Husqvarna YTA19K42 Support Question
Husqvarna YTA19K42 Support Question
Find answers below for this question about Husqvarna YTA19K42.Need a Husqvarna YTA19K42 manual? We have 1 online manual for this item!
Question posted by cbk3982 on August 30th, 2020
Reverse/forward Shifting Linkage Parts Diagram
my lawnmower will not shift into reverse it seems to be broken
Current Answers
Answer #1: Posted by Odin on August 30th, 2020 6:14 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
For a schematic see https://ishort.ink/QY1T. Also see https://ishort.ink/q7yv. If the issue persists you may need professional service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Husqvarna YTA19K42 Manual Pages
Owners Manual - Page 2
.... GENERAL OPERATION
• Read, understand, and follow all parts to come to cool before dismounting.
• Disengage blades ...in place and working. • Slow down a hill in reverse unless absolutely necessary. These operators should evaluate their ability to ...
• Keep all slopes requires extra caution. Do not shift to protect themselves and others from serious injury.
• ...
Owners Manual - Page 3
... controlled lawn mower and a minimum of 16 years of 15°. Allow machine to cool before operating a riding lawn mower....If machine stops while going uphill, disengage blades, shift into reverse and back down and behind before operating. CHILDREN
... out of the mowing area and in contact with manufacturer's recommended parts, when necessary.
• Mower blades are explosive.
•...
Owners Manual - Page 4
... 10W 30 (Above 32°F/0°C) SAE 5W30 (Below 32°F/0°C)
W/Filter: 51 Oz./1,5 L W/O Filter: 35 Oz./1,05 L
Champion RC12YC (Gap: .030"/.76 mm)
Forward: 0 - 5.2/8,4 Reverse: 0 - 2.9/4,7
15 @ 3600 RPM
AMP/HR: 28 MIN. It has been designed, engineered and manufactured to give you cannot easily remedy, please contact your nearest authorized...
Owners Manual - Page 5
...side panels flat.
• Check for location and function of this manual). • Roll tractor forward off the skid. BEFORE REMOVING TRACTOR FROM SKID
TO CHECK BATTERY (See Fig. 1)
• ... minimum of one hour at the factory with the instructions that follow all accessible loose parts and parts cartons from the skid.
fortable position is reached which allows you are listed.
(1) ...
Owners Manual - Page 6
...sectionofthismanual. Verifythatthebeltsareroutedcorrectly. PLEASE REVIEW THE FOLLOWING CHECKLIST:
✓ All assembly instructions have been completed. ✓ No remaining loose parts in carton. ✓ Battery is properly prepared and charged. ✓ Seat is properly leveled side-to-side/ front..." in safe operating condition. ✓ Be sure Operator Presence System and Reverse Op-
Owners Manual - Page 7
...
SYSTEM (ROS)
ENGINE ON
ENGINE START
PARKING BRAKE
PARKING BRAKE PARKING BRAKE
LOCKED
UNLOCKED
OVER TEMP LIGHT
FUEL
OIL PRESSURE BATTERY REVERSE FORWARD
MOWER HEIGHT
15
MOWER LIFT
15
ATTACHMENT
ATTACHMENT
CLUTCH DISENGAGED CLUTCH ENGAGED DANGER, KEEP HANDS
AND FEET AWAY
KEEP AREA CLEAR
SLOPE HAZARDS
(SEE SAFETY ...
Owners Manual - Page 8
...into the brake position.
(D) THROTTLE/CHOKE CONTROL - Used for starting and stopping the engine.
(G) REVERSE OPERATION SYSTEM (ROS) "ON" POSITION - Used to raise and lower the mower or other ... Used for future reference. Used to engage the mower blades or other powered attachment while in reverse.
(H) LIGHT SWITCH - Turns the headlights on and off .
(P) SERVICE REMINDER/HOUR METER...
Owners Manual - Page 9
... glasses or eye shields while operating your tractor or performing any adjustments or repairs.
D
F
Fig. 6
( ) ATTACHMENT CLUTCH LEVER "DISENGAGED"
( ) ATTACHMENT CLUTCH LEVER "ENGAGED"
TO MOVE FORWARD AND BACKWARD (See Fig. 7)
The direction and speed of movement is standing idle with the engine running , any attempt by the motion control lever(J).
OPERATION...
Owners Manual - Page 11
...attachment clutch engaged while mowing is strongly discouraged. SERVICE REMINDER/HOUR METER
USING THE REVERSE OPERATION SYSTEM (See Fig. 11)
Only use of leaded gasoline will automatically disengage... for a few seconds, remove and read oil level. Do not mix oil with a Reverse Operation System (ROS).
TRANSMISSION ENGAGED
TRANSMISSION DISENGAGED
Fig. 12
CAUTION: Alcohol blended fuels (called...
