How Do I Replace The Thorttle Cable And Trigger On A Husqvarna 326 Weed Eater

www.youtube.com/watch?v=WTn0XqnrQbY

Hope that solves your problem. Please mark as helpful if it leads you to a satisfactory solution.Thank you.

Replacing the throttle cable and trigger on a Husqvarna 326 weed eater involves a few steps. Here's a general guide to help you with the process:

Note: Before starting any maintenance or repair on your weed eater, make sure the engine is turned off, and the spark plug wire is disconnected to prevent accidental starting.

Gather the necessary tools and replacement parts: You'll typically need a screwdriver, pliers, and the replacement throttle cable and trigger kit for your specific model. You can obtain the replacement parts from an authorized Husqvarna dealer or an online retailer.

Remove the air filter cover and air filter: Unscrew the air filter cover and remove it, along with the air filter. This step provides better access to the throttle assembly.

Disconnect the old throttle cable: Locate the end of the throttle cable inside the engine compartment. Depending on the model, you may need to remove a cable retaining clip or loosen a screw to release the cable. Carefully disconnect the cable from the carburetor or throttle linkage.

Remove the old trigger assembly: Examine the trigger assembly and locate any screws or fasteners securing it to the handle. Unscrew or remove these fasteners to detach the old trigger assembly from the handle.

Install the new trigger assembly: Take the new throttle trigger assembly and position it in place on the handle. Align the screw holes with the corresponding holes on the handle. Use the screws or fasteners you removed earlier to secure the new trigger assembly.

Connect the new throttle cable: Take the new throttle cable and thread it through the appropriate openings or guides on the weed eater handle. Ensure that the cable is properly routed and aligned with the carburetor or throttle linkage. Connect the cable to the carburetor or throttle linkage, securing it with a cable retaining clip or tightening the screw.

Reinstall the air filter and air filter cover: Place the air filter back into its housing and reattach the air filter cover. Ensure that the cover is securely fastened.

Test the throttle operation: Reconnect the spark plug wire, and start the engine. Test the throttle trigger to ensure smooth operation and proper response. Make sure the cable is properly tensioned and adjusted for optimal performance.

Please note that these steps are a general guide, and the exact procedure may vary slightly depending on the specific model of your Husqvarna 326 weed eater. It's always recommended to consult the owner's manual for detailed instructions and diagrams specific to your model. If you're not comfortable performing the replacement yourself, it's best to seek assistance from a professional or authorized Husqvarna service center.