrigerator to the water pipe.
Cold water pipe B. Pipe clamp C. Tighten the packing nut. TOOLS NEEDED...System." IMPORTANT: If you need. This will work, but the following procedure...used in the valve.
4. Screw compression nut onto outlet end ...
Use & Care Guide - Page 5
... tubing into the plastic water valve supply line. Copper tubing B. Compression sleeve
3.
Turn on the copper tubing. 5.
Style 1 1. Remove plastic cap from moving. Attach the
copper tube to refrigerator and check for your model, the water line may come down from the top or up from water supply connection. Do not use an...
Use & Care Guide - Page 6
...
6 To replace the handles, reverse the directions. Remove Doors and Hinges
IMPORTANT:
Remove and Replace Refrigerator Drawer and Freezer Drawer
IMPORTANT: Two people may be required to the drawer front. Loosen the two top screws attaching the drawer glide brackets to remove and replace the freezer drawer. NOTE: Loosen screws three to
refrigerator and freezer.
†®TORX is a registered...
Use & Care Guide - Page 8
... clockwise.
■ To lower, turn the leveling screw counterclockwise. Adjust the Doors
IMPORTANT:
■ Your refrigerator has two adjustable, front leveling screws - Using a ¹⁄₄" hex driver, turn the screws.
Using the Controls
The refrigerator and freezer controls are still set points are touching the floor.
1. Remove the base grille. This makes it is out of...
Use & Care Guide - Page 9
...exactly the same time
When cooling is off the lights and dispensers. CONDITION:
TEMPERATURE ADJUSTMENT:
REFRIGERATOR too cold
REFRIGERATOR Setting 1° higher
REFRIGERATOR too warm
REFRIGERATOR Setting 1° lower
FREEZER too cold
FREEZER Setting 1° higher
FREEZER too warm / Too little ice
FREEZER Setting 1° lower
The set points to lower the set point.
■ When you...
Use & Care Guide - Page 10
...know if the power supply to the refrigerator...your model, ... readily accessible. Power...confirm that need to turn...drawer's location allows children to its normal status.
Removing and Replacing Ice Storage Bin
To Remove...drawer. When power has been restored, "PO" repeatedly flashes on the ice maker. Door Ajar Alarm The Door Ajar Alarm feature sounds an alarm when the refrigerator or freezer...
Use & Care Guide - Page 11
...freezer to be dispensed, according to manually turn off or by the ounce, cup, or liter.
Remove the glass to a water source or replacing
the water filter, flush the water system. Water and Ice Dispensers
IMPORTANT: ■ After connecting the refrigerator...specified amount of water with the touch of ice. You may need to adjust the volume to produce the first batch of a ...
Use & Care Guide - Page 12
...with the faucet rotated, do not need to apply a lot of the... does not shut off power to the refrigerator, to the ice maker, or to ... your dispenser lights are not working, see "Ice Maker and Storage...Remove the glass to cubed, a few seconds after removing the glass from crushed to stop , then gently lift up on some models)
On some models... no drain in the freezer when the dispenser lever is...
Use & Care Guide - Page 13
...installed in the refrigerator, the water filter status lights help you know when to change... filter, model number UKF8001AXX-750 or UKF8001AXX-200, contact your stainless steel refrigerator looking like new
and to remove minor scuffs...refrigerator and freezer sections defrost automatically. Clean the Touch Screen Display on disinfected waters that may scratch or damage the materials. Remove...
Use & Care Guide - Page 14
... fuse or reset the circuit breaker. Make sure the refrigerator controls are LEDs that cannot be changed.
■ Some models may run too much
Do not remove ground prong.
The motor seems to its high-efficiency compressor and fans. Your new refrigerator may run longer than your refrigerator. Plug into place. Replace the base grille when finished...
Use & Care Guide - Page 15
... from your old model. See "Water Supply Requirements."
■ Questions remain regarding water pressure? fans/compressor adjusting to begin. flow of refrigerant, movement of the refrigerator ■ Sizzling/...moisture buildup is on. Minimize door openings and keep doors fully closed completely? Remove filter and operate ice maker. This can decrease water pressure.
Failure to fill...
Use & Care Guide - Page 16
...Refrigerator connected to cool completely.
■ Water not been recently dispensed? See "Refrigerator Doors and Drawer."
■ Reverse osmosis water filtration system connected to a cold water pipe?
Remove ... needs additional flushing. Hold the glass under the dispenser 2 to 3 seconds after dispensing is connected to be clogged or incorrectly installed. A water filter may need ...
Use & Care Guide - Page 17
... Standards 42 and 53 for the reduction of the substances listed below. Use replacement filter model UKF8001AXX-750. 2010 suggested retail price of Lead, Mercury, Atrazine, Benzene, p-Dichlorobenzene, ...of unknown quality without filter status lights, replace the filter every 6 months.
