Hoover H3060 Support Question
Hoover H3060 Support Question
Find answers below for this question about Hoover H3060 - FloorMate SpinScrub 800 Wet Dry Vacuum.Need a Hoover H3060 manual? We have 1 online manual for this item!
Question posted by lblonde on May 29th, 2012
Not Holding Cleaning Solution
When i fill with water and the cleaning solution, it empties out immediately.
Current Answers
Related Hoover H3060 Manual Pages
Manual - Page 2
...water, take it must be connected to reduce the risk of an extension cord is not permitted by a qualified electrician. Turn off all chemicals used by the cleaning...or use without tanks in place.
• Always install float before any wet pick up operation. • Close supervision is necessary when any other ... dry place.
Do not immerse product.
• For use on stairs. • The...
Manual - Page 3
... Brush/nozzle assembly . . . . 5-6 General Operation Mode selector dial 8 Solution tank 9-10 Recovery tank 10-11 Automatic shut-off 10 To clean filters 11-12 How to this manual. Hard floor cleaner B. Tool caddy F....8226; www.hoover.com
• 1-800-944-9200 - Nozzle C. our Consumer Response Center (8 AM to 5 PM Monday - Floor cleaning
concentrates
© 2004 The Hoover Company www.hoover.com
D
E C...
Manual - Page 4
... of cleaner. Carrying handle 18. Cord hooks: top hook rotates
for wet pickup and dry vacuuming 5. Cleaner Description
1
1
2
3
17
16 15
4 4
5
6 7 8 9
10 11 20
12
11
14 13
Features
1. Mode selector dial: turns brushes
ON for wet cleaning and OFF for quick cord release 20. Clean solution tank release
8. Recovery tank lid and filter 10.
Soft-tread...
Manual - Page 6
... section (D) of the cleaner nozzle (C) for assembly. Remove cardboard packing insert from squeegee area on cleaner.
Assemble tool caddy
9
The two sections (A & B) of nozzle.
8
While holding nozzle in place, slide latches inward to snap into place.
7
To install nozzle, make sure latches (C) are out.
Manual - Page 8
... posi- It is not intended for complete cleaning instructions.
8
tion, tilt cleaner back on rear wheels
and push forward.
17
The cleaner may also be used to clean" section for use FloorMate™ SpinScrub™ Cleaner to the WET PICKUP position. Refer to "How to both vacuum dry debris and wet clean non-carpeted floor surfaces such as vinyl...
Manual - Page 9
... set of HOOVER® Grout Cleaner. Use these conditions could damage your FloorMate™ SpinScrub™ 800 Cleaner. Carry tank to a sink.
21
Rotate tank cap counter-clockwise ...Floor™ Cleaner.
20 21 A
The tanks
Solution (upper) tank
The solution tank holds detergent and water that is needed for cleaning grout. (See "Cleaning the brushes" section for how to remove and replace...
Manual - Page 10
... from overflowing. 24
If rubber ring (D) on cap has become dislodged, reposition it locks in place. When the shut-off is full and must be emptied.
10 Recovery (lower) tank
Automatic shut-off An automatic suction shut-off activates, the cleaner will not pick up debris and the sound of the...
Manual - Page 11
....
Check the solution tank also.
Allow filter to empty
Turn cleaner off and disconnect from electrical outlet. Reposition filter.
30
Replace filter lid. Clean this time.
...pleated filter when suction is recommended that the recovery tank be emptied after dry vacuuming and before wet operation. Empty tank. To clean filters
The tank lid contains a washable, reusable filter. ...
Manual - Page 12
... (C).
12 Reposition pleated filter in place. E
How to clean
Recommended cleaning sequence
Use your HOOVER® FloorMate™ SpinScrub™ 800 Cleaner to:
• Dry Vacuum to the WASH position (B).
To wet clean with brushes turned ON, turn the dial to remove loose dirt, hair and debris. • Wet Clean the floor surface. Dry or loose debris will also collect on and...
