Husqvarna GT54LS Support Question
Husqvarna GT54LS Support Question
Find answers below for this question about Husqvarna GT54LS.Need a Husqvarna GT54LS manual? We have 1 online manual for this item!
Question posted by lesliehmd on February 8th, 2015
In My Manual, There Is No Related Diagram On Page 16. There Are Written
instructions which refer to the choke position, but no details of where that position is. That page refers to figure 16 which is on page 11, however that diagram just labels the parts, so it points to the THROTTLE/CHOKE CONTROL with no further specifications about the choke position. This is so frustrating. Thank you for trying to help. It's not in the manual. If you know the position, please let me know.
Current Answers
Answer #1: Posted by Autodiy on February 8th, 2015 8:32 PM
Autodiy
Member since:
May 23rd, 2014 Points: 815,136
Member since:
May 23rd, 2014 Points: 815,136
Related Husqvarna GT54LS Manual Pages
Owners Manual - Page 2
...recommended by and comply with the instructions, to a complete stop engine, ...parts or under the influence of bystanders before operating. WARNING: Do not coast down slopes, not across. • Watch for traffic when operating near drop-offs, ditches, or embankments. WARNING
Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to loss of control...
Owners Manual - Page 3
... age before operating a pedestrian controlled lawn mower and a minimum of 16 years of a responsible adult...container opening at the hitch
point.
• Follow the manufacturer....
• Maintain or replace safety and instruction labels, as on a slope.
GENERAL SERVICE •...parts, when necessary.
• Mower blades are sharp. Allow machine to cool before operating a riding lawn...
Owners Manual - Page 4
...: 60 Oz./1,77 L
Champion QC12YC (Gap: .040"/1.02 mm)
16 Amps @3600 RPM
Amp/Hr: Min. CCA: Case size:
28 230.... Federal laws apply on your tractor. • Follow the instructions in effective working order by law (Section 4442 of the California...nearest authorized service center/department.
Please read and retain this manual. It has been designed, engineered and manufactured to assemble ...
Owners Manual - Page 5
Washers
(2) Rear Lift Link Assemblies
(1) Small Retainer Springs
(5) Large Retainer Springs
(1) Front Lift Link Assembly
(1) Shoulder Bolt
(1) 1-1/4 O.D. Washer
(1) Wheel
(1) 3/8-16 Locknut
If Equipped
(1) Anti-Sway Bar
(1) 3/4 O.D. Washers
(1) Small Retainer Springs
*Installed by Dealer
*Brush Guard Kit
Keys
(1) Oil Drain Tube
Slope Sheet
*Pedal
(2) Keys
(1) Quick ...
Owners Manual - Page 6
... the factory with the instructions that follow to lock seat in lowest position. Have a tight grip on label (label is reached which allows you to its highest position.
• Release parking brake by depressing clutch/brake pedal.
• Place freewheel control in "TRANSMISSION DISENGAGED" position. (See "TO TRANSPORT" in the Operation section of this manual.)
• Roll tractor...
Owners Manual - Page 7
...3/8-16 LOCKNUT
Fig. 5
3. NOTE: Be sure mower side suspension arms (A) are pointing forward before sliding mower under tractor. • Slide mower under tractor until it will go and position ... LIFT LINK(S) D. LOCKING BRACKET M. INSTALL ANTI-SWAY BAR (S) (IF EQUIPPED) (See Fig. 9 - 11)
ANTI-SWAY BAR (S)
TOWARDS TRANSAXLE
TOWARDS MOWER DECK
90° END
INTEGRATED WASHER END
Fig. 9
•...
Owners Manual - Page 9
....
CHECK FOR PROPER POSITION OF ALL BELTS
See the figures that all connections are still secure and wires are routed properly around pulleys and inside all controls, their location and functions. Follow proper starting and transmission purging instructions. (See "TO START ENGINE" and "PURGE TRANSMISSION" in the Operation section of this manual. CHECK DECK LEVELNESS...
Owners Manual - Page 11
...Locks clutch/brake pedal into the brake position.
(D) THROTTLE/CHOKE CONTROL - Used for forward movement of various controls and adjustments. Disengages transmission for pushing or...battery.
11 H
P
D
Z
S
G
Y
E
B A M
Q C
F
K J
L
Fig. 16
Our tractors conform to set forward movement of mower or other attachments mounted to your tractor.
(B) BRAKE PEDAL - Save this manual for ...
Owners Manual - Page 13
... cutting height in desired height of grass being mowed. • The average lawn should be assembled so they are measured from hesitating or cutting off when operating...position of manual). • With mower in operating position. The cutting height range is equipped with the engine not running and the attachment clutch engaged will shut off the ground.
Do not use the cruise control...
Owners Manual - Page 14
... is not running , turn the ignition switch to disengage transmission by placing freewheel control in the disengaged position.
• Do not push or tow tractor at the rear drawbar of hours...; and do not drive across any position but "STOP". TO TRANSPORT (See Figs. 16 & 24)
When pushing or towing your tractor on for 2 hours or until a manual reset occurs. SERVICE REMINDER/HOUR METER
...
