Get support for Jenn-Air JDS9865BDP

Jenn-Air JDS9865BDP Support Question

Jenn-Air JDS9865BDP Support Question

Find answers below for this question about Jenn-Air JDS9865BDP.
Need a Jenn-Air JDS9865BDP manual? We have 5 online manuals for this item!
Question posted by krporter1 on November 27th, 2016

Rapid Heat Not Working But Everything Else Is

oven light wont turn off and rapid heat not working as well

Current Answers

Answer #1: Posted by waelsaidani1 on November 27th, 2016 4:19 PM
waelsaidani1

Member since:
May 12th, 2013

Points: 19,501,787
100
points
the control board is faulty, call for service.

Related Jenn-Air JDS9865BDP Manual Pages

Dimension Guide - Page 1

...kits that the ground path and wire gauge are for turning on the model/serial rating plate for it here. Shutoff valve "open" position C. Range must be level for use with Natural gas. Page...connecting to convert the appliance from each front corner of your model) has information on the oven frame behind the control panel or on the types of gas that resist the action of &#...
Installation Instruction - Page 4

...; Masking tape Parts supplied Check that the floor covering can be reduced by reaching over carpeting. Oven racks ■ 1 - Thickness of 194°F (90°C). If cabinet storage is to...°C). ■ Use an insulated pad or ¼" (0.64 cm) plywood under range if installing range over heated surface units, cabinet storage space located above . 4 Air grille ■ 3 - vent...
Installation Instruction - Page 9

...connected load listed on the types of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. Explosion ...oven frame, depending on your model) has information on the model/serial rating plate. ■ A time-delay fuse or circuit breaker is recommended. ■ This range is factory set for use with LP gas. ■ This range...
Installation Instruction - Page 11

... either the left ) edge of the cutout. Centerline B. 14¹⁄₄" (36.2 cm) 11 Remove shipping materials, tape and film from inside oven. 3. Re-engage anti-tip bracket if range is taped to follow these instructions can use the wall mounting method. 3. Failure to the package containing literature. 2. Do not operate...
Installation Instruction - Page 19

... positioned, surface burners will not light. Adjusting leveling legs if necessary. 3. then front to clear countertop. Plug range into grounded outlet (if using ...oven. Attach flexible vent (provided) to look underneath the bottom of the anti-tip bracket. 1 1 2 A B A. a.) Place rack in burner base. Level the range. c.) If range is not level, pull range forward until range...
Installation Instruction - Page 21

...Range Use" in place of /recycle all parts are now installed. See the Use and Care Guide for heat. If burners do not light properly: ■ Turn...Turn on range...turned to the "LITE" position, the system creates a spark to "LITE." If the range is cold, turn...turned to light... flame should light within 4 ...Light 1 burner and turn the control knobs to turn off the range and check that range...
Use and Care - Page 5

... hot air or steam escape before initiating the cleaning cycle. Build-up of the range. ■ Wear Proper Apparel - Always place oven racks in temperature. ■ Utensil Handles Should Be Turned Inward and Not Extend Over Adjacent Surface Units - Heating elements may ignite. ■ Glazed Cooking Utensils - During and after use . In Canada, the...
Use and Care - Page 6

... setting heat levels. If you have purchased may have some models) during the Self-Cleaning cycle, the entire cooktop area may not match those of the items listed. Push in the left or right rear positions. E F D. Check for a clicking sound. Electronic oven control E. Turn knob anywhere between High and Low ■ Hold a rapid boil...
Use and Care - Page 10

... HR using the left Quickset pad. 6. Timer 2 G. Rapid preheat K. Vent fan O. Lock Electronic Control Pads When pressing... pad. 3. Favorites C. Convect O P J. Oven Display When power is supplied to the range or after entering the function, option, number or...12-hour mode. (For 24-hour clock, see following.) 7. Oven light P. Press SETUP. 2. Press the right Quickset pad to press...
Use and Care - Page 11

...desired timer beep using the left Quickset pad. 6. Oven Light The oven light automatically comes on when the door is closed , press the OVEN LIGHT pad to turn the clock display On or Off. Use right ...1. Press TIMER 1 or TIMER 2. 2. Select LANGUAGE using the left Quickset pad to turn the oven light on the Quickset pads repeatedly until "CONTROL LOCKED" appears in use of day. Use ...
Use and Care - Page 12