For models without adequate disinfection before or after the system. and against NSF/ANSI Standard 42...
Use & Care Guide - Page 18
... out for the product to replace the filter.
Interior Water Filtration System
Model UKF8001AXX-200 Capacity 200 Gallons (757 Liters)
System tested and certified by...Toxaphene, Cysts, Turbidity, Asbestos, O-Dichlorobenzene, Ethylbenzene, Chlorobenzene, Endrin, Tetrachloroethylene and Lindane. For models without notice. and against NSF/ANSI Standard 42 for cold water use only.
■ Do...
Use & Care Guide - Page 19
... states and provinces do not allow limitations on major appliances with original model/serial numbers that existed when this major appliance was purchased: compressor, evaporator, condenser, dryer, and connecting tubing. Expenses for travel and transportation for replacement or repair of the refrigerator/freezer cavity liner (including labor costs) if the part cracks due to...
Use & Care Guide - Page 20
... the refrigerator compartment. For additional product information, in the U.S.A., call 1-800-807-6777.
If you need assistance using your correspondence.
Please keep these User Instructions and the model number information for future reference.
20 For assistance or service in the U.S.A., visit www.kitchenaid.com In Canada, visit www.kitchenaid.ca
If you do not have access...
Dimension Guide - Page 1
... the control (Thermostat, Refrigerator or Freezer Control depending on the model) to change materials and specifications without notice. handle
E incl.
IMPORTANT: The pressure of the water coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be a minimum of Cabinet
"B"
Depth Doors Open
90° "C"
Depth Drawer Open
"D"
Depth...
Energy Guide - Page 1
...Refrigerator-Freezer ·Automatic Defrost ·Bottom Mounted Freezer ·With Through-the-Door-Ice Service
Kitchen Aid Corporation Model(s):KFXS25RY***,KFXL25RY***
Capacity: 25.0 Cubic Feet
Estimated Yearly Operating Cost
$51
Cost Range of Similar Models
The estimated yearly operating cost of this model...to other similar models. Government
Federal law prohibits removal of Canada's high...
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Water supply hookup - Side by side refrigerator
... may reduce the water pressure when used in "Steps to connect a refrigerator to the refrigerator. Bottom freezer/French door refrigerators << Go Back to see whether the sediment filter in some models; Tools needed: 7/16" and 1/2" open-end or two adjustable wrenches Parts needed IMPORTANT: All installations must be required in the reverse-osmosis... -
Replacing the light bulb - Bottom freezer/French door refrigerator
... damage the light cover. NOTE: Not all appliance bulbs will fit your refrigerator. doing so may need to remove the upper freezer shelf or basket to release it locks into the liner and snap the back portion of the cover into place. Firmly press forward on each side of the cover and pull down the... -
Determining correct beater to bowl clearance
... of the bowl on stand mixers. Bowl-Lift Stand Mixers Beater hitting side of your model number. Place a dime in the bottom of the bowl. IMPORTANT: The flat beater should be... does not touch the dime, the clearance is an adjustment screw that can be adjusted, there is too high. If the Beater to Bowl Clearance needs to bowl clearance on a Bowl Llift Stand Mixer. Download ...
Similar Questions
Error Code Po, Refrig Randomly Shuts Off
I have a 3 yr old KA French door model #kfs25ryms4 that shows "PO", not cooling enough to freeze ice...
I have a 3 yr old KA French door model #kfs25ryms4 that shows "PO", not cooling enough to freeze ice...
(Posted by fontanagreg 3 years ago)
Need A Control Board Model Number Kddo27trx02 Kitchen Aid Architect Series I
(Posted by Newcowoodworks 8 years ago)
Ksc24c8eyy01
Odin, Thanks for responding. I have cleaned condenser coils andThe temp in the freezer is +02 and th...
Odin, Thanks for responding. I have cleaned condenser coils andThe temp in the freezer is +02 and th...
(Posted by 59ronbarski 9 years ago)
I Have A Kitchenaid Side By Side Refrigerator. The Ice Make Has Stopped Working
Model number KFIL27CXMS, S/N K01421386. I have cleared the ice tray and ensured it's correctly in pl...
Model number KFIL27CXMS, S/N K01421386. I have cleared the ice tray and ensured it's correctly in pl...
(Posted by blanegobama 10 years ago)
Kitchenair Freezer Bulb Does Not Work
My Kitchenaid-Model KFIS20xvms freezer light does not work..I tried two bulbs.
My Kitchenaid-Model KFIS20xvms freezer light does not work..I tried two bulbs.
(Posted by Anonymous-41443 12 years ago)