Kenmore 4027 Support Question
Kenmore 4027 Support Question
Find answers below for this question about Kenmore 4027 - 4.0 cu. Ft. Front-Load Washer.Need a Kenmore 4027 manual? We have 1 online manual for this item!
Question posted by dalston613 on April 2nd, 2012
Kenmore Washer Not Working Model 110.21202010
Washer not working. comes on, fill light on lid lock light on , moves a few times no fill, then lid light start flashing an takes about 5 mins the open then shuts off. have changed board and lid switch, some say i could have another bad board.
Current Answers
Related Kenmore 4027 Manual Pages
Use and Care Guide - Page 2
... Drain Hose
'10
Connect to the Power Supply t 0
Leveling the Washer
11
lnstaBation of non-skid pads (optiona0
11
HOW TO USE
iiiiiiiii Ci!onitiro!liiP!aineliiF!eiaitiurie:...si!
12
Operating the Washer
13
ijjii!ii!!!!!ii i!i!!ili! Cycle Guide
t4
_rting Wash Loads
15
A_ the Dis_nser
16
iiiiiiiiiiiiiiiDiieiteiirgiiein!tiiiainid!idiisipiein!sie...
Use and Care Guide - Page 3
... taps and unplug the washer if the machine is not designed for maritime use an open flame during vacations.
&#...used for such a _riod, before loading laundry. Close su_rvision of the washer for children. Thissym_l alertsyoutopotentiahl azardsthatcanresultinprope_ damageand/... what can _ dangerous for foreign objects before using this time.
• Do not allow children to the wash water...
Use and Care Guide - Page 4
...the washer where it is properly grounded. Install washer on the power cord. Plug into the washer while parts are moving the washer, be...to follow this warning can produce poisonous gas, resulting in one load unless s_ified on the label.
• _ not mix ...shock, or injury to porsons when using laundry products. Failure to clean t_ washer, They willdamage the finish,
•...
Use and Care Guide - Page 5
... is pro_rly grounded. " Destroy the carton, plastic bag, and other packing materials after the washer is equipped with rugs, bedspreads, or plastic sheets can result in serious personal injuries.
* ...serious personal injuries.
* Keep laundry products out of children or small animals getting trapp_ inside before use of children is necessary when the washer is remov_ from service or ...
Use and Care Guide - Page 6
... and locked in place using the adjusting wrench included with the washer.
FILTER ACCESS PANEL Provides easy access to the drain pump filter, which allows you to -read LED display shows cycle options, settings, cycle status, and estimated time remaining during operation and has a delay feature to prevent the door from being opened until...
Use and Care Guide - Page 7
..., electrical sho_, or death.
• Properly ground washer to conform with current wiring codes and regulations.
• Time-delay fuse or circuit breaker is recommended. rq
(2.5 ...Loading Washer 120 VAC @ 60 Hz. 27" (W) X 293/4" (D) X 3811/1e"(H), 511/8" (D, door open) 68.6 cm (W) X 75.6 cm(D) X 98.3 cm(H), 129.8 cm (D, door open the door.
• To minimize noise and vibration,the washer...
Use and Care Guide - Page 8
...the washer and lay it carefully on its front or back. Starting ...washer. To prevent damage to fully loosen the 4 shipping bolts by turning them counterclockwise.
,p
Bolt Assembly
Hole Cap
2, Remove the bolt assemblies by wiggling them in
Shipping Bolts
Powor
Cord
1. DO NOT lay the washer on its final
position.
•These bolts and retainers MUST be removed before moving the washer...
Use and Care Guide - Page 9
... _nnect the water supply hoses to the water lines and internal mechanisms of the washer. If the washer was expo_d to freezing temperatures priorto installation, allow it to stand at room temperature ...cold water inlet on the back of the washer can result. Attach the blue, cold water line to cross-thread the hose fittings since this laundry product. Inspect the threaded fitting on the water...
Use and Care Guide - Page 10
... drain hoe in place.
Option 1: Standpipe
Elbow Bracket
Option 2: Laundry Tub
Elbow Bracket
The elbow bracket should not exceed 96 in the washer. NOTE:
•Total height of the hose end should be... crushed, or kinked.
Plug in . (244.8 cm) from moving. NOTE: If the drain hose is not long enough. CONNECT TO POWER SUPPLY Washer should be plugged into the floor drain. J
10 Option 3: ...
Use and Care Guide - Page 11
... the final location, taking special care to not pinch, strain, or crush the water and drain lines..Place
from moving during operation.
•All four leveling feet must be out of
ba]an_, excess noise and vibration can result from getting out of laundry in the machine. Pos_ion the washer in firm contact w_h...
Use and Care Guide - Page 12
...
if the washer is too high. TIME AND STATUS DISPLAY The display shows the estimated time remaining, load size, cycle status, and door lock status.
