Hotpoint HDA3500NBB Support Question
Hotpoint HDA3500NBB Support Question
Find answers below for this question about Hotpoint HDA3500NBB - Dishwasher w/ 5 Wash Cycles 6PUSHBTN.Need a Hotpoint HDA3500NBB manual? We have 1 online manual for this item!
Question posted by jusherjusher on February 2nd, 2015
Does The Hda3600hbb Has A Fuse?
is there a fuse ?
Current Answers
Related Hotpoint HDA3500NBB Manual Pages
Installation Instructions - Page 1
... you should immediately contact your Owner's Manual for future reference.
• Skill Level- Proper installation is required.
KEEP THESE INSTRUCTIONS. If you received a damaged dishwasher, you have questions, call 800.GE.CARES1800.432.2737} or visit our website at: www.ge.com
BEFORE YOU BEGIN
Read these instructions for available ...
Installation Instructions - Page 3
... Shaded Area
Figure A
• Hake sure the floor is completely enclosed at a later date for proper drainage. • The dishwasher must be fullg enclosed on the top,
sides, and back. • The dishwasher must not support ang part of the
enclosure.
• The rough cabinet opening and even with the finished floor...
Installation Instructions - Page 4
...Make sure there are NO, either question is connected to the
underside of the dishwasher, which mag cause damage.
Waste Tee Installation
Figure C
Disposer Installation
METHOD 2-High ...instructions. The drain hose will not drain if
plug is necessary for the drain hose. Dishwasher will be sure that
_4
drain plug has been removed. Installation Preparation-Drain
PREPARE DRAIN ...
Installation Instructions - Page 5
... / White
Cabinet Preparation & Wire Routing • The wiring mag enter the opening , 6" to Dishwasher
Electrical connection is on the appliance. Permanent wiring connections mag pass through a separate hole. If the... ELECTRICAL WIRING
P"v._V#:lt.,_'1I I_[_i
FOR PERSONAL SAFETY: Remove house fuse or open circuit breaker before proceeding. This appliance is installed and grounded in...
Installation Instructions - Page 6
... cord with plug is used, the water line must be required by local codes.) • The water connection is on the left side of the dishwasher. Cabinet Face_,- Figure F
Water Line Connection • Turn off the water supply. • Install a hand shut-off valve in an accessible
location, such as under...
Installation Instructions - Page 7
...toekick, and screws aside for use in the hinge arm.
• Screw leveling legs back into the dishwasher frame, approximately 3/4" from the underside of the wood base with the 1/4" machine thread screws
in the... to remove
it will go. • Gently pull the access panel forward to install the dishwasher. Damage will tip over when the door is opened if the base is properly balanced if it...
Installation Instructions - Page 8
... bracket. • Connect power cord white (or ribbed) to dishwasher white, black (or smooth) to dishwasher black and ground to dishwasher green wire.
Black
IM PORTANT- Note: The drain hose supplied ... drain hose and clamp set aside in Step 1. Use UL listed wire nuts of
the dishwasher.
Prevent drain hose damage
and possible leaks. Maximum power
cord length is fully seated against...
Installation Instructions - Page 9
...AND POWER
CORD, IF USED, THROUGH CABINET
• Upright the dishwasher and position it will not kink when the dishwasher is installed into the hole previously drilled in the cabinet wall.
...follow the instructions
included in front of the junction box avoiding contact with anything under the dishwasher.
1
Figure N
_Water Line Supply
Tip: Avoid unnecessary service charges for the power ...
Installation Instructions - Page 10
...the lower rock. Theg should fit in the adjacent cabinet while sliding the dishwasher into position. The dishwasher must not interfere with the springs, straighten and re-center the blanket ... front
panel with hands or knees when sliding dishwasher into position. The dishwasher door should not be level for
proper dish reck operation, wash performance, and door operation. If the rocks ...
Installation Instructions - Page 11
...door panel and/or control panel.
• If countertop is wood or woodlike material, fasten the dishwasher to the countertop by driving the Phillips head screws through the countertop brackets and into the countertop.
...with door operation and damage to prevent interference with the compression nut. Dishwasher must be sure the door
spring does not rub or contact the fill hose or water supplg...
Installation Instructions - Page 12
...disposer
__
r_
__
r¢
Figure V
Cutting Line
/.
Dishwasher will not drain if plug is connected to fit the inlet port. Dishwasher Installation
STEP 15: CONNECT DRAIN LINE
The molded end of... plug has been removed if the drain hose is left in the dishwasher cavitg from becoming kinked or crushed bg the dishwasher. IMPORTANT: Do not cut corrugated portion of the inlet port •...
Installation Instructions - Page 13
... it to a permanent connection, refer to convert it does not roll back into dishwasher or further out. Insert dishwasher wires through moll hole in brocket
Junction Ground s ox s rocket
White
In this...: Checkthot home leod ore threoded through the small hole in contact with door springs or other dishwasher components. [] Check that the wiring is not 2-wire with a ground wire, a ground must...
Installation Instructions - Page 14
...Wash
Appearance varies by the dishwasher door rubbing or hitting adjacent cabinets. Check the drain line for leaks under the dishwasher. Plug the red connector into the dishwasher....
[] Let the dishwasher run through another fill and drain cycle. Check again to /4 minutes. Cycles
_
_
Options
_
_
_
on electronic models. Cover
[] Check for leaks when dishwasher drains. A leak ...
Installation Instructions - Page 15
...two tgpes of the access panel and should still be in the access panel and into the dishwasher frame. • Tighten these screws. • Align the toekick and make sure the bottom edge... is against the floor. To prevent damage to the dishwasher. • Select the two 8-32 x 1//4" machine thread screws
just removed and insert them through the ...
Installation Instructions - Page 16
...Remove and discard the power cord. • Connect the conversion harness (included with
dishwasher) to the dishwasher harness bg connecting like-colored wires. Figure CC • Return to Step 16... present. • Disconnect the three power cord conductors from
the dishwasher harness. Appendix
CONVERTING DISHWASHER WITH FACTORY
EQUIPPED POWER CORD TO A PERMANENT CONNECTION
This procedure requires...
Similar Questions
Dishwasher Model: Hda2000tww
I put this Dishwasher in my rental. Has not been used much over the last year or so. My current rent...
I put this Dishwasher in my rental. Has not been used much over the last year or so. My current rent...
(Posted by Two4spurs 11 years ago)
Hotpoint Aquarius Fdw20 Dishwasher
machine not working and prewash light flashing whatever cycle is selected, filter cleaned pipes not ...
machine not working and prewash light flashing whatever cycle is selected, filter cleaned pipes not ...
(Posted by marlenrichards 11 years ago)
Dishwasher Racks Are Rusting. Are They Under Warranty Or Can They Be Replacerd
Dishwasher is 6 years old and works fine.
Dishwasher is 6 years old and works fine.
(Posted by 22stuart 11 years ago)
Dishwasher Runs Through Cycle But Makes A High Pitched Whining Noise.
Dishwasher is a Hotpoint, model HDA2000TBB
Dishwasher is a Hotpoint, model HDA2000TBB
(Posted by mgs61 12 years ago)
Installing A Ge Gsm2260nss Under Sink Dishwasher With Gpf97 Double Bowl Sink.
I am installing aNew GE GSM2260NSS Under Sink Dishwasherwith theGPF97 Double Bowl Sink. I am running...
I am installing aNew GE GSM2260NSS Under Sink Dishwasherwith theGPF97 Double Bowl Sink. I am running...
(Posted by myrthmaker 12 years ago)