Husqvarna HU775H Support Question
Husqvarna HU775H Support Question
Find answers below for this question about Husqvarna HU775H.Need a Husqvarna HU775H manual? We have 2 online manuals for this item!
Question posted by jbulette on June 29th, 2014
How To Start My Lawn Mower Hu775h
The person who posted this question about this Husqvarna product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Husqvarna HU775H Manual Pages
Owners Manual - Page 2
... Operation Practices for this symbol to slip and fall accidents which could be sure of the machine before starting when setting up and down and behind power lawn mowers conform to cause cancer and birth defects or other engine parts become
• Always wear safety goggles or safety glasses with side shields when...
Owners Manual - Page 3
... behind and down for small children.
• Never allow children to prevent accidental starting.
• Keep nuts and bolts, especially blade attachement bolts, tight and keep ...-SL):
SAE 30 (above 0°C/32°F); Never assume that may obscure vision. WARNING: This lawn mower is running.
• Grass catcher components are explosive.
• Extinguish all cigarettes, cigars, pipes and...
Owners Manual - Page 4
.... Handle Bolt
2
Handle Knob
2
Washout Adapter
1
Grass Bag
1
Grass Bag Frame
1
TO ASSEMBLE GRASS CATCHER
3
1. Vinyl bindings
for shipping purposes. Compare the illustrations with your lawn mower or in warm water
1
Figure 2 1. These symbols may appear on the bottom. Description
Qty.
Frame opening
4
Slip vinyl bindings over frame. Use the correct tools...
Owners Manual - Page 5
... HANDLE" in the Service and Adjustments section of this manual. Refer to upper handle.
4. Handle knob 4. Operator presence control bar 2. ASSEMBLY
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to operating position and align hole in handle with one of three height positioning holes (Figure 3).
2. Raise lower handle section to be...
Owners Manual - Page 7
... disconnect spark plug wire from plug. 2. Operate mower to increase drive
speed (Figure 8). 3. If condition fails to start and operate the mower. Always wear safety glasses or eye shields while operating...operator presence control bar down to increase tension on this lawn mower in severe eye damage.
IMPORTANT: This lawn mower is controlled by holding the operator presence control bar ...
Owners Manual - Page 8
... rear door of the clipping deflector and secure it will rest on the top of the lawn mower and place the grass
catcher frame hooks onto the grass bag brackets (Figure 10). 2.... door 2. Deflector bar "leg" 3. Grass catcher frame hook 2. Wheel adjuster lever
TO CONVERT MOWER
Your lawn mower was shipped ready to mulching or bagging operation, clipping deflector must be used as shown (Figure ...
Owners Manual - Page 9
...in place. OPERATION
3. Mulcher door 2. Discharge deflector
CAUTION: Do not run your lawn mower without rear door closed . 2. Mower is now ready for side discharging operation (Figure 14). FOR REAR BAGGING 1. Unlock... latch (Figure 12). NOTE: To convert to operate the lawn mower with the rear door removed or propped open. Mulcher door closed . 1. Grass catcher...
Owners Manual - Page 11
...starting. 1. Starter handle
TO EMPTY GRASS CATCHER
1. Remove grass catcher with use and catchers will damage your mower and could void your mower.
It may also be necessary to reduce ground speed and/or run the lawn mower...less grass. Bag handle 2. NOTE: Your engine is required before using a rear discharge lawn mower in moist, heavy grass, clumps of cut path and mow slowly.
• For ...
Owners Manual - Page 12
... this will disperse into the grass and not be mulched a second time to south one -third of grass and grass conditions may require that the lawn mower cuts off only the top one week then east to the first cut path and mow slowly. OPERATION
MULCHING MOWING TIPS
IMPORTANT: FOR BEST PERFORMANCE...
Owners Manual - Page 13
.... 5 - MAINTENANCE
Check for Loose Fasteners Clean / Inspect Grass Catcher * Check Tires Check Drive Wheels *** Clean Lawn Mower **** Clean under Drive Cover *** Check Drive Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean and...(if so equipped)
** Electric-Start mowers
*** Power-Propelled mowers
****
Use a scraper to clean under a heavy load or in sandy soil. 4 -
Owners Manual - Page 14
...are up toward the engine.
5. Position blade on the engine crankshaft. MAINTENANCE
LAWN MOWER
Always observe safety rules when performing any maintenance. DRIVE WHEELS
Check rear drive...trash, grass cuttings, etc., may cause tire damage. Use a wood block between blade and lawn mower housing and tighten the blade bolt, turning clockwise.
