Honeywell HM509 Support Question
Honeywell HM509 Support Question
Find answers below for this question about Honeywell HM509.Need a Honeywell HM509 manual? We have 3 online manuals for this item!
Question posted by barryshain on February 9th, 2014
I Need The Correct Part Number
The locking arm that swings down to lock the water holding tank in place has broken. Can i buy just this bracket or do i need an entire new top of tank piece?
Current Answers
Answer #1: Posted by BusterDoogen on February 9th, 2014 1:53 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,397
Member since:
October 30th, 2011 Points: 28,565,397
Go to this page for the tank. I had no luck finding the latch.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Honeywell HM509 Manual Pages
Owner's Manual - Page 2
... Inc. Table of contents
About your new humidifier TrueSTEAM controls 1 Maintaining ideal humidity 2 TrueSTEAM function and operation 3 Setting the controls 4
Maintenance and operation LED light indicators 5 Cleaning and maintenance 6 Seasonal or vacation maintenance 8
Troubleshooting and repair Homeowner troubleshooting 9 Limited warranty...10
Need Help? All rights reserved. Registered...
Owner's Manual - Page 5
...-05 Snap-lock latch allows for a longer period of mind. The patented Condensate Collect Dome and beveled nozzle keep water in the tank, delivering only true steam into your duct's airflow.
Automatically fills with highcapacity true humidity, while using up to monitor performance, giving you to 70% less water than flow-through humidifiers.
TrueSTEAM Direct...
Owner's Manual - Page 7
Humidifying indicates that the humidifier is operating correctly, when maintenance is needed, and when it is safe to remove the tank for cleaning.
The 5-minute default can be drained for 5 seconds to turn off the Press Empty LED and restart the Clean tank timer. Press/Hold the button for 5 seconds to remove for service.
If the Press Empty...
Owner's Manual - Page 9
... suitable for non-stick pots or pans are suitable for cleaning the TrueSTEAM reservoir walls and components within the bracket to ready the humidifier.
69-2035EFS-05 Cleaning and maintenance
TrueSTEAM Direct-Injection Humidifier
2. Use tap water to the cam shaft, and "Lock" the shut-off humidifier with tank.
Tank is removable. Carefully rub minerals off of the...
Owner's Manual - Page 10
... to a comfortable position.
69-2035EFS-05
Clear the water drain tube. 4. Make sure the water tank gasket seal is still level. Check that the humidifier is not cracked or split before reattaching the
humidifier water tank. 5. Follow steps 1-6 in the Cleaning section on extended vacations, it is not needed again.
There are a few house-cleaning steps to follow...
Owner's Manual - Page 11
...Homeowner troubleshooting
TrueSTEAM Direct-Injection Humidifier
If you have difficulty with TrueSTEAM, please try the following suggestions. Most problems can be corrected quickly and easily.
Lower ...ventilation is on . • Set the humidistat higher. • Check that the furnace power is needed.
• Press Reset button.
• If fault persists, turn off power supply to a minimum...
Owners Guide - Page 3
... line is open.
• Ensure there are no water leaks/drips at least enough capacity to fully flush and drain. True 6 Gallons
* ARI Guideline F-2007 for the Job
1. TO BYPASS AND DRAIN IMMEDIATELY, Press and hold the EMPTY button again while the Clean Tank light is being generated.
• Test the drain by...
Owners Guide - Page 4
...69-2036EFS-07
If the homeowner sees that TrueSTEAM is not humidifying but there is blinking, instruct the homeowner to press and hold the Reset button to calling a contractor. Wait 24 hours prior ... unit may be under-sized (if home is used, there may be needed. These odors will reset to operate correctly when full power is condensation on weather, size of continuous operation to achieve...
Owners Guide - Page 6
...cut into a GFI ground fault interrupt outlet. • Water inside tank can increase the internal operating temperature of the humidifier and shorten the humidifier's life.
• Allow at least 1 foot clearance to... Electrocution, Heavy Equipment, and Chemical Hazard. upstream of the interior duct to hold the humidifier in . Covering them can be splashed. You may be necessary.
•...
Owners Guide - Page 7
...water line. • Electrical circuit rated to your humidifier. • Vertical surface with adequate clearances. M24744
2 Install duct nozzle. Ensure o-ring gasket is properly seated in . TrueSTEAM Humidification System
If installing the humidifier...Draining water may be hot.
Model HM506 HM509 HM512
M24745
Required Minimum Circuit Capacity 7 Amps 10 Amps 12 Amps
CAUTION Hot water temperature ...
Owners Guide - Page 8
SUPPLY
4 Drill 1-3/4-in . B) Push down to secure humidifier to page 13 for plumbing and wiring instructions.
69-2036EFS-07
Foam gasket
M24750
B A
M24749
Proceed to bracket arms. Ensure gasket forms tight seal in duct hole. hole.
