Humax F2-1000T Support Question
Humax F2-1000T Support Question
Find answers below for this question about Humax F2-1000T.Need a Humax F2-1000T manual? We have 1 online manual for this item!
Question posted by xlb on November 6th, 2014
Satellite
Hi, hope you can help. Just bought an Autotrail motorhome fitted with a Humax F2 1000T box. Is this capable of using with a Snipe Satellite system which I've just bought. Excuse ignorance. Thankyou.
Current Answers
Related Humax F2-1000T Manual Pages
User Manual - Page 1
... does not have any responsibility for direct, indirect, accidental, necessary and other corruptions due to your receiver for purchasing a HUMAX digital terrestrial receiver. Notice
**
Copyright (Copyright © 2001 HUMAX Corporation)
Not to be able to safely install, use of the information contained in this manual.
**
Trademarks
VIACCESS™ is a trademark of copyright and copyright law...
User Manual - Page 3
... of power source indicated on top of power supplied to dust the receiver.
**
5. ATTACHMENTS
**
Do not use any maintenance or installation procedure
**
2. CONNECTION TO THE AERIAL
**
Disconnect the receiver from the mains before you are not sure of the type of the receiver must be left uncovered to allow proper airflow to any liquids...
User Manual - Page 4
... appliance.
**
11.LIGHTNING, STORM, or NOT IN USE
**
Unplug the product from melting.
2. Do not use the product when defective, serious damage can be sure the service technician uses replacement parts specified by the manufacturer or those that you... one of time. Safety and Warning
**
10.LOCATION
**
Place the receiver indoors to avoid exposing it can fall. Follow these directions.
User Manual - Page 5
... GB16 GB16 GB16 GB17 GB17 GB19 GB21
**
GB21
**
GB22 GB22 GB24 GB28 GB29
**
GB29
**
GB31 GB32
GB 5 Contents
**
1. Setup
2.1 Connecting Aerial 2.2 Powering On 3. Before Using the Receiver
1.1 Package Contents 1.2 Front Panel 1.3 Rear Panel 1.4 Remote Control 2. Channel List
5.1 Displaying and Switching Channel List 5.2 Changing Channel List Group 5.3 Edit Channels 5.4 Edit Favourite Channels...
User Manual - Page 7
...
**
This chapter describes detail instructions on the product and its accessories.
1.1 Package Contents
Please check all package contents before using your receiver.
**
**
Remote Control (1) **
User's Manual (1)
Batteries (2)
RF Cable (1)
Adaptor (1)
**
Note: Since faults may occur if the remote control is being left without a battery for a long time, ...
User Manual - Page 8
Green light is displayed when the product is in operation.
STANDBY LED
**
Red light is displayed when the product is in the Standby mode. Before Using the Receiver
**
1.2 Front Panel
** 1. GB 8 1.
User Manual - Page 9
TV SCART
**
Connects a TV SCART cable. 4. TV / VCR
**
Connects a RF signal from your receiver to a ANTENNA input jack on your receiver.
**
2. AC Adaptor
GB 9 **
**
1.3 Rear Panel
**
1. ANTENNA IN
**
Connects a aerial to RF (ANT) input jack on the your TV or VCR.
**
3.
User Manual - Page 10
Before Using the Receiver
**
1.4 Remote Control
** GB 10 1.
User Manual - Page 11
...OK
**
Selects a menu, or confirms the selected operation. To set the remote control for future use)
**
12.STANDBY
**
Switches between TV and Radio modes.
**
Note: This remote control can also... control your TV, please refer to Chapter 11. DTV
**
Controls the Receiver.
**
2. TV
**
Controls the TV.
**
3. BACK
**
Returns to the up, down, left or right ...
User Manual - Page 12
... the receiver. • Scart and co-axial cable are connected as in the figure above.
1.
GB 12 Refer to set to On. Setup
**
This chapter describes how to Chapter 8.4 for more information. Select the most appropriate procedure depending on your TV aerial to the passive antenna when Antenna Power is used. Note...
User Manual - Page 15
... or finished, the result of Channel Search is automatically started.
