Husqvarna 326LS Support Question
Husqvarna 326LS Support Question
Find answers below for this question about Husqvarna 326LS.Need a Husqvarna 326LS manual? We have 1 online manual for this item!
Question posted by tkinard54 on August 9th, 2021
Fuel Line Routing Diagram
How are fuel lines routed from carburator and primer bulb on husqvarna 326 LS? Also how is throttle cable routed to carburator?
Current Answers
Answer #1: Posted by Troubleshooter101 on August 9th, 2021 6:39 PM
Troubleshooter101
Member since:
September 30th, 2015 Points: 2,927,030
Member since:
September 30th, 2015 Points: 2,927,030
Please check this link below:-
https://www.fixya.com/support/t25170029-replace_fuel_lines_326rj
https://pnab.seleus.pl/husqvarna-326l-fuel-line-diagram.html
Thanks
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Troublshooter101
Answer #2: Posted by SonuKumar on August 9th, 2021 11:33 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,621,300
Member since:
May 9th, 2021 Points: 16,621,300
https://www.youtube.com/watch?v=ZQdjazRjixc
https://www.youtube.com/watch?v=ZQdjazRjixc&t=170s
https://www.youtube.com/watch?v=ZQdjazRjixc&t=336s
https://www.youtube.com/watch?v=ZQdjazRjixc&t=604s
https://www.youtube.com/watch?v=JmQ372o-w0o
https://www.searspartsdirect.com/model/5b284gisev-003199/husqvarna-326l-gas-line-trimmer-parts
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Husqvarna 326LS Manual Pages
Owners Manual - Page 1
Operator's manual (EPA)
326C 326L 326LS
326LX-series
326LDX-series
Please read the operator's manual carefully and make sure you understand the instructions before using the machine.
English
Owners Manual - Page 3
... a trimmer guard and Superauto II 1" trimmer head 11 Fitting other guards and cutting attachments 11 Fitting the trimmer guard and trimmer head 11 FUEL HANDLING Fuel safety 12 Fuel 12 Fueling 13 STARTING AND STOPPING Check before starting 14 Starting and stopping 14 WORKING TECHNIQUES General working instructions 16 MAINTENANCE Carburetor 18 Muffl...
Owners Manual - Page 4
In 1956, the first motor driven lawn mowers appeared, followed by chain saws in the world of forest and garden products, with quality as a valuable document. If... Karl XI ordered the construction of muskets. Today Husqvarna is working today. We develop, manufacture and market high quality motor driven products for forestry and gardening as well as for production of a factory on...
Owners Manual - Page 5
What is what?
1 Trimmer head 2 Grease filler cap, bevel gear 3 Bevel gear 4 Cutting attachment guard 5 Shaft 6 Loop handle 7 Throttle control 8 Stop switch 9 Throttle lockout 10 Cylinder cover 11 Starter handle 12 Fuel tank
13 Choke control 14 Air purge 15 Air filter cover 16 Handle adjustment 17 Shaft coupling 18 Operator's manual...
Owners Manual - Page 9
... trimmer head is used to the instructions for a couple of the cutting attachment. The nylon lining inside of the cord it . Avoid
contact with catalytic
! To remove it lasts longer....;tting, tighten the nut in the opposite direction to rotate even after the
throttle has been released. The lining should be cleaned regularly. GENERAL SAFETY PRECAUTIONS
If the muffler on ...
Owners Manual - Page 10
... least 3 times).
• Clip the loop handle onto the shaft. B A
10 - Fitting the loop handle
(326L, 326LS, 326Lx, 326LDx)
Dismantling:
• Loosen the coupling by turning the knob. • Align the tab of the ...between the arrows on the drive disc/support flange engages
correctly in the diagram.
• Tighten the wing nut. Note that the handle must be mounted below the ...
Owners Manual - Page 11
... them together, with the cut -outs in the diagram.
G
K
F
I
B
J
C
I ) while grasping the cover with your other guards and cutting attachments
(326L, 326LS, 326Lx, 326LDx)
L
K
• Fit the... in the reverse order.
ASSEMBLY
Fitting a trimmer guard and Superauto II 1" trimmer head
(326L, 326LS, 326Lx, 326LDx)
Fitting other hand, release the two catches (J) that engage in the...
Owners Manual - Page 12
...((RON+MON)/2). Fuel and fuel fumes are highly
! English Wash any leakage or fumes coming into contact with sparks or naked flames, for example, from the fuel cap and fuel lines.
WARNING!
Two.... Transport and storage
• Store and transport the machine and fuel so that has come in contact with HUSQVARNA two-stroke oil. For this purpose.
• When storing the...
Owners Manual - Page 13
.... English - 13
This also
applies during and after refuelling. Taking the following precautions,
! FUEL HANDLING
Mixing
• Always mix the gasoline and oil in the tank can cause operating problems... Ensure that any excess pressure is not used for some time the fuel tank should be used.
Tighten the fuel cap carefully after use. Always move the machine away from the refuelling...