12 INCHES
Secure bracket to remote mounting instructions. M24748
A) Slide foam gasket over nozzle and
6
insert the nozzle into...
Owners Guide - Page 9
...by improper hose installation.
Insul-Tube 1-1/8 in . and 12-gallon models (HM509 and HM512) can lead to duct nozzle water spitting or leaking gasket. Choose a location for : • Remote hose ... temperature requirements.
pitch on page 10). Refer to governing codes for mounting to your humidifier (see remote installs on TrueSTEAM, which can be installed with an upward pitch of...
Owners Guide - Page 12
...Guide
Remote mount installation
Model HM506 HM509 HM512
M24745
2
Minimum Circuit Capacity 7 Amps 10 Amps 12 Amps
Install hose adapter from scalding. Continuous downflow
Ensure o-ring gasket is properly seated in the groove.
M24744
CAUTION Hot water temperature above 120°F (49&#... nozzle to TrueSTEAM.
69-2036EFS-07
10 Ensure drain outlet not exposed.
Draining water may be hot.
Owners Guide - Page 15
... with hose clamp. Description In-Line Water Filter (included) (required for warranty) Back-flow valve (included) (required)
Part Number 50028044-001
50030142-001
To water supply
A
B
1/4-in . T-fitting
Manual shutoff valve (sold separately)
Saddle valve (provided)
Piercing pin
To humidifier
M24852
To humidifier
Water supply line
Check all water line connections to ensure a tight fit...
Owners Guide - Page 21
... , press/release the RESET button. Press/hold the RESET button for 5 seconds. the Press Empty button).
return to "Ready" • Check for the fault signified by the number of the tank prior to releasing the tank,
especially if water is present.
• Clear any excess debris from which the humidifier can not recover by Professional HVAC...
Owners Guide - Page 23
...? if fault no longer exists in tank may be Performed by HUMIDIFYING light turning on. • Allow unit... to 104°F (40°C).
• Turn humidistat off . Yes, system will
electronic circuit
return to "Ready"
board is off and allow time for water in tank to "Ready" if fault no longer
exists in the cover are set correctly...
Owners Guide - Page 24
... press/hold the EMPTY button while the "Clean Tank" light is not exposed and use caution when pressing the EMPTY button, and do NOT attempt to remove the tank with water in it...locked rotor at 24 VAC
Output Ratings • Relay output contacts:
- HM512: 1440W at 120VAC at full load - W x 19 in . HM509: 1200W at 120VAC at full load - E185662. HM509
9 lbs.
14.5 lbs. D
• Humidifier ...
Owners Guide - Page 29
... and Nozzle Kit 20-foot Remote Hose and Nozzle Kit Cover Duct Nozzle Remote Nozzles Mounting Bracket Solenoid Valve In-Line Water Filter HM512/HM509 Water Tank HM506 Water Tank Water Level Sensor Assembly Saddle Valve Back-flow Water Valve Differential Pressure Switch
Part Number 50024917-001 50024917-002 50028004-001 50028003-001 50028001-001 50020012-001 50027997-001 50028044...
Parts Guide - Page 1
... replaced.
• If voltage is cool).
• Follow tank cleaning instructions
in the Professional Installation Guide. • Reassemble tank and press the RESET button. • Initiate humidistat call and monitor
device. (may need to
insufficient. Tank failed to drain.
• Water in . Heater failed • Press and hold the EMPTY button for fault
light to validate...
Parts Guide - Page 2
... Nozzle Kit Cover Duct Nozzle Remote Nozzles
Mounting Bracket Solenoid Valve In-Line Water Filter HM512/HM509 Water Tank HM506 Water Tank Water Level Sensor Assembly Saddle Valve Back-flow Water Valve Differential Pressure Switch
Part Number Fig. If the TrueSTEAM Call Service light is detected, the system will drain from which the humidifier can not recover by turning the humidistat...
Similar Questions
Reseting Problems Hm509
Hi, can't seem to get system reset. I cleaned and it worked for a couple days.
Hi, can't seem to get system reset. I cleaned and it worked for a couple days.
(Posted by earlsmythe63 1 year ago)
I Need A New Water Tank , Hcm6012i-l One Of Mine Has A Crack
(Posted by burkex1 3 years ago)
Humidifying Light
My humidifying light is blinking and not humidifying at all, what do i do?
My humidifying light is blinking and not humidifying at all, what do i do?
(Posted by Anonymous-123169 10 years ago)
Honeywell Humidifier Not Working.
It worked last year, but now it won't do anything. I thought maybe the line was clogged, but someone...
It worked last year, but now it won't do anything. I thought maybe the line was clogged, but someone...
(Posted by johnschlueter16 13 years ago)