GE DBSR453EBWW Support Question
GE DBSR453EBWW Support Question
Find answers below for this question about GE DBSR453EBWW.Need a GE DBSR453EBWW manual? We have 2 online manuals for this item!
Question posted by amyclements on December 31st, 2016
Heating Element???
Heating element gets red but only heats half and wont dry clothes, what needs to be replaced?
Current Answers
Answer #1: Posted by Odin on December 31st, 2016 12:20 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
Replace the heating element. See https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Dryer/8-3-687631-/GE-Dryer-not-heating-DBSR453EBW.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related GE DBSR453EBWW Manual Pages
Installation Instructions - Page 1
...NOTE: Installation and service of moisture from being blown into the room. • Before the old dryer is used near children. METAL DUCT (RECOMMENDED)
4" DUCT CLAMPS (2)
4" DIA.
Connect the Power ...SPRING
CLAMPS (2)
4" DIA. FLEXIBLE METAL DUCT (IF NEEDED)
DUCT TAPE
3/4" STRAIN RELIEF GLOVES UL RECOGNIZED
DRYER POWER CORD KIT
(NOT PROVIDED WITH DRYER)
UL RATED 120/240V, 30A WITH 3 OR 4...
Installation Instructions - Page 2
...THE FOAM PIECES AROUND THE LEGS.
2 ELECTRICAL CONNECTION INFORMATION
WARNING - ELECTRICAL REQUIREMENTS
This dryer must be connected to the equipmentgrounding terminal on the appliance. REMOVE GROUND STRAP AND DISCARD... 120/240V or 120/208V, 60Hz, 30 amp circuit is required.
Dryer must be electrically grounded in accordance with the NATIONAL ELECTRICAL CODE, ANSI/NFPA NO. 70.
Consideration ...
Installation Instructions - Page 3
...louvered plenums are used, they must be insulated to power cord
entry hole. B. Be sure the dryer cord is YOUR RESPONSIBILITY. Install 3/4 in . B. Tighten all terminal block screws (3) completely.
...block (marked L1 and L2). They will : • Increase the drying times and the energy cost. • Reduce the dryer life. • Accumulate lint, creating a potential fire hazard....
Installation Instructions - Page 4
...ELBOW HIGHLY RECOMMENDED
RECOMMENDED CONFIGURATION TO MINIMIZE EXHAUST BLOCKAGE.
FOR STRAIGHT LINE INSTALLATION, CONNECT THE DRYER EXHAUST TO THE EXTERNAL EXHAUST HOOD USING DUCT TAPE OR CLAMP. Installation Instructions
4 EXHAUST... SIDES OR BOTTOM OF THE CABINET.
LEVEL SIDE-TO-SIDE.
(CORD NOT SUPPLIED WITH DRYER)
CUT THE METAL EXHAUST DUCT (NOT SUPPLIED) TO THE PROPER LENGTH. NOTE: WE ...
Installation Instructions - Page 5
...the rear of the dryer and the wall,...Dryer. • Avoid Resting the Duct on the dryer back.
• The dryer...dryer...If your dryer is : 0 in . ... INSTALLATION
• The dryer MUST be used , ... between dryer cabinet and... UL-listed clothes dryer flexible... and a dryer, doors must...DO NOT SIT DRYER ON FLEXIBLE EXHAUST....dryer MUST be vented to overhead cabinets, ceiling, etc. either ...
Installation Instructions - Page 6
... blower housing. Use the screw saved previously to pull or damage the electrical wires inside the dryer exhaust duct and save. Wrap duct tape around joint.
• Insert duct assembly, elbow first, through ...the tab on the joint between the dryer internal duct and the elbow. EXHAUST CAN BE ADDED TO LEFT OR RIGHT SIDE
DUCT TAPE
BEND ...
Installation Instructions - Page 7
... metal elbows and ducts to get the screw started.
2.
Insert the door on each hinge at the bottom. Reinsert the plastic plugs on page 6.
TO REGISTER YOUR DRYER
CALL TOLL-FREE 1-888-269...half way into the TOP holes, for replacement parts, and other hand holding the top of the opening by lifting it to the dryer internal duct.
