Homelite UT41112 Support Question
Homelite UT41112 Support Question
Find answers below for this question about Homelite UT41112.Need a Homelite UT41112 manual? We have 3 online manuals for this item!
Current Answers
Related Homelite UT41112 Manual Pages
User Manual - Page 3
Failure to follow all bystanders, children, and pets at the rate for the gardening appliance. Always use of balance.
Avoid Accidental Start - Use rubber gloves and substantial footwear is dusty.
Always wear safety glasses with the switch ...
User Manual - Page 6
... not avoided, will result in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety glasses with side shields and, when needed, a full face shield. Always use only identical replacement parts.
WARNING:
The operation of risk associated with this product. SYMBOLS
The following signal words and meanings...
User Manual - Page 7
... It should be used.
Only round jacketed cords listed by a qualified service technician. Failure to do not need for loose or exposed wires and cut or worn insulation.
**Ampere rating (on product data plate) 0-2.0 ...
Double insulation is a concept in safety in electric power tools, which eliminates the need to be sure to use . Double insulated tools do so can result in serious...
User Manual - Page 8
...locked in two different positions for ease of use. FRONT HANDLE
The string trimmer is needed for ease of operation and to different extension points for ease of use of this ... can be adjusted to prevent loss of the project you are attempting. English cord retainer
A convenient cord retainer helps keep the extension cord connection secure during string trimmer operation. EdGER GUIDE
The ...
User Manual - Page 10
...:
Do not allow familiarity with products to inflict severe injury.
Remember that a careless fraction of the string trimmer housing and place underneath the cord retainer. To start the string trimmer, press the switch trigger. To stop the string trimmer, release the switch trigger.
User Manual - Page 11
...; Resume trimming.
This will extend approximately 1/4 in serious personal injury. OPERATION
WARNING:
Always hold the string trimmer away from the power supply, then push the spool retainer button in figure 8. Use the tip of use. Unplug the string trimmer. Unscrew telescoping boom coupler and slide to do not force...
User Manual - Page 13
...
Avoid using the bottom part of the spool counterclockwise, as garden chemicals and de-icing salts.
Spool Retainer
tABS
WARNING:
Do not at any old string remaining on the spool. Cut two pieces of spool retainer. Pull spool retainer up to remove. Remove spool. To install the new spool, make repairs described here.
Use original manufacturer...
User Manual - Page 14
Strings are tangled on spool.
3. Refer to String Replacement earlier in this manual. Refer to String Replacement
earlier in ... welded to start when switch trigger is loose.
2. Not enough string on spool.
4.
Motor fails to themselves. Page 14 - using the Auto Feed Head: 2. Cut tall grass from spool and rewind. Lubricate with silicone spray. 2. Strings are worn too short.
...
User Manual - Page 15
... repairs made necessary by normal wear or by the dealer to substantiate any warranty claim. Spark Plugs, Carburetor, Carburetor Adjustments, Ignition, Filters
B. Bump Knobs, Outer Spools, Cutting Lines, Inner Reels, Starter Pulleys, Starter Ropes, Drive Belts, Tines, Felt Washers, Hitch Pins, Mulching Blades, Blower Fans, Blower and Vacuum Tubes, Vacuum Bags...
Replacement Parts List - Page 2
...
9
6
SEE NOTE
3
4
5
2 1
KEY NO.
1 2 3 4 5 6 7 8 9
part NUMBER
34108178AG
31104178G
33301178G
31100178G
3220811G
*
3110585G
3410705AG
3290205G
*
3110482AG
987000221
PARTS LIST
DESCRIPTION
QTY
Spool Cap...1 Spool...1 Edger Guide...1 Grass Shield...1 Screw (M4 x 16 mm 1 Front Handle Assembly 1 Knob Screw (M6)...1 Hex Nut (M6)...1 Clamp...1 Operator's Manual...
Getting Started Guide - Page 1
...card: "Send me information on the rear of the string trimmer.
7 Route extenion cord through the cord retainer.
8 Connect the extension cord to the power supply.
3
9 Fully depress the switch trigger.
4
...shipment to Drawings for each product.
Mail the card to www.homelite.com and register your new tool on a 3"x5" card or standard postcard: your product, call the Homelite Help Line...
Similar Questions
New Bump Feed Spool And Knob.
I am unable too get the new bump feed spool off the machine
I am unable too get the new bump feed spool off the machine
(Posted by Tyronepearce 7 years ago)
How To I Remove The Spool Head From The Shaft?
I want to replace the spool head with a plastic blade unit. How does the head come off?
I want to replace the spool head with a plastic blade unit. How does the head come off?
(Posted by Bsackett 7 years ago)
How To Load Spool On A Model Ut33600
I have homelite UT33600 dual feed edger and I'm trying to fine an instruction video for this
I have homelite UT33600 dual feed edger and I'm trying to fine an instruction video for this
(Posted by jayman626 10 years ago)