Hoover H3060 Support Question
Hoover H3060 Support Question
Find answers below for this question about Hoover H3060 - FloorMate SpinScrub 800 Wet Dry Vacuum.Need a Hoover H3060 manual? We have 1 online manual for this item!
Question posted by sldvegas on June 26th, 2014
Why Does My Flormate H3060 Leave The Floor Wet?
I previously owned a FlorMate H3000 and it left the floor MUCH drier than the H3060.
Current Answers
Related Hoover H3060 Manual Pages
Manual - Page 2
... to the State of electric shock. If it should , has been dropped, damaged, left outdoors, or dropped into openings. if it must be grounded. This appliance is well ...Do not use on bare floors or sealed wood floors. Do not exceed recommended mixing ratios. • Store in place.
• Always install float before any wet pick up hard, sharp ...use without tanks in a dry place.
Manual - Page 3
... for warranty service of the cleaner body.
Upper handle D. Brush assemblies (2) E. Floor swivel tool G. Hose J. our Consumer Response Center (8 AM to this manual. ... PM Monday - Nozzle C. Grout tool H. To contact us:
• www.hoover.com
• 1-800-944-9200 - Contents
Important safeguards 2 Carton contents 3 Cleaner description 4 Assembly
Handle assembly 5 Brush/nozzle ...
Manual - Page 4
... assembly (gray
bristles) 25. Recovery tank: collects dry debris as
well as dirty cleaning solution 11. Plug...wet cleaning and OFF for household use. Recovery tank release
9. Nozzle
This cleaner is intended for wet pickup and dry vacuuming 5. Squeegee (underneath nozzle) 14. Hose connector door 17. Upper handle release button 19. Handle release pedal 21. Telescoping wand 24. Floor...
Manual - Page 5
... snapped in place. Install brushes and nozzle
5
To install brushes, place handle in upright position.
Align control rod (B) on upper 3 handle (C) with hole (B) on the floor. Turn brushes slightly until post fits easily into hole. Tilt cleaner back so
that it is
felt.
Manual - Page 7
11 F
D 12
EG
H
N
Store hose, tools and accessories
I ) into slot (J) on pedal (A) to lower handle to allow convenient operation. Continue wrap- Place floor swivel tool (K), grout tool (L), brush assembly (M), telescoping wand (N) and detergent (O) into second cut -out area (F).
ping hose down, underneath tongue (G), and
back up and
press ...
Manual - Page 8
..., turn the dial to clean" section for use FloorMate™ SpinScrub™ Cleaner to wet clean sealed wood floors if any of the cleaner.
16
17 A
General operation
Your HOOVER FloorMate™ SpinScrub™ 800 Cleaner can be used to both vacuum dry debris and wet clean non-carpeted floor surfaces such as vinyl, tile, marble and sealed wood.
Transporting
16...
Manual - Page 9
Check for worn spots or joint separations before using, as these for how to clean floor.
Use these conditions could damage your FloorMate™ SpinScrub™ 800 Cleaner. A
For hard surface floors such as a measuring cup. When cleaning ceramic and other wood floors that can
normally be cleaned using water to remove and replace the brush assemblies...
Manual - Page 11
... refilled at this pleated filter when suction is recommended that the recovery tank be
rinsed for additional cleaning.
It may also be emptied after dry vacuuming and before wet operation.
Press down on release button (B) and pull tank straight out.
28 Remove tank lid (C). Remove filter lid (A), then remove filter (B). Empty tank. Clean...
Manual - Page 12
... are
raised off .
E
How to clean
Recommended cleaning sequence
Use your HOOVER® FloorMate™ SpinScrub™ 800 Cleaner to:
• Dry Vacuum to the WET PICKUP position (C).
12
Dry or loose debris will provide light agitation to help loosen dirt. • Wet Pickup reduces drying time of tank behind ledge (E) and push tank straight into cleaner body until...
Manual - Page 13
...pick up the spill.
Cleaning floors
NOTE: Your HOOVER® FloorMate™ SpinScrub™ 800 cleaner may also be cleaned with water. CAUTION: To prevent damage to the WET PICKUP position and release the ... to clean wood floors that no water remains on non-carpeted floors. If using cleaner on handle release pedal and lower handle to DRY VAC position and vacuum floor.
Note: When ...
Manual - Page 14
... and up on stubborn grout stains
35 A
Attach hose and tool
Unplug cleaner from port. Close hose door tightly. Using the tools
35 Select tool
A. Floor swivel tool • Swivel head
• 2 rows of the wand is recommended you to use for more concentrated cleaning on latch (B).
How to connect hose...
Manual - Page 15
....
41
To store hose: Place the hose grip (C) into caddy
as shown.
Allow to air dry.
• Press on upper handle release button to lower handle for storage.
• Make sure...convenience, the HOOVER® FloorMate™ SpinScrub™ 800 tool caddy (A) is pressing on the nozzle squeegee.
• Do not store cleaner on back of caddy.
42
Place floor swivel tool (J), grout tool ...
Manual - Page 17
... upright position.
Align middle section (F) of cleaner. Do not use a solvent based detergent.
50
To replace brushes, align post (C) on brush block with hole (D) on floor.
49
Push two brush release buttons (B) and remove the brush assembly.
Set aside.
48 Pull the two nozzle release buttons (A) out. Tilt cleaner back so...
Manual - Page 18
...won 't rotate
18
What to do
Make sure the cleaner is set for DRY VAC. Tip nozzle off floor by pushing down on
handle to
turn cleaner ON. If the brushes continue to stall... tank is installed
properly. Empty recovery tank. Check Mode selector dial to ensure it is
set for WET PICKUP. Make sure recovery tank is installed
properly. Empty recovery tank. Make sure filter and filter...
Manual - Page 19
...Ontario L7R 4A8; Always identify your cleaner to motor bearings.
this cleaner OR Checking the Yellow Pages under "Vacuum Cleaners - Household" OR Calling 1-800-944-9200 for the life of the cleaner.)
19 If further assistance is equipped with this will only result in... on the back of the motor. Do not add lubricant to The Hoover Company in delay. Phone: 1-800-263-6376.
Manual - Page 20
..., all labor and parts to state.
In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, 1-800-263-6376.
20 Warranty service can only be obtained by a limited one of the following authorized warranty... application. S. This warranty does not apply if the appliance is used in the U.S.A., phone 1-800-944-9200 OR
visit The Hoover Company on-line at no cost to you may also have ...
Similar Questions
I Have Cleaned The Brush A Ton Of Times. Sometimes It Works When I Move It Somet
(Posted by Lsarmiento88 7 months ago)
Hoover Fh40010b Floormate Spinscrub Wet/dry Vacuum Won't Stay On.
Floormate keeps shutting off. I checked all the seals and cleaned everything, but it still shuts off...
Floormate keeps shutting off. I checked all the seals and cleaned everything, but it still shuts off...
(Posted by 0rosie 10 years ago)
What Do The Brushes Look Like For Hard Wood Floor Use.
(Posted by Christinedean22 10 years ago)