Image Fitness 518 Support Question
Image Fitness 518 Support Question
Find answers below for this question about Image Fitness 518.Need a Image Fitness 518 manual? We have 1 online manual for this item!
Question posted by pogurk on January 11th, 2019
Image 518 User Manual
I am looking for user instructions on how to use the Image 518 Professional Fitness System equipmjent.
Current Answers
Answer #1: Posted by Odin on January 11th, 2019 12:04 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,710
Member since:
April 10th, 2010 Points: 41,236,710
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Image Fitness 518 Manual Pages
English Manual - Page 1
....
E
Serial Number Decal
11
,-411114%. i..4..•.0..0.e
'ft".... ......s..o. *
..../. ..
..i.r...iI,...I.I
7.....".. 1IV
Model No.
The serial number can be found in the space above. i -.
"III
1`%
44 IIIIIIIMW
OWNER'S MANUAL
CAUTION!: Read all safety precautions and instructions In this manual before using
this manual in a safe place for future reference.
English Manual - Page 2
... the designated handles. If the pin is in the accompanying literature before using the IMAGE 518.
1.
Replace any time while exercising, stop immediately and begin cooling down. The weights will fall with pre-existing health prob- If you use , causing serious injury.
6. Inspect and tighten all instructions in this product. Keep small children away from the...
English Manual - Page 3
... of weight training exercises to the IMAGE 518 (see the front cover of this manual and the accompanying literature before calling. until 6 p.m.
Before reading further, please examine the drawing below and familiarize yourself with the parts that are labeled. If you , please note the product model number and serial number before using the IMAGE 518.
V, 814
lull...
English Manual - Page 4
... and 3/8" Nylock Nut (1). Attach a Pulley (9) to the size and weight of the image 518, it will be used in assembly. Be sure the Base (89) is -turned-se that all parts of soapy...
7 106 Attach the Weight Guide Base (88) to the PART IDENTIFICATION (ID) CHART accompanying this owner's manual for assembly: two 8" adjustable wrenches, a 9/16" socket wrench, a 1/2" socket wrench, a rubber mallet...
English Manual - Page 7
...). Assemble the Left Butterfly Arm (74) in assembly steps 2-10.
11. Press two 2" x 2" Inner Caps (11) into the Right Butterfly Arm (75). Tighten all Nuts used in the
\ , , , •
. ,
,
' 3
same manner.
13. Press the Bumper Cap (111) onto the Butterfly Arm Support (73). Insert the post up through the Butterfly Arm...
English Manual - Page 9
... and turn it clockwise until it outward (see the inset drawing).
Attach the "U" Handle (68) and the Short Seat Post (69) to the desired height. Using an adjustable wrench, tighten the shaft 18 of 17 the Short Seat Post (69). Attach the VKR Frame (67) to wet the "U" Handle with soapy...
English Manual - Page 11
...Frame Top (80).
Press two 2" x 2" Inner Caps (11) into the Press Arm, Adjuster and Frame Top. Using a rubber mallet, tap the 7 1/2" Axle (30) into the
24
posts on the Press Arm (102) as... shown. Hold the Adjuster (103) between the posts on the Press Arm (102).
Using a rubber mallet, tap the 10 3/4" Pin until the 7 1/2" Axle is centered in the Frame Top (80...
English Manual - Page 13
... (9) to the Leg Press Stabilizer (96) with a 1/2" x 3" Bolt (34), two 9/16" Washers (33) and a 1/2" Nut (32). Grease the insides of the Leg Press Lever (97).
Using a rubber mallet, tap a 13 1/4" Axle (31) through the Leg Press "H" Frame and the Leg Press Stabilizer. Insert two 5/8" Bushings (24) into the Leg Press Plate...
English Manual - Page 14
Using a
rubber mallet, tap a 131/4" Axle (31) through
the Leg Press Plate and the Leg Press "H"
Frame. Press a 2" x 2" Inner Cap... Frame (101) counterclockwise and pull it upward (see the inset drawing). Make sure that the Leg Press Rail is angled as shown.
