GE DSXH47GGWW Support Question
GE DSXH47GGWW Support Question
Find answers below for this question about GE DSXH47GGWW - 5.8 cu. Ft. Gas Dryer.Need a GE DSXH47GGWW manual? We have 1 online manual for this item!
Question posted by florencetedesco on October 3rd, 2010
My Gas Dryer Won't Stop Beeping.
My gas dryer won't stop beeping. All the lights flash and even though I press pause/cancel, the beeping continues until I unplug it.
Current Answers
Related GE DSXH47GGWW Manual Pages
Owners Manual - Page 1
... Instructions 2-5
Operating Instructions
Care and Cleaning 8 Controls 6 Features 7 Loading and Using the Dryer 8
Installation Instructions 9-18
Electrical Installation for Electric Dryer 16, 17 Electrical Requirements 11 Exhausting the Dryer 12, 13 Gas Connection for Gas Dryer 18 Gas Supply Requirements 13 Location of Your Dryer 14 Mobile Home Installation 15 Preparing to Install Your...
Owners Manual - Page 2
.... WHAT TO DO IF YOU SMELL GAS:
1 Do not try to light a match, or cigarette, or turn on any gas or electrical appliance.
2 Do not touch any other reproductive harm and requires businesses to such substances.
Properly adjusted dryers will minimize incomplete combustion.
do not use gasoline or other flammable vapors and liquids in...
Owners Manual - Page 3
... IF IT COLLAPSES OR BECOMES OTHERWISE RESTRICTED IN USE OR DURING INSTALLATION. Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support
PROPER INSTALLATION
This dryer must be properly installed and located in Installation Instructions.
■ Install or store where it is used.
■ Properly ground...
Owners Manual - Page 4
... or inside the dryer or in your dryer. Do not stack or place laundry or throw rugs against the front or back of electric shock, unplug this or any ...dryer at the household distribution panel by clothing during subsequent dryer uses.
■ To minimize the possibility of the dryer.
■ Close supervision is necessary if this appliance is moving. NOTE: Pressing the PAUSE...
Owners Manual - Page 5
... you understand and have a pilot light.
Place the cord away from hiding inside the dryer should be cleaned at least once a year by using a dryer-applied fabric softener or an antistatic ... a qualified technician.
Hazardous fumes or electrical shock could occur.
■ If yours is a gas dryer, it is equipped with controls.
■ Do not attempt to repair or replace any part...
Owners Manual - Page 6
... sense fabric dryness. The TIMED DRY cycle will stop the dryer.
MEDIUM For synthetics, blends and items labeled permanent press or tumble dry medium heat. Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions
About the dryer control panel. This cycle is lighted.
Fabric Care
HIGH For regular to heavy cottons.
DEWRINKLE...
Owners Manual - Page 7
...dryer features. Unheated tumbling continues during the cycle, the Cycle Selector will advance to remove the clothes. These fabrics should be used with flat blade screwdriver
Light housing
Replacing the Dryer Light... the cycle, press the CANCEL button twice.
■ Remove garments promptly at the household distribution
panel by removing the fuse or switching off the light housing.
2 Unscrew...
Owners Manual - Page 8
... operating.
The Exhaust Duct: Inspect and clean the exhaust ducting at the bottom of the Dryer
The Exterior: Wipe or dust any spills or washing compounds with the manufacturer's instructions. Follow...lint screen from the dryer. The Lint Screen: Clean the lint screen before each use in all GE Dryers when used in warm, soapy water. Remove by some laundry pretreatment soil and stain...
Owners Manual - Page 9
...; Remove and discard existing plastic or metal foil
duct and replace with flexible plastic ducting materials.
Save these instructions
for local inspector's use only. The gas dryer is not
covered under ANSI Z 21.5.1 or ANSI/UL2158-CAN/CSA C22.2 (latest editions) for commercial applications such as restaurants or beauty salons. Keep these...
Owners Manual - Page 10
... or UL-listed flexible metal 4″ (10.2 cm) duct
Vent hood 1/4″ nut driver (remove terminal block access cover and install cord) (ELECTRIC DRYER)
Pipe thread sealer (GAS DRYER)
UL-listed strain relief (may be sure that the existing external exhaust is required (new construction)
Flexible stainless steel or plastic-coated brass connnecting...
Owners Manual - Page 11
...GAS DRYERS
WARNING -
or 20-amp circuit breaker or time-delay fuse.
• If the electric supply provided does not meet the above specifications, call a licensed electrician.
Attach ground wire (obtain locally)
NOTE: A wiring diagram is located under the top panel. Electrical Requirements
• This dryer...outlet.
Electrical Requirements
• This dryer must be supplied with 120V, ...
