Kenmore HE2t Support Question
Kenmore HE2t Support Question
Find answers below for this question about Kenmore HE2t - 3.7 cu. Ft. Front Load Washer.Need a Kenmore HE2t manual? We have 1 online manual for this item!
Question posted by rlhaan36 on September 8th, 2015
Where Is The Filter Located On A Kenmore Washing Machine Model 110 24622300?
The person who posted this question about this Kenmore product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by TechSupport101 on September 8th, 2015 10:02 AM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
This model does not appear to use/have a filter - see the parts here http://www.partselect.com/Models/110.24622300/Parts/
Related Kenmore HE2t Manual Pages
User Guide - Page 3
...Washer Safety 1-1 Model & Serial Number Designations 1-2 Model & Serial Number Label And Tech Sheet Locations 1-3 Specifications 1-4
INSTALLATION INFORMATION 2-1 Installation Requirements 2-1 Installation Instructions 2-6
PRODUCT OPERATION 3-1 Features And Benefits 3-1 Washer Use 3-3 Washer... Switch 5-2 Line Filter 5-3 Detergent Dispenser Motor & Switch 5-4 Door Switch 5-5 Drain ...
User Guide - Page 7
MODEL & SERIAL NUMBER LABEL AND TECH SHEET LOCATIONS
The Model & Serial Number Label and Tech Sheet locations are shown below.
Model & Serial Number Label
Tech Sheet (Behind Lower Access Panel)
1-3
User Guide - Page 8
Max
Width Product Weight (approx)
WFW8300SW
WFW8500SW
WFW8500SR
Front Load Washer
Front Load Washer
Front Load Washer
White with Gray Accents
White with Gray Accents
White with Sterling Bright Accents
3.3
3.6
3.6... Water Consumption Average DOE (Gallons-Per-Cycle) Rated Load Load Pounds
Height Install Depth: Min - SPECIFICATIONS
Model Number Model Description
Color
Capacity (Cu.Ft.
User Guide - Page 14
... coupling by hand until it is seated on the washer.
3. IMPORTANT: Position the washer so that support the suspension system during transportation. Screw on the valve. Then pull the power cord through the opening of the final location.
A
B
A. NOTE: If the washer is within approximately 3 ft (90 cm) of the rear panel and close the...
User Guide - Page 16
... stable and resting on the edges of the washing machine top plate, the machine should be secure, but loose enough to provide a gap for air.
• Do not lay excess hose on the top edge of the drain hose in the laundry tub or standpipe. LEVEL THE WASHER
One foot has been installed at the...
User Guide - Page 19
...load machines.
ADD A GARMENT
This option is available in which means fewer loads. When this option is no agitator, you can wash larger, bulkier items such as an average size sleeping bag.
LARGER LOAD... conventional washer.
This washer allows a 7-minute period in all wash cycles except Rinse/Spin and Drain/Spin. ADAPTIVE VARIABLE SPEED MOTOR
The motor adapts to the load size ...
User Guide - Page 22
... manufacturer's recommended amount for the selected cycle. To load washer
Open the washer door by pulling on the washer by turning the cycle selector. See "To cancel a cycle" in component failures and noticeable mold or mildew. Not all cycles. Sort laundry according to use. Load evenly.
• Wash small items such as it stops. The indicator light...
User Guide - Page 24
... Illustration)
Add 1/4 cup (60 mL) liquid fabric softener to your load.
• Always measure liquid chlorine bleach. Do not use .
•... 1 second) to the wash cycle and when the controls are available with a pour spout; The washer powers down, the door...the water level or the temperature is not available, the machine will drain automatically before START is selected. Select and hold ...
User Guide - Page 26
... in the machine increasing the wash time. The preset settings provide the recommended fabric care for gentle fabric care.
• Use mesh garment bags to wash loads of 3...washing temperatures assure optimal bleach activity.
Cycle
Sanitary Whitest Whites Heavy Duty Normal/Casual Quick Wash (2-3 items) Delicate/ Hand Wash Clean Washer Rinse/Spin Drain/Spin Soak
Estimated
Time* (hr:min)
Wash...
User Guide - Page 27
... is unavailable with an empty wash tub.
NOTE: Loads of your wash load. The countdown to avoid fabric stress. These new sounds and pauses are not accustomed to thoroughly clean the inside of normal washer operation.
Rinse/Spin
Use this cycle to drain your washer or to drain and spin your washing machine. This cycle combines fast-speed...
User Guide - Page 28
...; Use powdered detergent to keep laundry additives from the washer as soon as in the normal rinse. ATC regulates incoming hot and cold water. This option provides an additional rinse with Warm and Cold settings.
• The Cold rinse temperatures depend on the type of load you are washing. The washer continues automatically from garments...