Owners Manual - Page 14
...started with your hand
Repeat pulling the cord until fuel begins to being tightened too much. English shaft must...a guard nor with your left hand (CAUTION! WARNING!
Starting
Primer bulb: Press the air purge repeatedly until the engine starts. Replace...ange is exposed to run position and apply full throttle;
the throttle will start setting.
14 - STARTING AND STOPPING
...
Owners Manual - Page 17
...contact with the ground during normal cutting. Let the end of the rotating cord can ruin the lawn and damage the tool.
• Do not allow the trimmer head to constantly come into contact...ideal for quick and easy clearing up against stones, brick, concrete, metal fences, etc., than full throttle so that does the work at an angle. English - 17 WORKING TECHNIQUES
Grass trimming with a ...
Owners Manual - Page 18
...; The setting of fuel to match the rate that the engine is controlled with the throttle. The basic setting is...fuel). Basic setting
• The basic carburetor settings are mixed in the carburetor. Do not use . To ensure that reduce harmful emissions. shaft must be fitted before the machine is dirty it anti-clockwise gives a lower idle speed. MAINTENANCE
Carburetor
Your Husqvarna...
Owners Manual - Page 19
...H very slowly clockwise until the engine runs smoothly. This is too lean. Apply full throttle and turn the high speed jet H very slowly anticlockwise until the cutting attachment starts to .... High speed jet H
The high speed jet H affects the engine power, speed, temperature and fuel consumption. If the screen is fitted with a special spark arrestor screen. The exhaust gases are...
Owners Manual - Page 20
...refitting it clean in fluenced by:
• Incorrect carburetor adjustment.
• An incorrect fuel mixture (too much or incorrect type of : 1 Air intake on the starter. 2 Fins on the &#...piston/cylinder. Use of engine power • Unnecessary wear to engine parts • Excessive fuel consumption. See instructions under the heading Oiling the air filter.
Wash it . There ...
Owners Manual - Page 21
... oil. You should check that the bevel gear is filled with grease. Bevel gear
(326L, 326LS, 326Lx, 326LDx)
The bevel gear is filled three-quarters full with the right quantity... of accessories and/or attachments not specifically recommended by HUSQVARNA.
Your warranty does not cover damage or liability caused by the use of grease at the...
Owners Manual - Page 22
... stop switch works correctly. Check that the guard is cracked.
Check all cables and connections.
Most of the maintenance that the spark plug is filled three-quarters ... the fuel filter from contamination and the fuel hose from carbon deposits.
English
X
Make sure the throttle trigger lock and the throttle function correctly from the engine, tank or fuel lines. X...
Owners Manual - Page 23
... 6Y Champion RCJ 6Y
Electrode gap, inch/mm
0,02/0,5
0,02/0,5
0,02/0,5
0,02/0,5
Fuel and lubrication system
Manufacturer/type of output shaft, rpm
11700
8014
8014
8014
Max. speed, left... English - 23 The table indicates the highest and lowest values. TECHNICAL DATA
Technical data
326C
326L/326LS
326Lx
326LDx
Engine Cylinder displacement, cu.in/cm3
1,50/24,5
1,50/24,5
1,50/24...
Owners Manual - Page 24
... been evaluated by Underwriters Laboratories Inc. (UL) and are recommended for the Husqvarna 125LD trimmer, but can also be used in combination with the specified...model 326C
Accessories Blade shaft thread 3/8 R Plastic blades
Trimmer head
Arbor shaft thread M10 Plastic blades
326L, 326LS, 326Lx, 326LDx Trimmer head
326LDx
Shaft
Type
Tricut Ø 230 mm (R) Trimmy Hit Junior (R) ...
Owners Manual - Page 25
... under the warranty is delivered to the effect of "repair or replace as the carburetor, ignition system, catalytic converter, fuel tank, filters and other engine components proximately caused by Husqvarna Forest & Garden at no abuse, neglect or improper maintenance of warranty coverage, it will be warranted for diagnostic labor that leads to...
Owners Manual - Page 26
... OF EMISSION-RELATED PARTS
Any replacement part may be provided without charge to the owner. Such use will not reduce the warranty obligations of all Husqvarna Forest & Garden authorized servicing dealers. FEDERAL AND CALIFORNIA EMISSIONS CONTROL WARRANTY STATEMENT
HOW TO FILE A CLAIM
If you have any warranty maintenance or repairs and must...
Similar Questions
How Do You Replace The Trigger Spring On A 326ls Weed Eater
Repairs
Repairs
(Posted by robertwatsonjr1955 2 years ago)
How To Replace The Throttle Recoil Spring On Husqvarna 326ls
(Posted by Anonymous-168781 2 years ago)
Husqvarna 323l Fuel Line Routing
I replaced the fuel lines on my husqvarna 323L and not sure if I routed the fuel lines correctly. Ca...
I replaced the fuel lines on my husqvarna 323L and not sure if I routed the fuel lines correctly. Ca...
(Posted by higad016 5 years ago)
