KitchenAid KFIS20XVMS Support Question
KitchenAid KFIS20XVMS Support Question
Find answers below for this question about KitchenAid KFIS20XVMS.Need a KitchenAid KFIS20XVMS manual? We have 3 online manuals for this item!
Question posted by rkaczmarek on March 11th, 2017
Kitchenaid Refrigerator Model #kfis20xvms5 Has Stopped Cooling.
Replaced circuit breaker and the control panel reads PEO 000. My question is how do you program the code into the panel? I appreciate your guidance.
Current Answers
Answer #1: Posted by BusterDoogen on March 11th, 2017 2:32 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,447
Member since:
October 30th, 2011 Points: 28,565,447
Temperature is too warm
New installation? Allow 24 hours following installation for the refrigerator to cool completely.
Door(s) opened often or left open? Allows warm air to enter refrigerator. Minimize door openings and keep doors fully closed.
Large load of food added? Allow several hours for refrigerator to return to normal temperature.
Controls set correctly for the surrounding conditions?
Adjust the controls a setting colder. Check temperature in 24 hours.
Go here for other possible causes of a warm refrigerator.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related KitchenAid KFIS20XVMS Manual Pages
Use & Care Guide - Page 1
...can happen if the instructions are very important. Always read and obey all safety messages.
Table of Contents / Índice / Table des matières
REFRIGERATOR SAFETY 1 SEGURIDAD DEL REFRIGERADOR 20 SÉCURIT&#.... If you still need your model and serial number, located on your appliance. In Canada, visit our website at www.kitchenaid.ca or call us at 1-800-807-6777.
Use & Care Guide - Page 2
... an extension cord. ■ Disconnect power before servicing. ■ Replace all parts and panels before installing ice maker (on ice maker
kit ready models only). ■ Use a sturdy glass when dispensing ice (on some models). ■ Do not hit the refrigerator glass doors (on the refrigerator.
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire...
Use & Care Guide - Page 3
... circuit serving only your refrigerator next to a fixed wall, leave a 2³⁄₄" (7.0 cm) minimum space between the refrigerator and wall to allow for ¹⁄₂" (1.25 cm) of space on each side and at the back for 1" (2.54 cm) of installation, cleaning, or removing a light bulb, turn Cooling ON. See "Using the Controls...
Use & Care Guide - Page 4
...Replace the filter if necessary.
■ Allow the storage tank on the refrigerator before you need. Connect the Water Supply
Read all directions before the water line is connected, turn off the ice maker to avoid excessive noise or damage to the cold water pipe with a reverse osmosis system. Unplug refrigerator...in the cold water pipe you have questions about your water pressure, call a...
Use & Care Guide - Page 5
... closed until you .
†®TORX is a registered trademark of the copper tubing into a grounded 3 prong outlet. Failure to refrigerator cabinet with the copper tubing.
Remove and Replace Handles
1. Remove Doors and Hinges
IMPORTANT: ■ Remove food and any leaks. NOTE: Provide additional support for leaks. TOOLS NEEDED hex head socket wrench...
Use & Care Guide - Page 6
... refrigerator door while the hinges are being moved. Final Steps
WARNING
Electrical Shock Hazard Plug into the connector.
6. Do not remove ground prong. Return all screws.
4. NOTE: On some models,...the drawer front into the slots in the bottom of the left side refrigerator door. See Drawer Front Replacement graphic. 2. Pull the drawer brackets toward you are included later in Top...
Use & Care Guide - Page 7
... 4 Door Bracket Screws
7 Top Hinge Cover C. 5/16" Hex-Head Hinge Screws D. Bottom Hinge C. Water Line Connection
Drawer Front Removal
A
A. 3/32" or 1/8" Setscrew
Drawer Front Replacement
A
A. Shim (on some models) B. Top Hinges
A B C
D
A. Hinge Cover Screw B. Hinge Screws
Connections
A
B
Door Removal & Replacement
Metal Handle
1
A
A. 3/32" or 1/8" Setscrew
Metal Handle
2
A.
Use & Care Guide - Page 8
... pads
8 Adjust the Doors
IMPORTANT:
■ Your refrigerator has two adjustable, front leveling screws - A. NOTE: Adjusting the refrigerator and freezer temperature controls to adjust the tilt of the way. ■ When both screws the same amount.
4. A
2. Raise or lower the cabinet. Using the Controls
IMPORTANT:
■ The control panel is located on the front of the...
Use & Care Guide - Page 9
... some models) The humidity control feature turns on a heater to "Options."
2. The refrigerator uses more than one setting at the factory.
Vacation Mode The vacation mode feature decreases the number of the compartment. Once set, vacation mode will sound until "Max Cool is turned off . In each of the following screens, continue to press...
Use & Care Guide - Page 10
...refrigerator and freezer compartments. User Settings
The control center allows you to adjust the level at which the Light Sensor will automatically reset once the warm condition has been corrected for best storage of the control panel...switch is felt. The ice maker sensors will automatically stop ice production, but the control will sound repeatedly and the highest temperature reached in ...
Use & Care Guide - Page 11
...Off: To turn
the light on the control panel. NOTE: The dispenser lock does not shut off power to the product, to the ice maker, or to cool down and chill water. Auger driver
Ice...to do not need to be locked for the refrigerator to the dispenser light. Wait 24 hours between adjustments. Avoid connecting the ice maker to stop dispensing water to flow. Remove the container to ...
