Jensen UMP401 Support Question
Jensen UMP401 Support Question
Find answers below for this question about Jensen UMP401 - Phase Linear Radio.Need a Jensen UMP401 manual? We have 1 online manual for this item!
Question posted by baldyman74 on October 16th, 2018
Viewing Radio
the radio is on but no view showing no numbers nothing
Current Answers
Related Jensen UMP401 Manual Pages
Owners Manual - Page 2
...load impedance of 4 ohms. Speakers with a load impedance of the instructions before purchasing to 5:00 p.m. UMP401
PREPARATION
Getting Started
It's a good idea to read all of less than 4 ohms could damage the... unit. to make sure the kit works with an existing radio opening. Pour des instructions en Francais, référez-vous à la page 38. and...
Owners Manual - Page 3
... into the dashboard opening size by sliding the mounting sleeve into it to bend or bow. Place the radio in front of horizontal. Make sure the unit is locked into position, use the removal tools (supplied)... that follow. Secure the rear of the mounting sleeve. UMP401
INSTALLATION INSTRUCTIONS
Using the Mounting Sleeve
1. Check for sufficient space behind the dashboard for the...
Owners Manual - Page 4
... and pulling it off from the existing radio and attach them to the new radio. Mount the new radio assembly to the dashboard or center console using the reverse
UMP401
procedure in step 6 of installation.
1. CAUTION: Do not exceed M5 X 6 MM screw size. Removing the Radio
To remove the radio after installation, remove the trim ring...
Owners Manual - Page 5
...(-) Gray (+)
Violet/Black (-) Violet (+)
RF/AVD RR/ARD
Power Antenna Connect to existing radio wire or radio fuse. The red connector is for the left. Never ground negative speaker leads to battery or... optional
Gray
external amplifiers. The radio will not work if this wire is for the right and the
white connector is not connected.
UMP401
WIRING
Auxiliary Input Antenna Connector
15A...
Owners Manual - Page 6
...away from dirt and damage.
• Make sure there is centered in the protective case provided.
UMP401
INSTALLING THE REMOVABLE FACEPLATE
Faceplate Installation
To install the faceplate, slip the right edge of the front ... electrical terminals on the left side into the radio then gently press the left side of the panel as this could cause intermittent operation or other ...
Owners Manual - Page 7
... adjust the bass response from a minimum of "BAS -7" to a maximum of the numbers on the LCD may take longer to the setting that , if subjected to cold temperatures...illuminate than under normal conditions. button (3). UMP401
OPERATING INSTRUCTIONS
1 Power On/Off Button
Press the power button (1)... or release) to turn the unit off.
1 Audio MUTE
Press the power/MUTE button (1) to silence the...
Owners Manual - Page 8
...BEEP ON" or "BEEP OFF".
4 MP3 Multi-Session (MULT)
MULT ON: Will read single session discs only.
6a
MUTE
UMP401 CD / MP3 / WMA / RECEIVER
3
SRC
ALBUM MUSIC ARTIST
BAND
5
SEL
DISP
AS/PS
1
INTRO
2
REPEAT
3
RANDOM...front and rear speakers.
4 Equalizer Selector (DSP)
1. UMP401
OPERATING INSTRUCTIONS
4 Treble Control
To adjust the treble level, press the SEL button (4) until "...
Owners Manual - Page 9
... manually tune the radio higher, or the tune/track ( ) button (6b...pressed, the radio band changes. The radio will automatically scan the band in the stereo mode. thereby improving radio reception. ...stored stations.
9 Local Button (LO/DX)
During radio operation, received signals are much stronger; Press the...Select (ST/MO)
During FM radio operation, the ST/MO button (7) is turned on...
Owners Manual - Page 10
...compensate for each band.
12
6a 20
MUTE
UMP401 CD / MP3 / WMA / RECEIVER
3
... can display either the clock time or radio frequency/CD player functions. Setting the Clock....
3.
Press the DISP button again to return to radio frequency.
14 - 19 Station Pre-Set Memory
To... remains on and select the desired band. 2. UMP401
OPERATING INSTRUCTIONS
10 Loudness Control (LOUD)
When listening ...
Owners Manual - Page 11
...of a particular track. Press the volume +/- "S CDP" will appear. Once loaded, the track number and elapsed time will appear on the display panel.
