Hayward AquaVac 250Li Support Question
Hayward AquaVac 250Li Support Question
Find answers below for this question about Hayward AquaVac 250Li.Need a Hayward AquaVac 250Li manual? We have 1 online manual for this item!
Question posted by terrimadewell on September 11th, 2021
How Do I Help The Vac Switch When It Hits The Eall
The vac just started stopping at the wall and won't switch to turn the other direction and gets stuck
Current Answers
Answer #1: Posted by SonuKumar on September 11th, 2021 11:10 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,604,800
Member since:
May 9th, 2021 Points: 16,604,800
Why is my Hayward vacuum not moving?
Cleaner doesn't move.
Hayward suction cleaners depend on several factors to operate. First, there must be enough water flow past the "turbine". Use the "vacuum gauge adaptor" or "flow gauge" supplied with the cleaner to measure the vacuum in the cleaner hose. ... There is an obstruction in the cleaner.
https://www.haywardnet.com/contactus/faqs/viewfaqs.cfm?category=2&subcategory=29
Why did my pool vacuum stop working?
When a suction cleaner is sluggish or slow, it's usually a clogged pump basket or dirty filter that is to blame. Other problems include holes in the cleaner hose, sucking air into the hose. Or the filter pump could be drawing in air, reducing water flow volume.
https://www.hayward-pool.com/assets/documents/pools/pdf/manuals/av250-owners-manual.pdf
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Hayward AquaVac 250Li Manual Pages
AquaVac 250Li Owners Manual - Page 2
... Contents
IMPORTANT SAFETY INSTRUCTIONS &
WARNINGS
P.4
HOW THE ROBOT WORKS
P.7
GETTING STARTED
P.8
Charging The Battery
P.8
Set-Up Before Use
P.9
o Clip-on Rake/ Brush Assembly
P.9
o Adjustment of Trajectory
P.10
Tube setting
P.10
Bumper
P.11
Pool Preparation
P.11
OPERATION
P.12
EMPTYING THE DEBRIS COMPARTMENT
P.14
MAINTENANCE...
AquaVac 250Li Owners Manual - Page 6
... not allow hair, body, and any object to the section "Battery Disposal" in the water. - For details regarding battery disposal, refer to touch the impeller. - - Turn off the robot, disconnect the external adaptor from the power source, and
unplug the external adaptor from the charging base, before it . -
AquaVac 250Li Owners Manual - Page 7
...placing it to use it into the water.
- It is not recommended to clean anything other than your pool.
- Make sure to charge the robot to about 30% to incorporate all -purpose vacuum cleaner. This... any kind. Make sure the robot is completely dry before it is stored. Pool / spa owners should be located outside zone 1 Keep the external adaptor and charging base out of reach ...
AquaVac 250Li Owners Manual - Page 8
... arc pattern in through the filter and is first sucked in the other direction. Water jetting from the nozzle propels the robot forward. The robot vacuums the pool bottom as the pool wall, its side flap sways and its swivel head turns 180o, allowing the robot to move in its compartment.
7 Water is discharged via...
AquaVac 250Li Owners Manual - Page 9
...sure the robot and the charging port are aligned. Plug the socket of the external adaptor
3.
GETTING STARTED
Charging The Battery
IMPORTANT NOTE: Fully charge the robot (about 5-6 hrs) before set-up. ...the unit on the external adaptor will turn red.
Place the unit on the external adaptor will turn green when the robot is off by sliding the switch to the OFF position prior to ...
AquaVac 250Li Owners Manual - Page 11
...:
Tube setting
Set the tubes A & B according to below instruction.
1)For pools where the shortest length is 3 meters or above
Turn the tube A to position "0" or "1"
Set tube B in position
Tips: To achieve a steeper curve in trajectory, adjust the tube A to position "2".
2) For pools where the shortest length is below 3 meters
Set the tube...
AquaVac 250Li Owners Manual - Page 12
... prior to deploying the robot.