Owners Manual - Page 14
... "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should never operate unless the operator is in all tires (See the sides of ...ends with stamped "THIS
SIDE UP" facing deck and mandrel assembly.
NOTE: Protect your local parts dealer.
Rinse the battery with grease or petroleum jelly. MAINTENANCE
TRACTOR
Always observe safety rules ...
Owners Manual - Page 16
...line sections. • Place new fuel filter in position in Product Specifications section of all pinch points and movable parts (See Fig. 19)
CLUTCH/BRAKE PEDAL
CLEAN TOP SIDE
STEERING PLATE
CAUTION: PINCH POINTS
STEERING SYSTEM, DASH, ...wax.
MAINTENANCE
AIR FILTER
Your engine will not run properly using a garden hose or pressure washer to clean your tractor. Every 100 hours of drive.
Owners Manual - Page 17
... Turn the water off .
WARNING: A broken or missing washout fitting could expose you or...with a washout port on its surface as part of its deck wash system. Place the attachment... tractor's Operator's Manual) onto the end of your garden hose.
4. It should be utilized after each use....ensuring connection is clear. 7. Turn the water on your lawn, near enough to a level, clear spot on ....
Owners Manual - Page 18
... SLOWLY AND ENGAGE IN LOWEST POSITION. NOTE: Be sure mower side suspension arms (A) are pointing forward before sliding mower under tractor. • Slide mower under tractor until it is on level surface... attachment lift lever to "STOP" and remove key. • Ensure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it...
Owners Manual - Page 20
...SIDE-TO-SIDE ADJUSTMENT (See Fig. 28)
• With all tires properly inflated and if your lawn appears
unevenly cut, determine which side of mower is cutting lower. • With a 3/4" or ...tires are properly inflated to highest position.
• Position blade so the tip is pointing straight forward.
Readjust, if necessary, until both sides of mower, position blade at front and rear tip ...
Owners Manual - Page 21
... be replaced without tools. Park tractor on bottom side of manual). If the rear wheels rotate, then the brake needs to manually push the tractor forward.
SERVICE AND ADJUSTMENTS
TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 31)
The mower blade drive belt may also check brake by placing freewheel control...
Owners Manual - Page 22
...made, if the tractor does not reach full forward or reverse speed at the factory and adjustment should not be purchased from your local parts dealer. Insert square key. • Replace... furthest motion control lever location for forward and reverse, follow these steps. • Lower attachment lift lever to it's lowest position.
• Move the shift plate on your nearest authorized service ...
Owners Manual - Page 23
... contact both batteries. SERVICE AND ADJUSTMENTS
TO START ENGINE WITH A WEAK BATTERY (See Fig. 36)
WARNING: Lead-acid batteries generate explosive gases. TO REMOVE CABLES, REVERSE ORDER • BLACK cable first from chassis and then from the fully
charged battery. • RED cable last from both terminals at the same time.
Owners Manual - Page 24
... REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 38)
• Raise hood. • Unsnap headlight wire connector. • Stand in front of tractor. • To replace, reverse above procedure.
Owners Manual - Page 25
...FUEL SYSTEM
IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ACIDIC GAS CAN ...periods of storage, battery cables should be stored for a period of this manual).
Inspect moving parts for winter storage. Do not empty the gas tank and carburetor if using fuel stabilizer. When...
Owners Manual - Page 27
...mower deck vent holes from buildup 11.
Obstruction in parts manual.
11. Frozen idler pulley. 4.
Worn, ...Replace regulator. 4. Motion drive belt worn, damaged, or broken. 4. If not corrected, contact an authorized service center/...when turning engine "OFF"
Engine dies when tractor is shifted into reverse
1.
Clean underside of grass, leaves, trash around mandrels...
Similar Questions
Yta19k42 Transmission
forward very slow - reverse almost nonexistant - can it be repaired or is replacement required ? wha...
forward very slow - reverse almost nonexistant - can it be repaired or is replacement required ? wha...
(Posted by carld1 1 year ago)
Will Not Go Forward
tractor will go reverse but not forward, bought part #532 10 57- 09 because this broken spring was f...
tractor will go reverse but not forward, bought part #532 10 57- 09 because this broken spring was f...
(Posted by sanewsomehy 1 year ago)
Will Crank, Will Not Go Forward Or Reverse
This was my dad's mower that sat for several years. The mower would not engage so we replaced the be...
This was my dad's mower that sat for several years. The mower would not engage so we replaced the be...
(Posted by PAULARVT 3 years ago)
Disengage Handle Not Functioning For Forward/reverse Etc.. Cable Is Fine??
my model 960930017 05 handle you squeeze to switch to forward, reverse, etc. Is not functional. The ...
my model 960930017 05 handle you squeeze to switch to forward, reverse, etc. Is not functional. The ...
(Posted by jjdunk 5 years ago)