Home » Kenwood » Car Stereo Amplifiers » Kenwood KAC 9104D

Kenwood KAC 9104D Support Question

Find answers below for this question about Kenwood KAC 9104D - Amplifier.
Need a Kenwood KAC 9104D manual? We have 1 online manual for this item!

Kenwood Overview Questions Manuals Reviews Videos Research

Question posted by mudddigger1981 on September 29th, 2019

Technical Support

not getting no sound out of speaker Jacks with RCA jacks in amp hook you radio

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Odin on September 30th, 2019 6:25 AM

This answer was accepted by the poster of the original question.

Odin

Member since:
April 10th, 2010

Points: 41,236,700

1,100
points

See the first-listed problem at https://www.manualslib.com/manual/86572/Kenwood-Kac-9104d.html?page=5#manual. If the issue persists or if you require further advice, you'll have to consult the manufacturer: use the contact information at https://www.contacthelp.com/kenwood/customer-service.

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Kenwood KAC 9104D Manual Pages

Instruction Manual - Page 1

... the unit, in the space provided below. Refer to read through this instruction manual. KAC-9104D CLASS D MONO POWER AMPLIFIER 7 page 2-5 INSTRUCTION MANUAL AMPLIFICATEUR MONO CLASSE D 7 page 6-9 MODE D'EMPLOI AMPLIFICADOR... serial numbers whenever you obtain the best performance from your new power amplifier. Familiarity with installation and operation procedures will help you call upon your...

Instruction Manual - Page 2

... equipment may generate or use radio frequency energy. When more than the output power (in accordance with the prescribed rating. These limits are going to the amplifier. 4Ω 4Ω 8Ω 4Ω 4Ω 2Ω Combined impedance Cleaning the unit If the front panel gets dirty, turn off and on, the user is not installed...

Instruction Manual - Page 3

...• Install this unit is triggered, the Power indicator goes OFF and the amplifier stops operating. • When a speaker wire may cause injury or an accident. • After installing the unit, ... into contact with driving, In a location that gets wet, In a dusty location, In a place that gets hot, In a place that gets direct sunlight, In a location that gets hit by hot air) • Do not...

Instruction Manual - Page 4

... • The genuine-accessory car stereo shall have a maximum power output of no more than 40 W. • The power is turned on and off before changing the setting of any switch. • If the fuse blows, check wires for this unit to both RCA cable input jacks and the speaker level input terminals simultaneously, for...

Instruction Manual - Page 5

... subwoofer speaker do not become sound but become sound. 4 PHASE switch When this switch to change without notice. Before calling service, first check the following table for possible problems. No sound. (...might appear to be a malfunction in the car body. ☞ Connect the speaker wire again so that cannot be the result of the genuine-accessory car stereo. Refer to . ✔ Volume is ...