Installation Wizard
**
When powering on your receiver as you can enjoy programmes. When completing Channel Search, you can use the Installation Menu to configure your receiver for finishing the Channel Search.
Warning:
Press the EXIT button to stop the Channel Search, select the...
User Manual - Page 18
4. Icons
Displayed only if this receiver.
2.Detail Programme Information
You can see detailed information about the current programme. Displayed only when there is a scrambled channel. Displayed only when the programme is a dolby digital one page, use button to move to hide the information box.
• If the Detail information is more than one . 4. Channel...
User Manual - Page 39
...
Reserved Pregoramme List is automatically powered off.
1. Select AV Control using the the OK or button. Select Power Off using the OK or button. Select Preferences using the
button, and press the or OK
button.
2. Select either... to Chapter 6.3 Viewing Reserved Programme.
7.5 A/V Control
You can set Audio or Video Output Control. 1. button, and press
4. **
**
3.
User Manual - Page 43
... cursor is located at Stop Therefore, if you can delete unnecessary channels from Installation menu using the OK or button. Then select Delete and press the OK button. When completing Channel... the OK button. Select MENU button.
2. Select your receiver is stopped and the channels found until then will be displayed.
2. Receiver starts to select all channels, select Select All to search...
User Manual - Page 45
button, and press
2. Press the MENU button.
2. Enter Password using the button.
8.3 Default Setting
Default Setting restores the receiver to other channel information are deleted. **
**
4. If you perform Default Setting, all data such as Channel List, and User Configured data are provided together, the ...
User Manual - Page 46
... displayed, which helps Channel Search. button, and press the
3. Off No power supply. GB 46 or BACK
button to the ANTENNA IN connector on the rear of the receiver.
1. Installation ... setting. On 5V power supply from Installation menu using the button.
4. Enter Password using the OK or button. Select Installation using the NUMERICAL (0-9) button to perform restoring.
7. ...
User Manual - Page 47
... work.
**
Note: • The product cannot work at Humax website http://www.humaxdigital.com. Caution: Please note that the manufacturer uses. 4. A message will only occur under the following circumstances.
...the availability of software upgrade.
9.1 OTA (Over the Air)
OTA, an abbreviation of receiving signal strength is found at all during software update.
1. Over the Air(OTA) is ...
User Manual - Page 49
... completing the software update, the product is performed only for the satellites that have been set parameters in which provides update software. If new...HUMAX, the software search operation is automatically powered off and on again.
5. Satellite Alternative menu and that have all other Antenna Setting correct.
1. **
**
5. Select 3 Manual Update from Software Update screen using...
User Manual - Page 50
... and signal quality receiving for the channel that is currently on AV.
1. Confirm the information about Hardware version, Software version, Loader version, Update Data and System ID.
10.2 Signal Detection
You can view System information
1.
System Information
**
You can view all system information, signal strength and quality.
1. Select Status using the or...
User Manual - Page 61
... button to descramble the scrambled channels.
GB 61 The channel is scrambled.
This digital terrestrial receiver does not support the service that enables to confirm if the channel has Audio. Remove the...you may need to do
No or bad signal The aerial is currently on
or video.
Replace antenna. Antenna is shorten.
The channel is short-circuited. is for data broadcasting.
...
Similar Questions
Does The Time Update Over Satellite
I don't have a satellite connected to my Humax in my room and the clock is always behind or forward.
I don't have a satellite connected to my Humax in my room and the clock is always behind or forward.
(Posted by dpope94461 5 months ago)
Humax F2-1010t Tuning
Won't pick up any channels. Auto search completes, but when I go to exit, it says no services were r...
Won't pick up any channels. Auto search completes, but when I go to exit, it says no services were r...
(Posted by xxdawwxx 12 years ago)
Transferring Media From Receiver To Pc In Home Network
i have plugged a LAN patch cable in the back of my receiver to communicate in my laptop in my home n...
i have plugged a LAN patch cable in the back of my receiver to communicate in my laptop in my home n...
(Posted by marquispurs 12 years ago)