Owners Manual - Page 12
...metal (semi-rigid) ducting cannot be inspected and cleaned at least 4 ft. Exhaust system shall be used (Kit WX08X10077).
• Never install...feet (2.4 m).
• For many applications, installing elbows at both the dryer and the wall is highly recommended (see illustrations at turns and joints.
... a ceiling,
gas vent, crawl space, attic, under an enclosed floor, or
in the exhaust ...
Owners Manual - Page 13
... clamp. Always use of 4" (10.2 cm) Dia. If codes allow, flexible metal tubing may be used to or less than 1/2 psig (3.45 kPa).
13 Gas dryers can cause gas leaks and personal injury. Slide one end of local codes, with normal usage. Stainless steel or plastic-coated brass MUST be used . Installation MUST...
Owners Manual - Page 14
... 1″ (2.54 cm). The following clearances for proper operation in the same closet as the GAS DRYER.
3. Closet door
60 sq. Floor MUST be exhausted outdoors.
2. No special dryer top is available through your GE retailer. Your dryer needs the space around it will come in an area where it for the full length...
Owners Manual - Page 15
... terminate beneath the mobile home.
Termination MUST be made for outside (outdoors, not beneath the mobile home) using Mobile Home Installation Kit Pub. When installing a gas dryer into a mobile home, a provision must be securely fastened to the mobile home structure.
3. See the Exhaust System Checklist section for installation and servicing.
15 Correct...
Owners Manual - Page 16
... proper power cord to be installed onto power cord.
For a grounded, cord-connected electric dryer: If your dryer. If in a risk of the dryer and can create electrical shock and/or a fire hazard.
For a grounded, cord-connected gas dryer:
• This dryer is not attached, the cord can be plugged directly into account the length of...
Owners Manual - Page 18
... installed by brushing on , the safety switch will light, it is clear and free from gas supply line to the corrosive action of combustion and ventilation air.
6. Be careful not to LP gas service without converting the gas valve.
Conversion to LP Gas: DO NOT connect the dryer to scratch the paint.
2. Open the shutoff valve...
Owners Manual - Page 19
...dryer may tumble but not heat
Gas service is off
LP gas supply tank is blown or one breaker tripped.
• Make sure gas shutoff at dryer and main shutoff are wet appear after drying. Your dryer... clothes
Possible Causes
Dryer is unplugged
Fuse is blown/circuit breaker is tripped
Thermal limiter tripped
What To Do
• Make sure the dryer plug is normal. • Move dryer to dry only ...
Owners Manual - Page 20
.... Overdrying
Letting items sit in dryer after drying.
• If you are operating. Synthetics, permanent press and • Try a fabric...gas), size of load, types of fabrics, wetness of clothes and condition of heavy fabrics (like • Large, heavy fabrics contain more than one or two items, add a few items to dry. Since most dryers use two fuses/breakers, make sure the dryer...
Owners Manual - Page 21
... Instructions Troubleshooting Tips Consumer Support
Error Codes If the dryer stops, the status lights flash and the signal beeps, an error has occurred. Make the correction, select a cycle and press START. Press PAUSE/CANCEL. Clean out the ventilation system.
If the dryer stops, status lights flash again and the beeping continues, please contact service for the possible cause and...
Similar Questions
My Ge Profile Gas Dryer Does Not Heat Up.
Hi I have a ge profile gas dryer model dpvh880gjmv. It does not heat up but everything else seems fi...
Hi I have a ge profile gas dryer model dpvh880gjmv. It does not heat up but everything else seems fi...
(Posted by kaganriverranch 3 years ago)
Just Bought A Ge Gfds170ghww Gas Dryer. Drum Not Running
Just bought a GE GFDS170GHWW gas dryer. Plug into 120V outlet(manual said 120v). Push the power butt...
Just bought a GE GFDS170GHWW gas dryer. Plug into 120V outlet(manual said 120v). Push the power butt...
(Posted by tomzhou 8 years ago)
Gas Dryer Btu's
What is the input Btu/hr for this gas dryer and what is the total input Btu/hr of this gas dryer?
What is the input Btu/hr for this gas dryer and what is the total input Btu/hr of this gas dryer?
(Posted by rarolin 10 years ago)
I Have A Ge Model Dsxh47ggoww Gas Dryer And All It Does Is Beep It Still Works
theAlthea gas dryer works fine but all it does is beep every 40 secs on and off
theAlthea gas dryer works fine but all it does is beep every 40 secs on and off
(Posted by Tzona928 10 years ago)
Gas Dryer Will Not Heat
Everything else works, led lights, motor,door switch, but the heating element stopped heating. I che...
Everything else works, led lights, motor,door switch, but the heating element stopped heating. I che...
(Posted by fortseward 13 years ago)