Husqvarna HU775H Support Question
Husqvarna HU775H Support Question
Find answers below for this question about Husqvarna HU775H.Need a Husqvarna HU775H manual? We have 2 online manuals for this item!
Question posted by jeffkillough on July 6th, 2015
Self Propelled Function Will No Longer Engage
The drive cable has either broken or became disconnected from the clutch lever. Whenever I pull in the left and right drive cable levers on the handlebar they pull in without any tension now even after being adjusted with the nut on the cable and will not engage the selp propelled function on the lawnmower. Can someone please email me a procedure for performing this repair myself ?
Current Answers
Answer #1: Posted by TommyKervz on July 6th, 2015 9:42 AM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,803
Member since:
January 10th, 2013 Points: 17,776,803
Click here for Self Propelled troubleshoot tips
Related Husqvarna HU775H Manual Pages
Owners Manual - Page 2
... pull mower backwards...adjusting or making repairs.
• Do not operate the mower...disconnect spark plug wire and place wire where it . Always be picked up and down and behind power lawn mowers...mowers so equipped before mowing. To avoid severe burns on wet grass. Exer- The operator could cause slipping.
2
never run.
• Disengage the self-propelled mechanism or drive clutch...
Owners Manual - Page 3
...accidental starting.
• Keep nuts and bolts, especially blade ...Disconnect spark plug wire, and keep equipment in handling gasoline.
Children are subject to wear, damage, and deterioration, which could expose moving parts or allow children to make adjustments or repairs with an internal combustion engine and should be thrown. A spark arrester for and using your lawn mower...
Owners Manual - Page 4
... ensure safe and proper operation of those parts left unassembled for a few minutes.
Make sure the frame handle is outside of various controls and adjustments. Learn and understand their meaning.
Use the correct tools as nuts, washers, bolts, etc., necessary to assemble or operate your lawn mower, all parts have been placed in warm water...
Owners Manual - Page 5
... around control bar. Upper handle 3. Bolt 3. Repeat for opposite side of this manual. Refer to "TO ADJUST HANDLE" in the Service and Adjustments section of handle.
4. Lower handle
2
1
3
Figure 4 1. ASSEMBLY
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be adjusted for your mowing comfort. Cut down flat.
3. Handle knob 4. Handle bracket
5 TO REMOVE...
Owners Manual - Page 7
...a drive control lever only. Self-propelling is controlled by holding the operator presence control bar down against handle to the handle and pulling either the operator presence control bar or a drive control lever are released. The further toward the handle a lever is worn and should be replaced.
1
2 1
TO ENGAGE DRIVE CONTROL
Figure 6
1. Drive control levers
DRIVE CONTROL ADJUSTMENT
Over...
Owners Manual - Page 8
... the lawn mower and place the grass
catcher frame hooks onto the grass bag brackets (Figure 10). 2. Figure 10
1. Handle bracket holes
8 OPERATION
TO ADJUST CUTTING HEIGHT
All four wheels are adjusted by a single lever.
1. To convert to mulching operation, remove grass catcher and close rear door. Grass bag bracket 4. Grass catcher frame hook 2. Pull adjuster lever toward...
Owners Manual - Page 9
... (Figure 13).
Mulcher door 2. Rear door closed and locked.
1
1. Grass catcher installed. 2. Mulcher door closed . 2.
Latch
Figure 12
2.
SIMPLE STEPS TO REMEMBER WHEN CONVERTING YOUR LAWN MOWER:
FOR MULCHING 1. Discharge deflector installed.
9 FOR REAR BAGGING 1. Rear door closed and locked. Figure 14
1
2
Figure 13 1. Discharge deflector
CAUTION: Do not run your...
Owners Manual - Page 11
... lawn mower handle.
3. To prevent this, regularly hose catcher off with an automatic choke system. No priming or choking is left on the right side of a rear discharge mower,...pull starter handle quickly.
Bag handle 2. OPERATION
TO START ENGINE
NOTE: Due to protective coatings on the engine, a small amount of smoke may also be necessary to reduce ground speed and/or run the lawn mower...
Owners Manual - Page 12
... require that an area be necessary to raise the height of the blades. • Avoid cutting your lawn is wet. At this will be mulched a second time to week. The best time to west the...disperse into the grass and not be exposed to direct sunlight. • For best results, adjust the lawn mower cutting height so that as this time the grass has dried, yet the newly cut area ...
Owners Manual - Page 13
...
* (if so equipped)
** Electric-Start mowers
*** Power-Propelled mowers
****
Use a scraper to properly maintain your engine run better and last longer. • Follow the maintenance schedule in this lawn mower does not cover items that have been subjected to see if you should make any of the adjustments described in the Service and Adjustments section of this manual.
Owners Manual - Page 14
...the manufacturer of wood between blade and mower housing to work properly. Turn lawn mower on the engine crankshaft. Remove blade and...
Figure 20
1.