Use & Care Guide - Page 12
...control panel will not be used on plastic parts, interior and door liners or gaskets. Remove sealing label from replacement filter and insert the
filter end into contact with the blue bypass cap. Snap the filter cover
closed. 4. If this option is for stainless steel parts only! Both the refrigerator... you when it stops. Wipe up spills immediately. Unplug refrigerator or disconnect power....
Use & Care Guide - Page 13
... high-efficiency compressor and fans. The refrigerator seems noisy
Electrical Shock Hazard
Plug into place.
2. Failure to fill the ice maker
■ Pulsating - Replace
the fuse or reset the circuit breaker. See "Using the Control(s)." ■ New installation? Due to this reduction, you did not notice from your old model. heard when the water valve opens...
Use & Care Guide - Page 14
..."Using the Control(s)." Adjust the controls a setting warmer.
Connect refrigerator to store... plumber. Wash ice bin.
Failure to cool completely.
■ Door(s) opened often...refrigerator to do so can reduce water flow. Turn the water shutoff
valve fully open ? See "Water Supply Requirements."
■ Questions... for refrigerator to return to your cold water supply? Replace water ...
Use & Care Guide - Page 15
... glass of water? See "Water Supply Requirements." Remove filter and operate dispenser. Replace filter or reinstall it does not close completely, see "The doors will not operate properly
■ Refrigerator connected to cool completely.
■ Recently dispensed large amount of water.
■ Refrigerator connected to 50°F (10°C). ■ New installation? Make sure...
Use & Care Guide - Page 16
... life is used on , and it is recommended that you to replace the filter. For models without notice.
Temp. = 68°F ± 5°F (20°C ±...005 mg/L
Average Influent
Influent Challenge Concentration
2.00 mg/L
2.0 mg/L ± 10%
14,000,000 #/mL At least 10,000
particles/mL
Average Influent
Influent Challenge Concentration
0.150 mg/L† 0.150 mg/L†
0.15 ...
Use & Care Guide - Page 18
... to or furnished with the product, KitchenAid will pay for replacement or repair of the refrigerator/freezer cavity liner (including labor costs)...KitchenAid designated service company. Damage resulting from defects in the sealed refrigeration system that existed when this major appliance is inconsistent to or furnished with electrical or plumbing codes, or use your authorized KitchenAid...
Use & Care Guide - Page 19
... service in the U.S.A., call 1-800-807-6777.
Have your complete model number ready. In Canada, call 1-800-422-1230. If you need assistance using your product or you would like to KitchenAid with any questions or concerns at the number below :
In the U.S.A.:
KitchenAid Brand Home Appliances Customer eXperience Center 553 Benson Road Benton...
Dimension Guide - Page 1
... circuit serving only your refrigerator be turned off by a switch. NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer Control depending on your refrigerator next to a fixed wall, leave 23⁄4" (7.0 cm) minimum on the hinge side (depending on the model) to swing open. If you have questions...
Energy Guide - Page 1
...Refrigerator-Freezer ·Automatic Defrost ·Bottom Mounted Freezer ·With Through-the-Door-Ice Service
KitchenAid Corporation Model(s):KFIS20XV**
Capacity: 19.8 Cubic Feet
Estimated Yearly Operating Cost
$56
Cost Range of Similar Models
The estimated yearly operating cost of this model.... Use the EnerGuide rating to other similar models. W10202397
The ENERGY STAR® mark on...
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Refrigerator not operating
... the freezer door. Check that the circuit breaker is not tripped or that the fuse is plugged into a grounded 3 prong outlet. Rate answer 1 of 3 Please tell us how we can be a Cooling On/Off button located on the control panel at all? Check that outlet? Given the refrigerator is left open . If the above did... -
When to change the water filter - Side by side refrigerator
... filter cartridge when the water filter status display changes to "Replace" or when water flow to your Water Filters To purchase replacement filters and receive a 10% discount on some models, will change the filter. It is in the refrigerator compartment or on the dispenser control panel on your usage and water quality. KitchenAid also sells... -
Reset the water filter indicator - Side by side refrigerator
... Most models also have a filter indicator reset button located in the refrigerator compartment 5 times within 10 seconds to flow. After changing the filter, reset the filter status light by pressing the Filter Indicator Reset button or by side refrigerator Blinking red light in the refrigerator compartment or on the dispenser control panel on the temperature control panel...
Similar Questions
Kitchenaid Refrigerator Model Number Kfis20xvms5
KitchenAid refrigerator model number KFIS20XVMS5,
KitchenAid refrigerator model number KFIS20XVMS5,
(Posted by cer6922429 6 years ago)
Control Panel Is Inoperative And The Refrigerator Has Ceased Cooling.
The display panel is fully lit and will not respond to the touch. The refrigerator will not cool or ...
The display panel is fully lit and will not respond to the touch. The refrigerator will not cool or ...
(Posted by bikecolorado 7 years ago)
Refrigerator Stopped Cooling After It Was Constantly Turning On And Off
I have a KSSC42QTS and the unit's cooling unit was turning on and off frequently - with a little pin...
I have a KSSC42QTS and the unit's cooling unit was turning on and off frequently - with a little pin...
(Posted by MJKimball 8 years ago)
Model Ksc24c8eyy Stopped Making Ice. Filter Has Seen One Cycle. Water Is Supplie
Water is supplied correctly. Checked temps in both sides and both OK. Ice could be dispensed if ther...
Water is supplied correctly. Checked temps in both sides and both OK. Ice could be dispensed if ther...
(Posted by 59ronbarski 9 years ago)
How To Replace Kitchenaid Refrigerator Model Kfis20xvms6 Water Filter
(Posted by martkokipi 10 years ago)