GE GG40T06PVK Support Question
GE GG40T06PVK Support Question
Find answers below for this question about GE GG40T06PVK.Need a GE GG40T06PVK manual? We have 2 online manuals for this item!
Question posted by ccaballero on June 22nd, 2011
Ge Power Vent Heater Doesnt Turn On
I HAVE A GE POWER VENT HEATER MODEL # GG40T06PVK00 WITH THE INTELLI-VENT THERMESTAT. THE HEATER DOES NOT TURN ON , THERES NO LIGHTS ON THE INTELLI- VENT, PUT THERE IS POWER TO THE UNIT. HELP..
Current Answers
Related GE GG40T06PVK Manual Pages
Use and Care Manual - Page 2
...model and serial numbers here: # #
You can kill or hurt you will follow the safety alert symbol and either the word "DANGER", "WARNING", "CAUTION" or "NOTICE". All safety messages will find many helpful hints on your water heater... . 21 Operating Instructions Lighting Instructions 22 Water Temperature . . . . . 23, 24
Care and Cleaning Draining 26 Maintenance 26 Vent System Inspection . ....
Use and Care Manual - Page 3
...to install or operate this manual.
Failure to install the blower assembly and properly vent the water heater to read and understand the entire Use and Care Manual before attempting to the Safety...questions, STOP, and get help from carbon monoxide, never operate this manual, or have any other appliance can result in this water heater unless it is properly vented and has an adequate air ...
Use and Care Manual - Page 4
... Shriners Burn Institute
More than 5 minutes 11/2 to read and follow the warnings outlined on the water heater. Children, disabled and elderly are at its lowest setting before the water heater was set at highest risk of being delivered, turn on the Gas Control (Thermostat) Temperature Dial.
120°F
90°F
Care and Cleaning
Troubleshooting...
Use and Care Manual - Page 6
...installation instructions. FOR INSTALLATIONS IN THE STATE OF CALIFORNIA
California Law requires that residential water heaters must be followed to minimize the risk of your appliance is specifically recommended in ....
● Do not attempt to earthquake motions. WARNING! Turn off the manual shut-off valve if the water heater has been subjected to overheating, fire, flood, physical damage ...
Use and Care Manual - Page 7
... Park, Quincy, MA 02269 as practical to the gas vent or chimney.
● Long hot water lines should be insulated to conserve water and energy.
● The water heater and water lines should not be installed in accordance with water.
The pan must be used or stored. The water heater must be located in an alcove or closet, the...
Use and Care Manual - Page 9
... main where the pressure is recommended on all models. Check with an air cushion built in the cold water line near the water heater. It may have been installed in the inlet water line.
In an "open " water system.
A "closed water system". The suggested typical installation. Contact your local water utility.
The installation of the relief valve, and...
Use and Care Manual - Page 10
...Water Supply Systems, ANSI Z21.22, is turned on the rating plate.
Drops of any type, restriction, or reducer coupling should be protected from operation with a heavy water draw and very cold inlet water... pitch downward from the valve to vent from the hot water faucet(s) indicates a full water heater.
The Btuh rating of the water heater as marked on . Condensation
Condensation ...
Use and Care Manual - Page 11
...water heater...water heater...water heater.
for LP gas....water heater.
gas, which could result in hazardous operating conditions. Gas Supply
The branch gas supply line to the water heater... water heater ... This water heater can ...water heater suitable...water heater...water heater and its manual gas shut-off valve during any pressure testing of this water heater...water heater is placed in operation....
Use and Care Manual - Page 12
...Venting section of this manual. If the water heater is being installed as outlined in the system. If any installation work.
Do not apply power until the adhesive has fully cured. NOTICE: This unit...connection. Install rubber coupling (supplied in this water heater to help prevent the transmission of this manual will result in the Venting section of noise and vibration.
PVC (Schedule...
Use and Care Manual - Page 13
... and Cleaning
Troubleshooting Tips
Customer Service
13 This water heater is one (1) foot of vertical pipe, one (1) 90°elbow, and four (4) feet of pipe. Minimum vent length for 2" Vents*
NOTICE: The mixing of 2" and 3" vent pipe is approximately equal to 5 feet of horizontal pipe. Venting information for 3" vent pipe is approximately equal to 6 feet of 45...
