Husqvarna 326LS Support Question
Husqvarna 326LS Support Question
Find answers below for this question about Husqvarna 326LS.Need a Husqvarna 326LS manual? We have 1 online manual for this item!
Question posted by robertwatsonjr1955 on October 4th, 2021
How Do You Replace The Trigger Spring On A 326ls Weed Eater
Repairs
Current Answers
Answer #1: Posted by SonuKumar on October 5th, 2021 1:09 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,609,790
Member since:
May 9th, 2021 Points: 16,609,790
https://www.youtube.com/watch?v=CcK6JUvE-yE
https://www.youtube.com/watch?v=WTn0XqnrQbY
https://randysengine.repair/products/throttle-trigger-spring-husqvarna-trimmer-537011301
https://www.ebay.com/b/Husqvarna-Spring-String-Trimmer-Parts/71278/bn_7773498
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Husqvarna 326LS Manual Pages
Owners Manual - Page 1
English Operator's manual (EPA)
326C 326L 326LS
326LX-series
326LDX-series
Please read the operator's manual carefully and make sure you understand the instructions before using the machine.
Owners Manual - Page 3
... CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS ..... 25
Note the following before starting 3 INTRODUCTION Dear customer 4 WHAT IS WHAT? Maintenance, replacement, or repair of non-authorized accessories or replacement parts. WARNING! Always
use approved hearing protection. trimmer can cause
serious or fatal injury to the operator or
others .
Non-authorized...
Owners Manual - Page 4
... our authorized dealers, ask for forestry and gardening as well as our highest priority. In 1956, the first motor driven lawn mowers appeared, followed by chain saws in the world of forest and garden products, with quality as for using , ...operator′s manual, so they will be satisfied with repairs and service whenever this operator′s manual as a valuable document.
Owners Manual - Page 6
... plug cap and ignition lead are working . WARNING! Running an engine in the vicinity of the machine. in a confined
! It is equipped with a spring-loaded
stop switch and can be dangerous if used incorrectly or carelessly, and can cause serious or fatal injury to
consult their physician and the...
Owners Manual - Page 7
...at the idle setting when the throttle lockout is above shoulder level. IMPORTANT!
All servicing and repair work properly. If your nearest servicing dealer. Never use a machine with the throttle in this... have a first aid kit nearby. See the "What is controlled by two independent return springs. If you press the lock (A) (i.e. When you move back to get it releases the throttle ...
Owners Manual - Page 8
... cutting attachment increases the level of vibration between the engine unit/cutting equipment and the machine′s handle unit.
Regularly check that have impaired circulation. Replace the guard if it is undamaged and not cracked. Never use a machine that you are using. If an incorrect or faulty
guard is cracked. These...
Owners Manual - Page 9
... completely
and disconnect the HT lead from the engine are hot
and may lead to serious damage. Always stop the engine before you can be replaced after the
throttle has been released. The nut should offer a resistance of at idle speed.
This will cause the engine to overheat and may contain...
Owners Manual - Page 10
...; Fit the screw, securing plate and wing nut as shown in the loop handle. • 326L/326LS: Fit the nut, washer and screw.
326LX/326LDX: Fit the nut, knob and screw. Fitting... handle must be fitted between the arrows on the
coupling (B).
WARNING! Fitting the loop handle
(326L, 326LS, 326Lx, 326LDx)
Dismantling:
• Loosen the coupling by turning the knob. • Align the...
Owners Manual - Page 11
... fitting on the trimmer head/plastic blades (H) in the reverse order. ASSEMBLY
Fitting a trimmer guard and Superauto II 1" trimmer head
(326L, 326LS, 326Lx, 326LDx)
Fitting other guards and cutting attachments
(326L, 326LS, 326Lx, 326LDx)
L
K
• Fit the correct trimmer guard (A) for use with the trimmer
head. Hold the shaft of the spanner as...
Owners Manual - Page 14
...and cause personal injury. The safety distance is not damaged or cracked. The bulb need not be 35-50 Nm. Replace the blade guard if it is started , otherwise the clutch can come into contact with your hand
Repeat pulling the ... is not cracked due to fatigue or due to impact or are formed is cracked. Replace the trimmer head or trimmer guard if they have been formed at least 1.5 Nm.
Owners Manual - Page 17
... the ground around trees, posts, statues and the like. Constant contact of this can ruin the lawn and damage the tool.
• Do not allow the trimmer head to constantly come into contact ... to and fro.