...Temp Adjust Oven temperatures are deactivated when the Sabbath Mode is active. ■ If the oven light is set for 33 hours. As ovens get older, the oven temperature can be set the oven temperature 25&#... be required to exit the Setup menu. MANUAL sets the oven to program Sabbath Mode. ■ Sabbath Mode cannot be turned on before the Sabbath Mode is desired while in temperature....
Use and Care - Page 13

...1. Tones (beeps) The number of beeps heard at the end of cooking and at the end of the range. 1. To change . 7. OR 1 BEEP to 208/240V. 3. OR LOW for medium volume. Press SETUP to ...pad to hear 1 beep only at the end of 12 hours if you will automatically turn off at the end of the oven control displays the Jenn-Air eXperience Center toll-free phone number. 1. Energy Saver To ...
Use and Care - Page 15

...finished cooking. BAKEWARE/ RESULTS RECOMMENDATIONS Light colored ■ aluminum ■ Light golden crusts ■ Even browning Use temperature and time recommended in the oven. 1. Ovenproof glassware, ceramic ... for baking, roasting or heating foods. For baking, allow the range to preheat before placing food in recipe. To change the oven temperature during cooking, press ...
Use and Care - Page 17

... space between the cookware and the sides of the oven. Failure to follow these instructions can result in the oven. It is off . Allow the range to allow a more than one hour before or ...done, continue roasting. Place food in the oven with a method such as using a toothpick. After 3 seconds, the oven will be used to heat. If food is turned on some models) Convect Bake can be ...
Use and Care - Page 19

...■ For any dough that requires one rise, either Standard or Rapid Proofing can also be used . ■ When using the Quickset pads... Use only oven-safe plates. Select KEEP WARM using the left in the oven. 2. Keep probe as far away from heat source as..." will appear in following diagram. Warm for 12 to turn off the oven and leave plates in determining the doneness of the probe...
Use and Care - Page 24

... time will appear in burns. RANGE CARE Self-Cleaning Cycle (on some models) WARNING How the Cycle Works IMPORTANT: The heating and cooling of porcelain on your model, see "Oven Vent" or "Oven Vents" section. Air must be displayed while the oven is left open, "CLOSE DOOR" will be displayed. 5. Set LIGHT soil level by entering "200...
Use and Care - Page 26

... back into bracket and close access door. Food spills should be cleaned when oven cools. If this happens, a light coating of cooktop. ■ Lift the vent grate off during use metal ... scrubbing pad. ■ Do not use the area behind the bottom access panel, underneath the range. IMPORTANT: To avoid the possibility of accidentally disconnecting any part of the ventilation system, do not...
Use and Care - Page 27

...on hinges. To Remove: 1. Grasp door at an angle. To Replace Oven Light: Before replacing, make sure the oven is completely seated on the hinges. Slide the door down on the .... Ask for Part Number 74004458. Unplug range or disconnect power. 2. The bottom of bulb cover. Cleaning Method: ■ Turn off and cool. Oven Lights The oven uses a 120-volt, 20-watt maximum...
Use and Care - Page 28

... a setting. ■ Are the burner ports clogged? Push in knob before turning to follow these instructions can result in death, fire, or electrical shock. ■... Oven Control" section. ■ Has a delay start been set to the proper heat level? Let it dry. See "Cooktop Controls" section. ■ Is the range level? Oven will not operate ■ Is the electronic oven control...
Use and Care - Page 29

... releases oven heat and can result in the "Setup" section. ■ Was the oven preheated? Food may be too close to preheat for 5 minutes. See the Installation Instructions. ■ Is the outside wall cap shut or blocked? ■ Was the range and air filter installed properly? See the Installation Instructions. 29 See "Temp Adjust...

Similar Questions

What Is The Correct Part No. For This Model's Halogen Oven Light Bulb?
I have a Jenn Air downdraft range, model JES9860CAS, with a burnt out halogen oven light (two pin). ...
(Posted by Cpgeiger1 6 years ago)
Our Fan Quit Working
We just purchased a Jenn-AIr JGRP430WP about a month ago and now the fans quit working.
(Posted by alyandjohn 7 years ago)
Jenn-air Jgs9900 Downdraft Fan Only One Speed Is Working
Only one of the 2 speeds is working on my Jenn-Air JGS9000 downdraft fan. Is there a fix for this
(Posted by kfcarpenter 8 years ago)
Ask a New Question
Use the box below to post a new question about this Jenn-Air product .
Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Jenn-Air Manuals

Find free Jenn-Air JDS9865BDP manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Jenn-Air Reviews

View thousands of Jenn-Air user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Jenn-Air customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Jenn-Air customer service rankings, employee comments and much more from our sister site.