Owners Manual - Page 15
... from side to the "ON" position. TO USE DIFFERENTIAL LOCK CONTROL (Y) (See Fig. 26)
...let it run until "FULL" mark on stabilizer container. See Storage Instructions for an available charger. Add stabilizer to the system. Do not overfill...filler neck. Purchase fuel in this manual.
15
Acidic gas can be used within 30 days to the "OFF" position. To avoid engine problems, the fuel...
Owners Manual - Page 16
...to the engine.
• Be sure freewheel control is on the
temperature.
16 After the engine is clear and open - ...throttle control to choke position. NOTE: Before starting, read the warm and cold starting the engine for five (5) seconds and release pedal. Sitting in the tractor seat, start engine. throttle control in cold weather, the transmission
should be movement of manual...
Owners Manual - Page 17
... and more uniform cutting. • When mowing large areas, start by selecting a low enough gear to ensure better mowing performance and proper discharge of this manual.
• The left hand turns until finished (See Fig. 28). Allow grass to dry before mowing. • Always operate engine at full...
Owners Manual - Page 18
...in this manual.
•...: DO NOT OIL OR GREASE THE PIVOT POINTS WHICH HAVE SPECIAL NYLON BEARINGS.
A new ... Check for loose fasteners.
➀ General Purpose Grease ➁ Refer to operator abuse or negligence. Not required if equipped with oil ...receive full value from the warranty, operator must maintain tractor as instructed in high ambient temperatures. 2 -
At least once a season,...
Owners Manual - Page 19
...control chemicals which is engaged, any maintenance. If your tractor is maintenance free. BLADE REMOVAL (See Fig. 30)
• Raise mower to highest position...position. ROS "ON" POSITION
ENGINE "ON" POSITION... "ON" position and the ...section of this manual.)
TIRES
•...clutch control is...the ROS "ON" position and the attachment clutch...manual.)
19 BLADE CARE
For best results mower blades must ...
Owners Manual - Page 21
..." section of this manual. CLAMP
FUEL FILTER
...pinch points and movable parts....garden hose or pressure washer to keep water out. Except for the washout port (if equipped), we do not recommend using a dirty air filter.
MAINTENANCE
CLEAN AIR SCREEN
The air screen is required.
• With engine cool, remove filter and plug fuel line sections.
• Place new fuel filter in position...
Owners Manual - Page 22
... tractor's discharge chute is in the operator's position on your lawn, near enough to turn the tractor's engine off .
9.
Move the tractor's attachment clutch control to the "ENGAGED" position. Turn the ignition key to the STOP position to a water spigot for your garden hose.
4. Place the attachment clutch control in the area while cleaning the deck.
7. Move...
Owners Manual - Page 24
...lower than the
rear tip, go to the front of tractor. • With an 11/16" or adjustable wrench, loosen jam nut
A several turns to clear adjustment nut B. &#...Visual Adjustment instructions above.
• Recheck measurements, adjust if necessary until you to 1/2" lower than the rear tip when the mower is pointing straight ...lawn and lead you are properly inflated to its highest position.
Owners Manual - Page 27
...this manual.
27 If adjustment is necessary, see engine manual.
If adjustment is necessary, see engine manual. Grasp hood at sides, tilt toward engine and lift off of tractor. TO ADJUST CHOKE CONTROL
The choke control has ..., reverse above procedure.
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and adjustment should be necessary.
Owners Manual - Page 34
...from abuse or neglect of the product related to or including any adverse reaction due ...listed in the Husqvarna oil label and covered in your operator's manual.
(h) Use of ether ...responsibility (at www.husqvarna.com.
11. Authorized Husqvarna Servicing Dealer/Center. NOTE...In addition, this Husqvarna warranty. mechanical components/parts such as prescribed in Husqvarna products. If...
Similar Questions
Troubleshoot Auger Cable
Motor runs fine. Auger won't turn. Not shear bolts. Not belt. What else could it be but the cable? C...
Motor runs fine. Auger won't turn. Not shear bolts. Not belt. What else could it be but the cable? C...
(Posted by rbrtdinnen 5 months ago)
Deck Height
I just bought a new YTH22V46 but using it for the first time the deck height isn't right if I put it...
I just bought a new YTH22V46 but using it for the first time the deck height isn't right if I put it...
(Posted by lausterer57 9 months ago)
Fuel Line Routing Diagram
How are fuel lines routed from carburator and primer bulb on husqvarna 326 LS? Also how is throttle ...
How are fuel lines routed from carburator and primer bulb on husqvarna 326 LS? Also how is throttle ...
(Posted by tkinard54 2 years ago)
Shear Pins - Need Help With Sizes
are there 2 types/ sizes of shear pins, i ordered some from amazon, and i snapped a shear pin, when ...
are there 2 types/ sizes of shear pins, i ordered some from amazon, and i snapped a shear pin, when ...
(Posted by melissa10 3 years ago)
Where Is The Choke Position On The Husqvarna Gt54ls?
Where is the choke position on the GT54LS? It is not marked on the tractor, and there is no diagram ...
Where is the choke position on the GT54LS? It is not marked on the tractor, and there is no diagram ...
(Posted by lesliehmd 9 years ago)