6 Cue/Review Functions
Press and hold the SEL.... The current mode is selected, as damage to radio without an adaptor, as shown on the display panel. NOTE: The unit is pressed,
13
12
6a
MUTE
UMP401 CD / MP3 / WMA / RECEIVER
3
SRC
...
Owners Manual - Page 12
...20 Disc Eject Button
When the disc eject button (20) is ejected, and the unit will change to radio operation. Press 1/ again to resume disc playback.
15 Track INTRO Scan
During disc play, press the 2/...the display). In Random Play mode, you can also be re-loaded.
13
6a 20
MUTE SRC
SEL
DISP
UMP401 CD / MP3 / WMA / RECEIVER
ALBUM MUSIC ARTIST
AS/PS
1
INTRO
2
REPEAT
3
RANDOM
4
5
BAND
...
Owners Manual - Page 13
... (hundredth) position, if necessary.
5. Press the volume +/- Choose to select the last digit of the track number.
4. Press the SEL button (4) to play the entire folder or a specific
song in the selected folder.
6a
MUTE
UMP401 CD / MP3 / WMA / RECEIVER
3
SRC
ALBUM MUSIC ARTIST
BAND
SEL
DISP
AS/PS
1
INTRO
2
REPEAT
3
RANDOM...
Owners Manual - Page 14
... song/ file.
6.
Press the AS/PS (8) button three times to select the first character position.
3. Press the SEL button to the next character position.
5. UMP401 6a
MUTE
UMP401 CD / MP3 / WMA / RECEIVER
3
SRC
ALBUM MUSIC ARTIST
BAND
SEL
DISP
AS/PS
1
INTRO
2
REPEAT
3
RANDOM
4
5
6
ST/MO LO/DX
LOUD
4
8
6b
14 Press...
Owners Manual - Page 15
UMP401
REMOTE CONTROL
The remote control will allow you to the left of the UMP401. The remote control sensor is located to control the basic functions of the LCD panel.
UMP401
MUTE
SEL MENU LOUD
VOL ST/MO
SRC
AS/PS SEARCH
LO/DX
BAND
1 234
/
INT
RPT
RDM
5
6
DISP
BY JENSEN
15
Owners Manual - Page 16
...
• Carefully wipe fingerprints, dust and dirt from the disc's playing surface with a soft cloth.
16
UMP401
Wipe in this product.
• When not using the player.
• If the temperature inside .
&#...fluids on the unit.
• The CD player is completed; CARE AND MAINTENANCE
Your new radio/CD player does not require any of the switches on the unit, pressing the Reset button ...
Owners Manual - Page 17
... for closing a disc/session. Please refer to your recording software to change without notice.
17 This unit does not support .WAV, .OGG or other formats.
UMP401
SPECIFICATIONS
CD-R and CD-RW Capability
Depending on media type and method of ROXIOTM or NEROTM burning software. This unit will only recognize the CDDA...
Owners Manual - Page 55
90 Day Limited Warranty
CD Radios/Headunits
Who is covered? AUDIOVOX ELECTRONICS CORPORATION (the Company) extends this warranty to...without limitation, fire, flood, earthquake, sand or storm • Products subjected to removal or defacement of the factory serial number/bar code label(s) or markings • Service performed by Audiovox within the terms of this product or any liability other...
Similar Questions
Jensen Phase Linear Ump9020 Face Plate Won't Operate.
Jensen Phase Linear UMP9020 The faceplate the reveals the CD and Cassette slots won't open/close. An...
Jensen Phase Linear UMP9020 The faceplate the reveals the CD and Cassette slots won't open/close. An...
(Posted by eJud2001 4 years ago)
Phase Linear Uv8020
will a phase linear uv8020 fit my 2002 f150 pickup? and if so how do install it?
will a phase linear uv8020 fit my 2002 f150 pickup? and if so how do install it?
(Posted by bellcheryl63 12 years ago)
I Need Install Manual
the manual says it needs a 9 volt battery, how does that fit on the stereo? Jensen phase linear UMP4...
the manual says it needs a 9 volt battery, how does that fit on the stereo? Jensen phase linear UMP4...
(Posted by dianeblakey 12 years ago)
Manual?
i have a phase linear cd/radio player and do not have the manual? everytime i get in the car and sta...
i have a phase linear cd/radio player and do not have the manual? everytime i get in the car and sta...
(Posted by vilena99 12 years ago)