Using an adjustable wrench, tighten the shaft of a Lock Knob (46) into the side of the Leg Press Rail (100). Turn the ...
English Manual - Page 24
...manual.
69. The Weight Decal numbered "10" should be explained in the same manner.
84
0
112
1
68. If any of the cables does not move smoothly, locate and correct the problem before using the IMAGE 518...pins w/tabs are not properly routed, they may be attached to the other weight stack in USING THE IMAGE 518, beginning on the next 2 pages and make sure that each of each cable a few...
English Manual - Page 27
... your hand. •
4. See the Exercise Guide accompanying this owner's manual to see how the IMAGE 518 should be set up and hold it.
...IMAGE 518 can be adjusted. Loosen the Threaded Knob (45).
46
46
2. Pull the Lock Knob outward.
105
2. See ADJUSTING
THE HEIGHT OF THE SMALL SEAT above.
45
a
45
27 USING THE IMAGE 518
The instructions below describe how each individual exercise...
English Manual - Page 28
...hole in the Leg Press
Frame.
CHANGING THE WEIGHT SETTING
The dual weight stacks allow two exercise stations to 200 pounds in the Leg Lever. Each weight, including the top weight, weighs ...Leg Press Frame
(101) can be adjusted for different exercises.
To lock it into the storage hole in increments of three heights. Note: When using the leg press, the amount of the Press Arm ...
English Manual - Page 29
... Long Chain (82) should be attached between the Rower Bar and the low cable with two Cable Clips.
For some exercises, the Long Chain (82) should be attached between the Lat Bar and the high cable with two Cable Clips. The Rower Bar (107), Hand Strap (...
English Manual - Page 30
The IMAGE 518 can be cleaned using a damp cloth and mild non-abrasive detergent.
Open One of the Cable Clips,
and slide a ...
tight. Turn the bolt clockwise
to the right weight stack, find the bolt on either end. ing the bolts, follow the instructions below.
To adjust the cables attach'4e to the left weight
stack, find the Short Chain (81) with a Cable Clip...
English Manual - Page 31
... Arm Adjuster Leg Press Plate Long Seat Post Leg Press Base Rower Bar Ankle Strap Hand Strap Ab Strap Bumper Cap Weight Decal Sheet Owner's Manual Exercise Guide Exploded Drawing/Part ID Chart
Grease
Note: "#" indicates a non-illustrated part. IM518021
Rev. 6/93
See the Exploded Drawing accompanying this owner...
English Manual - Page 32
... you. To obtain such free repair or replacement, please tell our Customer Service Department the product's. Image, Inc. 3670 Parkway Lane-Suite J
Hilliard, OH 43026
Part No. 113078 6/93 © 1993 Image, Inc.
Printed in use as described and prescribed by our labels anc
brochures it does not perform as the nature of...
Similar Questions
Parts Manual
where can I get a parts manual for image rewnew 631 spa?
where can I get a parts manual for image rewnew 631 spa?
(Posted by Anonymous-139384 9 years ago)
Image Renew 631 Filter Cover
Where can i buy a 631 image renew filter cover , I would like a parts manual for my spa.
Where can i buy a 631 image renew filter cover , I would like a parts manual for my spa.
(Posted by Anonymous-139384 9 years ago)
Image 512 Manual
Does anyone know of any web site to go to for information on how to set up my image 512 system that ...
Does anyone know of any web site to go to for information on how to set up my image 512 system that ...
(Posted by luxter64 10 years ago)
Image Pillow Image Renew 615 Sports & Fitness Equipment Model #imhs61500
I need the pillows for this spa. I want to purchase 6 of them. [email protected]
I need the pillows for this spa. I want to purchase 6 of them. [email protected]
(Posted by inspector0073 10 years ago)