Use and Care Manual - Page 14
...vent pipe. To help prevent moisture from an inside corner formed by two exterior walls.
Painted surfaces will condense as it leaves the vent terminal.
Additional Considerations
Do Not install vent... vent pipe...vent terminal. Use a rust-resistant sheet metal backing plate (2 x 2 feet) behind vent. (See illustration.)
Do Not locate vent terminal too close , block off and
install new vent...
Use and Care Manual - Page 15
... the roof and interior ceiling to the left . Support vertical or horizontal runs as shown to American National Standards Institute and American Society for vent. Refer to the water heater's vent connector fitting on the following minimum clearances and considerations (see illustration):
Minimum twelve (12) inches above anticipated snow level. Place the 1/2" mesh metal...
Use and Care Manual - Page 16
... vent section as close as practical ...type of vent pipe used...pipe into the water heater installing a condensate ...vary according to the water heater vent connection. Use a... applying cement. NOTICE: This unit is one inch. ABS materials... is recommended in the vent piping must conform to ... Installation Instructions Safety Instructions
Installing the water heater. Do not smoke.
CPVC materials...
Use and Care Manual - Page 19
...3/4" coupling depending on page 31. The base of the water heater is meant to be installed on any burner access door that the venting system
complies with two 24" sections of Dilution Air Holes
...rating plate.
❑ DO provide adequate air for joint cement
vapors to dissipate BEFORE applying power to the illustrations above, that the thickness does not exceed ½". A new burner access...
Use and Care Manual - Page 20
...; Gas Company inspected installation (if
required). Water Heater Location
❑ Close to area of vent. ❑ Indoors and protected from freezing
...heater's
flue.
❑ Blower assembly properly installed.
❑ Vent connector(s) pitched upward to applying electrical power.
20
Customer Service
Venting
❑ Flue baffle properly hung in top of length minimum) .
❑ Vent...
Use and Care Manual - Page 23
....
Operating Procedure
This heater is recommended that the hot water faucet be regulated by this or any electrical appliance connected to accumulate near the faucet at the kitchen sink before going into operation it is only necessary to turn the main manual gas valve to the "ON" position, plug the power cord in and...
Use and Care Manual - Page 25
... appliances can be hotter than 6" of the tank. This water heater incorporates a combustion shut off before draining water.
! CAUTION: Shut off gas to see that it is turned off device that there is suggested that a few quarts of the water heater. Check the outdoor vent terminal to the water heater at the fixture can
cause carbon monoxide
dangers, excessive...
Use and Care Manual - Page 27
... time, the power and water to conserve energy and prevent a buildup of dangerous hydrogen gas. The anode rod is equipped with an anode rod designed to prolong the life of the water supply should be turned off to the appliance should minimize the problem. Vacation and Extended Shut-Down
If the water heater is completely filled...
Use and Care Manual - Page 29
...DO NOT attempt repair of the water heater. Water usage may have exceeded the capacity of gas piping, gas control (thermostat), burners, vent connectors or other safety devices.
...Lights, but Combustion Shutoff System Main Burner will not tripped.
Turn "ON".
The pilot burner may be set too high. "ON/OFF" switch turned off. This is set too low. Refer repairs to water heater...
Use and Care Manual - Page 30
... control.
Lockout condition.
False Flame (Unwanted Flame Present). CAUTION: Make certain power to water heater is too high, the valve will not operate. Line/Neutral Polarity Failure..... Lockout condition.
● Contact local qualified service technician. Lockout condition. Inspect vent pipe and dilution air inlet for blockage. (Refer to "Routine Preventive Maintenance" Section...
Similar Questions
Ge Power Vent Water Heater
My water heater fires up and ignites but only runs for a few minutes then the flame goes out.It trie...
My water heater fires up and ignites but only runs for a few minutes then the flame goes out.It trie...
(Posted by miller19602003 9 years ago)
How To Replace An Igniter On A Hot Water Heater Model Gg40t06pvk00
(Posted by eraLill 9 years ago)