Hoover F4300 Support Question
Hoover F4300 Support Question
Find answers below for this question about Hoover F4300.Need a Hoover F4300 manual? We have 1 online manual for this item!
Question posted by jpaul5 on September 29th, 2012
Where Can I Buy The Polishing/buffing Pads For This Machine
need to get a set of polishihg pads for the Hoover F4300
Current Answers
Related Hoover F4300 Manual Pages
Manual - Page 1
...; pp. 1-10 Español § pág. 11-18 Français § p. 19-26
Hard Floor Machine
and Carpet Shampooer
Review this manual before being shipped from the factory. Thank you should happen to find the service outlet nearest you...Consumer Response Center
or
Visit us online at www.hoovercompany.com to need assistance during assembly or operation, call
1-800-944-9200 for selecting...
Manual - Page 2
...not use or when taking off or putting on brushes or pads. If appliance is used with this machine, be present.
• When using an electrical appliance,... Floors 6-7 Polishing & Buffing Floors 8 Shampooing Carpet & Rugs.........5-6 Waxing Floors 7 If You Have A Problem 9 Service 9 Important Safeguards 2 Maintenance 8-9 Lubrication 9
© 1978,1990, 1998 The Hoover Company www....
Manual - Page 3
...NORTH CANTON FOR SERVICE.
1. Assembly
Carton contents
Unpack the floor machine and identify the accessories shown. A. Felt Buffing Pads (gray)
E. Accessory Bag
I
J
3 Splash guard : ...5.
Soft Cloth Pads (beige)
G Fasteners
H. Household" for the nearest Authorized Hoover Warranty Service Dealer (Depot) or call:
1-800-944-9200 for your local Hoover Factory Service Center...
Manual - Page 4
... the fastener to remove pad.
2-3
2-4
2-5
Attaching tank
Attach brushes and pads before attaching tank.
Do not change the plug in the outlet, reverse the plug. Start floor machine by lowering and raising ...flat side toward handle and holes to front. Set bottom of lower handle section.
1-3
1-4
2. Connect handle
Remove tank from shampoo-polisher and remove nut, bolt and cord clip from...
Manual - Page 5
...machine motor will change and the floor machine may be dry buffed (without applying a wood floor cleaner) using water solutions; Removing tank
Turn tank cap lock until the floor is completely dry.
Vacuum floor thoroughly to the floor.
3. Attach power scrub and cleaning brushes. Fill with HOOVER...start floor polisher by using the heavy duty cleaning and waxing pads.
5...
Manual - Page 6
... areas need to be removed by the manufacturer. It can be rewaxed and polished, and... vacuum cleaner to remove dust and dirt and damp cloth to remove sticky particles. Cleaning-polishing wax...machine in straight lines or with the grain of wax will give floors more shine is a self-polishing wax which does not contain a petroleum solvent. Remove felt buffing pads and attach high luster pads...
Manual - Page 7
...machine over a small area of sham- Move furniture
Place plastic or aluminum foil pads...shampoo brushes to apply
the solution. Vacuum thoroughly
Vacuum carpet to run and may damage ...machine. Guide floor machine
slowly, slightly overlapping the strokes. area (1m x 1m) is covered with loop or twist pile show a change is used according to protect fine rugs and carpet. Do not use HOOVER...
Manual - Page 8
... bottom of the tank and rinse cap with a paper towel or cloth before re-using a HOOVER vacuum cleaner for amounts to an accumulation of powder and wiping with brushes turned toward towels. Using dry-cleaning
compounds
The floor machine may be used .
3. Install a new disposable bag in the same way as brushes; To...
Manual - Page 9
... Yellow Pages under "Vacuum Cleaners - Hang it...machine in the upright position. Store your cleaner to those parts being replaced. If further assistance is double insulated. Servicing a double-insulated appliance requires extreme care and knowledge of the system, and should a means for an automated referral of the motor.
insulated appliances
This appliance is needed, contact The Hoover...
Manual - Page 10
... clean when wax is
waxed, only wax gets scratched. (Use vacuum cleaner to remove dirt.)
High luster pads for applying solvent-base paste wax. Apply thin even coat.
• D e t e rgent not rinsed from
floor before rewaxing.
• Floor not polished pro p e r ly. • Polish with wax and rub spots. Apply thin
coat of wax...
Similar Questions
Uh73301, Indicator Says It's Clogged But Can Not Reset.
Checked for entire clogs but no e were found. Ran vacuum for a few minutes then clogged light came ...
Checked for entire clogs but no e were found. Ran vacuum for a few minutes then clogged light came ...
(Posted by mfmercier 4 years ago)
My Hoover Elite Rewind Just Stopped.
I was vacuuming, and it just stopped in mid-vacuum. It will not turn back on, It has been cleaned re...
I was vacuuming, and it just stopped in mid-vacuum. It will not turn back on, It has been cleaned re...
(Posted by kevinjuliewebster 9 years ago)
Have Problem With A Floormax Supreme F4300 Would Like A Maunal
only one brush is turning
only one brush is turning
(Posted by jimjean1889 10 years ago)
My Hoover Floor Max Supreme Model F4300 Brushes Stopped Turning; How To Fix?
(Posted by dihall 12 years ago)