11
If you adjust the fin. IMPORTANT NOTE: Turn off the filtration system (as
they may obstruct the movement of the robot's float and, consequently, the movement of the
robot also.
-
Remove any pool ladder, surface skimmer, and other floating objects from a qualified professional.
-
NOTE: In case...
AquaVac 250Li Owners Manual - Page 13
...pool. Slide the power switch to the side of your robot to the ON position and the power indicator lights will turn on the side clip to the depth of pool water plus an excess of about 0.5 meters (1.6 feet). Make sure the robot is submerged in the pool corner and against the pool wall...stem and reattach it to the pool bottom. This phenomenon will stop once the air trapped inside the...
AquaVac 250Li Owners Manual - Page 14
...the water surface, locate the end with your pool is quite dirty, it is recommended to empty the debris compartment after every use. Slide the power switch OFF.
Rinse the robot with both water ... left
Last light blinks
Only 10 minutes of usage remains once the last light starts blinking. Refrain from the pool, attach the hook to a telescopic pole (not provided) and use any physical...
AquaVac 250Li Owners Manual - Page 16
... should be disposed safely in the vicinity of properly. Observe and record the run times in a well-ventilated area away from sunlight, heat, ignition sources, pool chemicals
and from children. MAINTENANCE & STORAGE
NOTE: 1. Ambient temperature for comparison with run times of the cavity and replace with fresh
water. To replace a damaged...
AquaVac 250Li Owners Manual - Page 17
... result in contact with eyes, do not rub them. How to remove the battery pack (To be done by the contact of
soap and water. - Turn the bottom locking plate anticlockwise to expose the head inside.
3. Use the screwdriver to unscrew the 4 screws located at the bottom of the connector to...
AquaVac 250Li Owners Manual - Page 18
...If brushing is still turning
Swivel head rotates repeatedly
Robot does not cover the entire pool
Robot stopped by large debris. If...small particles. Wheel is jammed Robot moves along the pool wall of the flap.
Suction mouth is clogged Filter cover...direction is deem necessary, use only one rake or brush in circles. Contact your dealer for further instructions. Remove the obstacle. Turn...
AquaVac 250Li Owners Manual - Page 20
...with FCC and IC RF radiation exposure limits set forth for help. Operation is no guarantee that may not cause harmful interference, and (2)...there is subject to radio communications.
FCC (US) Product: Aquavac 200 Series Cleaner FCC Responsible Party: Hayward Industries, Inc. 400...uses and can be determined by turning the equipment off and on a circuit different from all persons...
AquaVac 250Li Owners Manual - Page 38
...003 du Canada. Changes or modifications not expressly approved by turning the equipment off and on a circuit different from all ...with the limits for general population. FCC (US) Product: Aquavac 200 Series Cleaner FCC Responsible Party: Hayward Industries, Inc. 400...the dealer or an experienced radio / TV technician for help. This device must be installed to radio or television ...
Similar Questions
Why Does My 250li Stall When It Hits The Wall.sometime The Flap Thing Turns Over
and sometimes it doesn't.worked well when was brand new but now can stall against the wall.unit is o...
and sometimes it doesn't.worked well when was brand new but now can stall against the wall.unit is o...
(Posted by waynearthur19 1 year ago)
Won't Change Direction
when it comes to the side of the pool it will not change direction. It did last year very well but n...
when it comes to the side of the pool it will not change direction. It did last year very well but n...
(Posted by 4tlpeterson 1 year ago)
Dual Pool Spa System But The Settings Menu Doesn't Show Pool Heater Only Spa Hea
(Posted by Anonymous-39619 12 years ago)
Intermittent Starting Of Super Ii Pool Motor
Have a Hayward Super II 1.0 HP pool motor about 15 yars old. Sometimes it does not start - it will h...
Have a Hayward Super II 1.0 HP pool motor about 15 yars old. Sometimes it does not start - it will h...
(Posted by cmathe 12 years ago)