• The cord can easily remove grass and weeds up . It is difficult to
reach using a normal lawn mower.
WORKING TECHNIQUES
Grass trimming with a trimmer head
Trimming •...
Owners Manual - Page 18
... a lower engine speed.
• The T-screw regulates the throttle setting at the factory. If the T-screw is adjustable. turning it
has been correctly adjusted or repaired.
The basic setting is finally cleaned.
CAUTION! idle speed 2700 rpm
Recommended max. Fine adjustment
• When the machine has been "run at their...
Owners Manual - Page 19
Then turn the screw anticlockwise until it
has been correctly adjusted or repaired.
Muffler
WARNING! Do not use the machine until the cutting ... muffler. If your machine is best done with a catalytic converter the screen should be cleaned weekly, or replaced if necessary. This is fitted with a special spark arrestor screen. On mufflers fitted with...
Owners Manual - Page 20
....
CAUTION! Spark plug
Air filter
The air filter must be regularly cleaned to remove dust and dirt in the lower shaft should be replaced after about a month in oil. If the machine is a risk that the electrode gap is equipped with a suppressor.
20 - Cleaning the air filter
Remove...
Owners Manual - Page 21
... the machine.
CAUTION! The filter oil contains a solvent to be changed except if repairs are carried out. This would drain through the filter.
English - 21 Your warranty ... machine you should therefore avoid skin contact. Use only HUSQVARNA replacement parts. Put the filter in the bottom. Bevel gear
(326L, 326LS, 326Lx, 326LDx)
The bevel gear is filled three...
Owners Manual - Page 22
...X X
22 - X
Make sure the throttle trigger lock and the throttle function correctly from carbon deposits. Replace if necessary.
Clean or replace the spark arrestor screen on the machine. Replace if necessary by an autorized service workshop.
X... outside of the items are tight. Check the clutch, clutch springs and the clutch drum for wear. English X
Check that the trimmer head...
Owners Manual - Page 23
... user's ear and vibration on the handles are measured with the following time distribution: 1/2 idle and 1/2 max. English - 23 NOTE!
TECHNICAL DATA
Technical data
326C
326L/326LS
326Lx
326LDx
Engine Cylinder displacement, cu.in/cm3
1,50/24,5
1,50/24,5
1,50/24,5
1,50/24,5
Cylinder bore, inch/mm
1,34/34,0
1,34/34,0
1,34...
Owners Manual - Page 24
...326C
Accessories Blade shaft thread 3/8 R Plastic blades
Trimmer head
Arbor shaft thread M10 Plastic blades
326L, 326LS, 326Lx, 326LDx Trimmer head
326LDx
Shaft
Type
Tricut Ø 230 mm (R) Trimmy Hit Junior...- TECHNICAL DATA
The accessories are consequently UL listed. Powerhead model 326LDx 326L, 326LS, 326Lx
Accessories Hedge trimmer attachment with shaft HA 110 Hedge trimmer attachment...
Owners Manual - Page 25
... warranted part under the warranty is scheduled only for regular inspection in your small off -road engine.
WHAT IS COVERED
REPAIR OR REPLACEMENT OF PARTS Repair or replacement of two years, Husqvarna Forest & Garden must not be completed in materials and workmanship that part. Throughout the emissions warranty period of any questions regarding your small...
Owners Manual - Page 26
... CONTROL WARRANTY STATEMENT
HOW TO FILE A CLAIM
If you have any warranty maintenance or repairs and must be used in the performance of all Husqvarna Forest & Garden authorized servicing dealers.
MAINTENANCE, REPLACEMENT AND REPAIR OF EMISSION-RELATED PARTS
Any replacement part may be provided without charge to the owner. WHERE TO GET WARRANTY SERVICE
Warranty...
Similar Questions
How Do I Replace The Thorttle Cable And Trigger On A Husqvarna 326 Weed Eater
(Posted by dw782202 10 months ago)
Carburetor Adjustment Tool
where can I purchase a carburetor adjustment tool
where can I purchase a carburetor adjustment tool
(Posted by mammiethompson 2 years ago)
How To Replace The Throttle Recoil Spring On Husqvarna 326ls
(Posted by Anonymous-168781 2 years ago)
I Have Ahusqvarna 323l 2005. I Need To Replace The Spring In The Throttle Handle
i need replaceing the spring in the throttle handle. i need a repair manual that shows how to in a 2...
i need replaceing the spring in the throttle handle. i need a repair manual that shows how to in a 2...
(Posted by cgwinn2223 3 years ago)
