Husqvarna YTA19K42 Support Question
Husqvarna YTA19K42 Support Question
Find answers below for this question about Husqvarna YTA19K42.Need a Husqvarna YTA19K42 manual? We have 1 online manual for this item!
Question posted by carld1 on August 16th, 2022
Yta19k42 Transmission
forward very slow - reverse almost nonexistant - can it be repaired or is replacement required ? what is the part number for replacement trans.?
Current Answers
Answer #1: Posted by Odin on August 16th, 2022 12:30 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Place the ignition key in the "ROS" ON position. But review https://www.manualslib.com/manual/636412/Husqvarna-Yta19k42.html?page=11&term=ros+%22on%22&selected=1#manual.
If the issue persists or if you require further advice, you may want to consult the company: use the contact information at https://www.contacthelp.com/husqvarna.
If the issue persists or if you require further advice, you may want to consult the company: use the contact information at https://www.contacthelp.com/husqvarna.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Answer #2: Posted by SonuKumar on August 16th, 2022 9:10 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,617,810
Member since:
May 9th, 2021 Points: 16,617,810
https://www.youtube.com/watch?v=GX8BngOHLHY
What causes a hydrostatic transmission to slow down?
Failure of any mechanical component, a broken hose, or clogged filter will cause tractor hydrostatic transmission problems. But the most common issue will be the oil itself. In the transmission section of your operator's manual, you'll find a section that covers oil viscosity.
https://nelsontractorco.com/fix-hydrostatic-transmission-problems/
https://www.manualslib.com/manual/636412/Husqvarna-Yta19k42.html?page=22
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Husqvarna YTA19K42 Manual Pages
Owners Manual - Page 2
.... • Do not mow in reverse unless absolutely necessary. These operators should evaluate... before operating. Operate only at all slopes requires extra caution.
Keep clear of the machine....Slow down a hill in gear when going down the slope.
• Keep all movement on the slopes slow...setting up, transporting, adjusting or making repairs, always disconnect spark plug wire and place...
Owners Manual - Page 3
... the area is clear of the mowing area and in reverse unless absolutely necessary. Check their proper operation regularly.
•... fuel-soaked debris. Adjust and service as required.
• Maintain or replace safety and instruction labels, as on a ...slowly and gradually downhill, if possible. Repair, if necessary, before operating a riding lawn mower.
Gasoline is in the mowing area...
Owners Manual - Page 4
... W/O Filter: 35 Oz./1,05 L
Champion RC12YC (Gap: .030"/.76 mm)
Forward: 0 - 5.2/8,4 Reverse: 0 - 2.9/4,7
15 @ 3600 RPM
AMP/HR: 28 MIN. Should you ...competent, well-trained technicians and the proper tools to service or repair this manual.
A spark arrester for
and using your tractor. ...mow in maintaining, caring for the muffler is required by the operator.
In the state of California...
Owners Manual - Page 5
...brakepedal. • Place freewheel control in "transmission disengaged"
position (See "TO TRANSPORT" in the Operation section of this manual). • Roll tractor forward off the skid.
TO REMOVE TRACTOR FROM ...battery cable installation see "REPLACING BATTERY" in the Service and Adjustments section in this manual. TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier...
Owners Manual - Page 6
...TO CHECK BRAKE" in safe operating condition. ✓ Be sure Operator Presence System and Reverse Op- CHECK FOR PROPER POSITION OF BELTS
See the figures that the brake is operating ... results. (Tires must be properly inflated for replacing motion and mower blade drive belts in this manual). Correct tire pressure is in "transmission engaged" position (see that are shown for leveling...
Owners Manual - Page 7
... death or serious injury. Learn and understand their meaning. REVERSE
NEUTRAL
HIGH
LOW
CHOKE
FAST
SLOW
IGNITION SWITCH
P
ENGINE OFF REVERSE OPERATION
SYSTEM (ROS)
ENGINE ON
ENGINE START
PARKING BRAKE
PARKING BRAKE PARKING BRAKE
LOCKED
UNLOCKED
OVER TEMP LIGHT
FUEL
OIL PRESSURE BATTERY REVERSE FORWARD
MOWER HEIGHT
15
MOWER LIFT
15
ATTACHMENT
ATTACHMENT
CLUTCH DISENGAGED...
Owners Manual - Page 8
...reverse.
(H) LIGHT SWITCH - Allows operation of the American National Standards Institute.
(A) ATTACHMENT LIFT LEVER - Disengages transmission for starting and stopping the engine.
(G) REVERSE...direction of various controls and adjustments. Used for future reference. Indicates when service is required for braking the tractor and starting the engine.
(C) PARKING BRAKE - Used for ...
Owners Manual - Page 9
...safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. When engine is controlled by the operator to "STOP" position and remove ...
F
Fig. 6
( ) ATTACHMENT CLUTCH LEVER "DISENGAGED"
( ) ATTACHMENT CLUTCH LEVER "ENGAGED"
TO MOVE FORWARD AND BACKWARD (See Fig. 7)
The direction and speed of grass.
Pedal should remain in the "DISENGAGED" ...
Owners Manual - Page 10
... TO STOP MOWER BLADES
• Disengage attachment clutch control.
For healthier and better looking lawns, mow often and after moderate growth. • For best cutting performance, grass over 3"...Do not operate the mower without either the entire grass catcher, on hills. • If slowing is necessary, move motion control lever to 4".