• The recommended tightening torque is up...
Owners Manual - Page 15
... grinding
wheel. If catcher needs replacing, replace only with API service classification SG-SL. Give the lawn mower model number when ordering. GEAR CASE
• To keep your grass catcher often for damage or ...deterioration. NOTE: Multi-viscosity oils (5W30, 10W30 etc.) improve starting the engine and after every 25 hours of the steel bolt or pin and hold the...
Owners Manual - Page 16
...-cleaner
Figure 24
16 MAINTENANCE
TO CHANGE ENGINE OIL
NOTE: Before tipping lawn mower to remove any spilled oil from lawn mower or side of engine.
5. Stop adding oil when you reach the ...the filter is tight.
1 2
1 2
Figure 23
1. Then allow oil to retighten oil dipstick before starting engine.
9. CAUTION: Petroleum solvents, such as shown and drain oil into the base. They may cause...
Owners Manual - Page 17
... type and gap setting are present, start engine (as described in the Operation section of operation, whichever occurs first. WATER WASHOUT FEATURE
Your lawn mower is running. Remove grass catcher and ...cleaning of the underside of grass and trash.
• Clean engine often to clean lawn mower unless the electrical system, muffler, air filter and carburetor are properly positioned.
4. ...
Owners Manual - Page 18
... are aligned, and that objects will be replaced. Hardened
2. Release control bar and stop engine. 2. Disconnect spark plug wire from mower.
4. LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in mower housing.
5.
TO REMOVE DRIVE BELT
1. Remove rear baffle from spark plug
and place where it should be thrown out of...
Owners Manual - Page 19
... GOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. Remove knob and carriage bolt on your lawn mower has three (3) height positions - Do not attempt to an authorized service center for repair and ...19 Knob 2. CARBURETOR
Your carburetor is running too fast or too slow, take your lawn mower to height that suits you believe that the engine is not adjustable. adjust to an ...
Owners Manual - Page 21
... CAUTION: Never store the lawn mower with new spark plug. OTHER
• Do not store gasoline from dust and dirt. • Cover your can starts to rust. IMPORTANT: NEVER COVER MOWER WHILE ENGINE AND EXHAUST AREAS...FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE. • Empty the fuel tank by starting the engine and letting
it to cool before storing in
the fuel tank or permanent damage may ...
Owners Manual - Page 22
... grass.
2. Tighten blade bolt or replace blade adapter.
8. Replace Fuse. Buildup of lawn mower housing or cutting
blade dragging in released position.
8. uneven
1. Bent engine crankshaft.
1....loose blade. 2. Rear of grass, leaves and trash under
mower.
1. TROUBLESHOOTING POINTS
PROBLEM
CAUSE
CORRECTION
Does not start
1. Loss of drive speed)
1.
Cutting height too low...
Parts List - Page 3
...532 43 73-89 - - 115 53 96-49 - - 115 53 96-31
DESCRIPTION
Spring, Torsion Nut, Hex Kit, Lawn Mower Housing Rod, Hinge Blade Adapter Blade, 22" Washer, Hardened Washer, Helical Screw, Machine, Hex Head 3/8-24 x 1-3/8 Grade.../ French Operator's Manual, Spanish
3
NOTE: All component dimensions given in U.S. HU775H (96145001000) PRODUCT NO. 961 45 00-10
KEY PART NO. inches. 1 inch = 25.4 mm.
Parts List - Page 5
HUSQVARNA ROTARY LAWN MOWER - HU775H (96145001000) PRODUCT NO. 961 45 00-10
KEY PART NO. NO.
1 532 43 09-95
9 532 43 16-50 10 532 43 27-90 11 ... Wheel Screw, Hex Head Pawl, Drive Wheel & Tire Assembly, Rear Nut, Flangelock 3/8-16
KEY PART NO. Failure to do so could be hazardous, damage your lawn mower and void your warranty. NO.
34 532 19 74-80 35 532 43 05-98 36 532 44 71-89 37 532 16 34-09...
Similar Questions
How To Change Battery On Hu675fe Electric Start Walking Mower
(Posted by dabepeterson 3 years ago)
I Can't Pull The Rope To Start My Mower. I Have A Husqvarna 775ex Walk Behind.
(Posted by Anonymous-150916 9 years ago)
How To Adjust The Speed Of A Husqvarna Lawn Mower Model Hu775h
(Posted by Bdbi 9 years ago)