BLADE CARE
For best results, mower blade must be sure they move freely. Disconnect spark plug wire from turning when removing blade bolt...mower. DRIVE WHEELS
Check rear drive wheels each time you mow to be cleaned out to clean drive ...
Owners Manual - Page 15
...the factory. If blade is not used .
• Check your drive system working properly, the gear case and area around the drive should remain in cold weather, and you check the oil level.
...level frequently to the proper level at least once a year if the lawn mower is balanced, it will cause eventual damage to lawn mower or engine. • The blade can be kept clean and free of...
Owners Manual - Page 16
... the pre-cleaner and the filter.
3. Wash the pre-cleaner in the base.
7. Base 5. Tip lawn mower on its side as kerosene, are not to be washed and reused.
1. Wait a minute to allow... oil trapped inside of engine.
5. Service air cleaner more often under dusty conditions. Disconnect spark plug wire from lawn mower or side of engine (Figure 23).
4. CAUTION: Petroleum solvents, such as shown ...
Owners Manual - Page 17
... fuel line sections (Figure 25).
2. WATER WASHOUT FEATURE
Your lawn mower is required.
1. CLEAN THE UNDERSIDE OF YOUR MOWER AFTER EACH USE. WARNING: Do not engage the drive system during the washout process.
2. If fuel filter becomes clogged, obstructing fuel flow to remove excess water from mower.
1
CAUTION: Disconnect spark plug wire from fitting.
Clamp 2. CAUTION: Do...
Owners Manual - Page 18
... shield 12. Disconnect spark plug wire from mower.
4.
Lock washer
5. Gearcase belt keeper
18 Place rear baffle in the Operation section of your mower, is provided to assure proper fit and long life.
2. Blade bolt
6. Belt retainer
7. LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in mower housing.
5. Be sure the new drive belt is inside...
Owners Manual - Page 19
...). 2. Bolt 3. If you believe that suits you. 1. If your engine does not operate properly due to suspected carburetor problems, take your lawn mower to an authorized service center for repair and adjustment. IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. Knob 2.
IF YOU THINK THE ENGINE...
Owners Manual - Page 20
...CABLES.
3 4
Figure 29 1. Upper handle 3. Bolt 3. STORAGE
Immediately prepare your mower for storage at the end of the season or if the unit will require manually locking into the mowing position. Clean entire lawn mower... POSITION
2
HANDLE
You can fold your lawn mower handle for damage, breakage and wear. NOTE: When setting up all nuts, bolts, screws, and pins are securely fastened.
Owners Manual - Page 21
Do not empty the gas tank and carburetor if using fuel stabilizer.
Pull starter handle slowly a few times to reach the carburetor. Replace with...to give
protection from one ounce (29 ml) of fuel gum deposits during storage. CAUTION: Never store the lawn mower with a suitable protective cover that
does not retain moisture. Remove spark plug. 2. STORAGE
ENGINE
FUEL SYSTEM
IMPORTANT:...
Parts List - Page 3
...
DESCRIPTION
Spring, Torsion Nut, Hex Kit, Lawn Mower Housing Rod, Hinge ...Cable Belt Keeper Front Shroud Assembly Operator's Manual, English / French Operator's Manual, Spanish
3
NOTE: All component dimensions given in U.S. HU775H (96145001000) PRODUCT NO. 961 45 00-10
KEY PART NO. IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. HUSQVARNA ROTARY LAWN MOWER...
Parts List - Page 5
... Assembly Knob, Wheel Adjuster Debris Shield Anchor Wheel Axle Assembly, LH Bracket, Height Adjustment Mounting Bracket, Debris Shield Belt Keeper E-Ring 7/16 Cover, Dust, Wheel Screw, Hex Head Pawl, Drive Wheel & Tire Assembly, Rear Nut, Flangelock 3/8-16
KEY PART NO. HU775H (96145001000) PRODUCT NO. 961 45 00-10
KEY PART NO. MODEL NO. HUSQVARNA ROTARY LAWN MOWER -
Similar Questions
Front Wheels Lower Than Rear, No Adjustment On Hu775h Self Propeller 22" Mowe
how do you adjust the stagger (front to back) on a Husqvarna hu775h 22" self propeller lawn mower, w...
how do you adjust the stagger (front to back) on a Husqvarna hu775h 22" self propeller lawn mower, w...
(Posted by Zieglerattorney47841 6 months ago)
The Self Propelled Feature Is Not Working
Do I need to turn the cable up or down to tighten the cable that is attached to the handle to make t...
Do I need to turn the cable up or down to tighten the cable that is attached to the handle to make t...
(Posted by loujstein 1 year ago)
Self Propelled Drives Slow
the self propelled drives slow already replaced the belt but still driving slow just didn't know if ...
the self propelled drives slow already replaced the belt but still driving slow just didn't know if ...
(Posted by brianscroggins13 7 years ago)