Press again to turn the washer ON. See...selected cycle The lights above the buttons show the current selection.
These settings can adjusted using the cycle setting buttons anytime before operating this button to start the selected cycle...
Use and Care Guide - Page 13
.... OPERATING THE WASHER
O SORT LAUNDRY AND LOAD WASHER Refer to the main wash compartment in the dispenser drawer, Add bleach and fabric softener as desired.
Once the cycle has been started, pressing the START/PAUSE again will sound, if turned on Refer to turn on page 20 (Stain Treat, 2rid Rinse, Control Lock, and Delay Start). Refer to...
Use and Care Guide - Page 15
.... • Combine large and small items in poor wash performance for the lightly soiled clothing. Loading the Washer • Check all pockets to make sure that are empty, Items such...light clothes can resu_ in a load. Avoid mixing the_ lint collectors and lint producers in a _parate load from light colors or whites. Washing heavier fabrics in a delicate load can result in the laundry ...
Use and Care Guide - Page 16
...modeL)
Pre-Wash Detergent Compartment
The dispenser drawer has a compartment that is labeled "Prewash",. Either powdered or liquid detergent may be dispensed immediately causing damage to fabrics, Using too much detergent can result in detergent buildup in clothing and the washer.... The bleach compartment is added to the load at the proper time during the final rinse cycie, Never exceed ...
Use and Care Guide - Page 17
...O Load the laundry products into the appropriate compartments,
Close the lid before starting the cycle.
Careful attention must be paid to the amount of detergent used when measuring the detergent, For most normal loads, ... are formulated specifically for this model
Designed to 3/4 of a cup or scoop of HE detergent should be used on top of your washer clean. While HE detergents are...
Use and Care Guide - Page 18
...length of the load. A blinking light indicates the active portion of time. • Estimated time is estimated, For example, the time displayed may be spun out. The door can pause for each load,
CYCLE STATUS ...TIME REMAINING
When the STARTJPAUSE is too high, the door will lock while the washer is too high, the door cannot be unlocked by pressingthe START/PAUSE to force the door open,...
Use and Care Guide - Page 19
...load... light for the desired value is lit,
• Your washer ...washer.
2o Press the SPIN SPEED button to select the desired spin speed, For drain only, select the NO SPiN option,
3, Press the START...time and saving energy,
Press the SPIN SPEED button until the indicator light for best results and maximum
efficiency. O SPIN SPEED
This extracts more time for heavily soiled clothes or less time...
Use and Care Guide - Page 20
... selected cycle.
O Add detergent only to start of the dispenser drawer. (See "Using the Dispenser" on then press and hold the CONTROL LOCK button for cleaning front load washers.
NOTE: To protect your individual needs,
O Turn on the washer and press the CLEAN WASHER button. O Turn on the washer and turn the washer on pages 16-17,)
O Select...
Use and Care Guide - Page 21
...around the washer door opening, door seal, and dcor glass, These areas should be used for proper use of detergent Do not _d laundry! Be ...Washer MagicR, and run CLEAN WASHERfor 3 con_uWe weeks After CLaN WASHER is comp_te or _en the washeris notused, _ave the washer door open to allow the gasket to dry completely
NOTE:
, Follow the manufacturer's instructions for an extended period of time...
Use and Care Guide - Page 28
...the Ioa&
Pause the cycle and redistribute the load after the door unl_ks. Then,,,
Add 1 or 2 similar items to dear the error code and use the washer.
28
iiiiiiiiiiiiiiiiiiiiiii!iiiii!i iiii!i!ili!ii!iiii... pE I
I The water level sensor is not working correcUy.
Then,. Then,,, Allow the washer to stand for service. This will be displayed the next time the washer is out of balance.
Similar Questions
Drain
I have Model 40272900 front loading washer. Stopped cycle at drain. Is it recalled and the local sto...
I have Model 40272900 front loading washer. Stopped cycle at drain. Is it recalled and the local sto...
(Posted by bevpwrs61 2 years ago)
Where Is The Filter Located On A Kenmore Washing Machine Model 110 24622300?
(Posted by rlhaan36 8 years ago)
Door Lock Won't Release
Off/on works fine, controls seem to work, but when puased lock clicks 3 times repeatedly, but will n...
Off/on works fine, controls seem to work, but when puased lock clicks 3 times repeatedly, but will n...
(Posted by john53766 9 years ago)
Kenmore Model 110.22722101 Washer Capacity?
what is the washer tub capacity of a kenmore model 110.22722101 washer?
what is the washer tub capacity of a kenmore model 110.22722101 washer?
(Posted by msp82756 10 years ago)
Machine Stop Working
My washing manchine is about 5 years old and it is model 110 24622300 , it just filled up chamber up...
My washing manchine is about 5 years old and it is model 110 24622300 , it just filled up chamber up...
(Posted by davidgrinnen 12 years ago)