User Guide - Page 30
...Cycle lights will flash and the WASH and CONTROLS LOCKED lights will stop the cycle. Be sure the dispenser drawer is closed .
5. Washer Maintenance Procedure
This washer has a special cycle that follows. ... then the cycle will continue.
• The machine will not fill, but the basket will unlock. The door will rotate while the washer runs a short sensing cycle. Failure to the ...
User Guide - Page 31
... for other causes. Remove the inserts (the siphon from faucets and drain. NOTE: Do not wash components in the drum.
2. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, ...bleach.
• If the procedure does not sufficiently improve the machine freshness, please evaluate your washer during freezing weather, winterize it looking new. Shut off the water supply ...
User Guide - Page 32
... manufacturer's recommended amount for a medium sized load.
3-14 Unplug the power cord.
3. Disconnect the water inlet hoses from the drain system and attach to locate, level and connect the washer.
2. Run the washer through the Normal/Ca-
To transport the washer:
1. To avoid suspension and structural damage, your machine must be transported in the drum. Reinstalling...
User Guide - Page 33
... hear metal items touching the washer drum. All four feet of the machine removed? Refer to cancel the cycle Unplug washer or disconnect power. The plywood may hear air being pulled through the pump. You may be shown in the Estimated Time Remaining display (on some models).
• "Spin" and "Wash" (HT "Rinse" and "Cycle...
User Guide - Page 34
...dispenser (on ? Do not use ? See "Washer Care" for leaks. This is the "Add a garment" light on some models)? WASHER ODOR
• Have you follow the manufacturer's ...washer has a tight seal to the Main Wash compartment.
• Is there water in the correct dispenser compartment?
Check household plumbing (laundry tubs, faucets, drainpipe, water pipes) for details.
• Are the laundry...
User Guide - Page 39
COMPONENT LOCATIONS
Water Inlet Valve
Line Filter
Detergent Dispenser Motor & Assembly
Pressure Switch
Central Control Unit
Temperature Sensor (On Rear ... Assembly
Rear Interlock Switch ECO Valve Motor Control Unit
Drain Pump
4-1
The components and their locations are shown below. COMPONENT ACCESS
This section instructs you on how to service each component inside the Duet Sport™...
User Guide - Page 80
...model. (abnormal = infinity) 4. Unplug washer or disconnect power for foreign objects. 5.
MOTOR CONTROL UNIT ERROR The Motor Control Unit has internal failure; repeating under or over voltage, or over current conditions. If failure occurs during the water-heating step of the WASH... Causes/Procedure The relay might be dis-
The machine will be displayed, then 4 minutes later the ...
User Guide - Page 81
... cycle again.
6-3 Check wire harness connections to properly detect motor speed, the machine shuts down . Check the MCU by looking for proper shut off hot and cold water faucets and unplug the unit before servicing. LOAD INSIDE DRUM DURING CLEANING WASHER CYCLE
If at the MCU is not mounted upside down . DISPLAY
EXPLANATION...
User Guide - Page 82
... will be drained and it is not plugged or kinked.
2. Plug in washer or reconnect power. 6.
Check the drain hose and make sure it will ...Wash
Soak/Prewash, Cycle Complete
6-4 Check/clean drain pump filter of the excess detergent.
1. Run the unit through a RINSE/SPIN cycle. -
Check drain pump. 7. Possible Causes/Procedure If too much detergent was used: - Some models...
Similar Questions
Kenmore Model 110.22722101 Washer Capacity?
what is the washer tub capacity of a kenmore model 110.22722101 washer?
what is the washer tub capacity of a kenmore model 110.22722101 washer?
(Posted by msp82756 10 years ago)
Distinguishing Different Models Of Kenmoore Washing Machines
How to determine between an 80 series and a 90 series kenmoore washing machine? I was told that the ...
How to determine between an 80 series and a 90 series kenmoore washing machine? I was told that the ...
(Posted by clinebuccie 10 years ago)
I could provide User Manual Kemore The Washing Machine Series 80 11,020,802
I could provide the instruction manual of the washing machine 80 series 110 20,802,991 kemore.
I could provide the instruction manual of the washing machine 80 series 110 20,802,991 kemore.
(Posted by janli 10 years ago)
How To Reset Washing Machine
Washing machine model 110.92195510; serial # CB1401610. Machine became unbalanced and will not run...
Washing machine model 110.92195510; serial # CB1401610. Machine became unbalanced and will not run...
(Posted by waynelfrank 10 years ago)
Kenmore Washing Machine
Hi I have a kenmore washing machine model #110.22722101 it fills up and agitates but wont spin and d...
Hi I have a kenmore washing machine model #110.22722101 it fills up and agitates but wont spin and d...
(Posted by hunter22818 12 years ago)