Manual - Page 13
... dial to pick up detergents that no water remains on non-carpeted floors. Cleaning floors
NOTE: Your HOOVER® FloorMate™ SpinScrub™ 800 cleaner may also be cleaned with water. Empty recovery tank (see Figs. 20 through 9. Ensure that contain solvent based ingredients. do not use FloorMate™ SpinScrub™ cleaner to wet clean sealed wood floors if any type of...
Manual - Page 14
...wand (A) onto hose end (B). Grout tool • Stiff brushes to use for more concentrated cleaning on hose.
To extend telescoping wand, pull button (D) toward you and pull wand ...35 Select tool
A.
How to clean small, tight areas
B. Floor swivel tool • Swivel head
• 2 rows of cleaner. Align hose connector (B) with hose and solution ports (C).
Insert hose connector ...
Manual - Page 15
...174; FloorMate™ SpinScrub™ 800 tool caddy (A) is provided for storing
the hose, tools, telescoping wand, set of caddy.
42
Place floor swivel tool (J), grout tool (K), brush assembly (L), telescoping wand (M) and detergent (N) into caddy
as shown. B
41 E
G
H
I ) on a wood surface unless cleaner is completely dry. The handle must be necessary to release cleaning solution...
Manual - Page 16
... (D) are out. A
A
43 Slide the two nozzle release latches (A) outward.
44 B
44 Remove nozzle (B) by pulling straight out.
45
Rinse nozzle under running water.
D
47
16
Maintenance
Cleaning the nozzle
43
Turn cleaner OFF and disconnect from squeegee (C) and wipe with opening (F) on cleaner. Remove debris from electrical outlet.
DE F
47
While...
Manual - Page 17
... slide latches inward to upright position.
Press brush assembly firmly to snap into hole. E
52
While holding nozzle in the upright position.
Tilt cleaner back so handle rests on bottom of nozzle with opening (G)... the brush assembly.
A Remove tanks to prevent leaking.
48 A
49
B
50
D
C
51 G F
E
52
Cleaning the brushes
The brush assembly can be removed for easy...
Manual - Page 18
...Cleaning solution won't dispense Brushes won 't run Low suction
Water puddling behind cleaner Won't pick up debris that is too large to clear the squeegee. Make sure solution tank is locked in firmly.
Check the fuse or breaker. Empty...ensure it is
set for DRY VAC. Tip nozzle off floor by pushing down on
handle to pick up dirty solution
Cleaner pushes a line of dry debris in front of it ...
Manual - Page 19
this cleaner OR Checking the Yellow Pages under "Vacuum Cleaners - Phone: 1-800-263-6376. Service
To obtain approved HOOVER service and ... Hoover Canada, Burlington, Ontario L7R 4A8;
Always identify your cleaner to motor bearings. Household" OR Calling 1-800-944-9200 for service; Lubrication
The motor is needed, contact The Hoover Company Consumer Response Center, Phone: 330-...
Manual - Page 20
...9499.
Hoover Factory Service Centers.
2. In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, 1-800-263-6376.
20 This warranty provides, at www.hoover.com
This warranty does not cover pick up ...purchased in the United States including its territories and possessions, or in the U.S.A., phone 1-800-944-9200 OR
visit The Hoover Company on-line at no cost to state. Appliances ...
Similar Questions
Why Does My Flormate H3060 Leave The Floor Wet?
I previously owned a FlorMate H3000 and it left the floor MUCH drier than the H3060.
I previously owned a FlorMate H3000 and it left the floor MUCH drier than the H3060.
(Posted by sldvegas 9 years ago)
Hoover Fh40010b Floormate Spinscrub Wet/dry Vacuum Won't Stay On.
Floormate keeps shutting off. I checked all the seals and cleaned everything, but it still shuts off...
Floormate keeps shutting off. I checked all the seals and cleaned everything, but it still shuts off...
(Posted by 0rosie 10 years ago)
What Brands Of Cleaning Solution Are Safe To Use In A Hover Fh40010b ?
I just purchased a Hoover FH40010B floor cleaner and want to know what other brand names of cleaning...
I just purchased a Hoover FH40010B floor cleaner and want to know what other brand names of cleaning...
(Posted by gbalbach 10 years ago)