IMPORTANT: THE MOTION CONTROL LEVER DOES NOT ...
Owners Manual - Page 11
.... SERVICE REMINDER/HOUR METER
USING THE REVERSE OPERATION SYSTEM (See Fig. 11)
Only use of the ROS is dangerous. Service reminder shows the total number of hours the engine has run until ... pedal is located at more than two (2) MPH.
• To reengage transmission, reverse above procedure. When service is required, the service reminder will shut off any position but "STOP". Never use ...
Owners Manual - Page 12
... control in cold temperatures (below 32° F /0°C) the carburetor fuel mixture may require an engine warm-up .
This can be done during the engine warm-up period after ...may need to fast position. See "TO ADJUST CARBURETOR" in cold weather, the transmission
should be used . AUTOMATIC TRANSMISSION WARM UP • Before driving the unit in the Service and Adjustments section ...
Owners Manual - Page 13
..., check to operator abuse or negligence. Not required if equipped with oil filter)
Change Engine Oil (without oil filter)
E N Clean Air Filter G Clean Air Screen I Inspect Muffler/Spark Arrester N Replace Oil Filter (If equipped) E Clean Engine Cooling Fins
Replace Spark Plug
Replace Air Filter Paper Cartridge
Replace Fuel Filter
3 4 5
1,2 1,2
2 2
1, 2 2 2
1 - Some adjustments will need to...
Owners Manual - Page 14
...bright. BRAKE OPERATION
If tractor requires more than five (5) feet to... by the operator to shift into reverse should not start unless the brake...repair the problem immediately. NOTE: To seal tire punctures and prevent flat tires due to open .
• Recharge at highest speed in the disengaged position.
Do not attempt to slow leaks, tire sealant may cause tire damage. Replace...
Owners Manual - Page 16
... spark arrester (if equipped) as necessary. SPARK PLUGS
Replace spark plugs at all times. IN-LINE FUEL FILTER (See Fig. 18)
The fuel filter should be kept free of dirt and chaff to overheating. Water in engine or transmission will not run properly using a garden hose or pressure washer to clean your tractor...
Owners Manual - Page 17
...
Move the tractor's attachment clutch control to lock the adapter on your lawn, near enough to a water spigot for your garden hose to turn the tractor's engine off . 9. Move the tractor's... PORT
Fig. 20
IMPORTANT: Tug hose ensuring connection is in mower with the blade. • Replace broken or missing washout fitting immediately, prior to a dry area, preferably a concrete or paved area...
Owners Manual - Page 18
... with plug. HAVE A TIGHT GRIP ON LIFT LEVER, LOWER IT SLOWLY AND ENGAGE IN LOWEST POSITION. NOTE: Be sure mower side suspension arms (A) are pointing forward before sliding mower under tractor. • Slide mower under tractor until it cannot come in "DISENGAGED" position. • Turn ignition key to "STOP" and remove...
Owners Manual - Page 20
... ADJUSTMENT (See Fig. 28)
• With all tires properly inflated and if your lawn and lead you are satisfied with wrench and tighten jam nut securely against adjustment nut.
If...8226; Recheck measurements, adjust if necessary until you to think the mower is pointing straight forward.
SERVICE AND ADJUSTMENTS
TO LEVEL MOWER
Ensure tires are properly inflated to the PSI shown...
Owners Manual - Page 21
...needs to manually push the tractor forward. BELT INSTALLATION 1. Be sure belt...requires more than five (5) feet to front, over the steer-
Pull belt toward rear of left footrest.
Remove belt from mower.
Engage parking brake. Disengage transmission...sure belt is in "transmission disengaged" position. SERVICE AND ADJUSTMENTS
TO REPLACE MOWER BLADE DRIVE BELT ...
Owners Manual - Page 22
...slow leaks, tire sealant may be necessary.
• Engage the freewheel control lever. (See "TO TRANSPORT" in the Operations section of transmission so that the extruded area centerline is made, if the tractor does not reach full forward or reverse... not lose). • Repair tire and reassemble. • On rear wheels only: align grooves in axle groove. • Replace axle cover. FRONT WHEEL ...
Owners Manual - Page 27
...- Bent blade mandrel. 5. Level mower deck. 3. Frozen idler pulley. 4. Engine speed too slow.
1. Clean around mandrels.
1. Battery will not rotate
1. Engine throttle control not set between...shifted into reverse
1. See Operation section.
27 Wet grass.
3. Mower drive belt worn.
8. Check wiring and connections. 5. Replace motion drive belt. 4. Replace blade. Replace bulb(s) ...
Similar Questions
Will Not Go Forward
tractor will go reverse but not forward, bought part #532 10 57- 09 because this broken spring was f...
tractor will go reverse but not forward, bought part #532 10 57- 09 because this broken spring was f...
(Posted by sanewsomehy 2 years ago)
Reverse/forward Shifting Linkage Parts Diagram
my lawnmower will not shift into reverse it seems to be broken
my lawnmower will not shift into reverse it seems to be broken
(Posted by cbk3982 3 years ago)
Will Crank, Will Not Go Forward Or Reverse
This was my dad's mower that sat for several years. The mower would not engage so we replaced the be...
This was my dad's mower that sat for several years. The mower would not engage so we replaced the be...
(Posted by PAULARVT 3 years ago)