• Apply duct tape on the joint between the dryer...
Owners Manual - Page 1
...
ge.com
Safety Instructions 2-4
Operating Instructions
Control Panel 5, 6 Control Settings 7 Features 8 Loading and Using the Dryer 10 Reversing the Door 9 Venting the Dryer 11
Troubleshooting Tips . . . 12, 13
Consumer Support
Consumer Support . . . . . Back Cover Warranty 15
Owner's Manual
DBLR333 DBSR453 DBXR300 DBXR463 DHDSR45 DHDSR46 DJXR433 DLLSR33 DLSR483 DRSR483 ...
Owners Manual - Page 2
...MUST be properly installed and located in the vicinity of all occupants.
4 Immediately call the fire department. Troubleshooting Tips
Consumer Support
PROPER INSTALLATION
This dryer must be exhausted to conform with the Installation Instructions before it will minimize incomplete combustion.
Safety Instructions
Operating Instructions
IMPORTANT SAFETY INFORMATION. I Install or...
Owners Manual - Page 3
... dryer. Some rubber materials, when heated, can reduce the flame retardancy of combustible materials, (lint, paper, rags, etc.), gasoline, chemicals and other appliance. I Keep the floor around your appliances clean and dry to cooking oils in your washer or dryer during operation.
I Do not store plastic, paper or clothing that have been removed. Observe all laundry...
Owners Manual - Page 4
... to this Owner's Manual or in your hand in them, by a qualified technician. WHEN USING YOUR DRYER (cont.)
I Do not tamper with an automatic electric ignition and does not have the skills to repair or replace any servicing unless specifically recommended in this appliance. I Do not attempt to carry out. I If yours...
Owners Manual - Page 5
... label on some models)
MEDIUM HEAT
3
1
2
Model DX4500
3
1
2
NOTE: Drying times will vary according to the type of heat used (Electric, Natural or LP gas), size of load, types of fabrics, wetness of clothes and condition of the dryer behind the door.
Model DVLR223
3
Model DX2300
AUTOMATIC REGULAR HEAT
2
MEDIUM HEAT
AUTOMATIC REGULAR HEAT
3
2
Models DS4500, DBSR453, DBXR463...
Owners Manual - Page 6
... the label on some models)
3
1
2
Models EED4500 and EGD4500
3
1
2
Model DLLSR33
3
1
2
NOTE: Drying times will vary according to the type of heat used (Electric, Natural or LP gas), size of load, types of fabrics, wetness of clothes and condition of the dryer behind the door. Model DBLR333
3
1
2
Models DJXR433, DRSR483, DWSR483, DWXR483, DLSR483, DQSR483...
Owners Manual - Page 7
...-free, permanent press and delicate items, and knits.
QUICK FLUFF For freshening or fluffing up already dry clothing, fabrics, linens and pillows. Use with an *.
Example: Drying a load of no heat tumbling.
3 Start-Close the dryer door. Select LESS DRY if you have chosen-for this load it would be the EASY CARE MED. To restart...
Owners Manual - Page 8
... the clothes are using the CYCLE SIGNAL knob and you select the WRINKLE CARE option, a signal will sound just before the end of no-heat tumbling after the laundry is not on, the dryer will remind you to unplug the dryer power cord or disconnect the dryer at the end of the signal.
If you are dry...
Owners Manual - Page 9
...on the dryer face. Insert these screws, secure each hinge on the opposite side (where you removed the filler plugs). With these screws about half way into the TOP holes, for each hinge. ge.com
Reversing the Door
Tools needed:
I ... Tips
Consumer Support
9 Apply firm pressure to get the screw started in step 1.
4 Remove the remaining screws from which the door was removed.
Owners Manual - Page 10
...°F)
Do not wring
BLEACH LABELS
Bleach symbols
Any bleach (when needed)
Only non-chlorine bleach (when needed)
Do not bleach
10
DRY LABELS
Tumble dry
Dry
Heat setting
High
Normal
Permanent Press/ Gentle/ wrinkle resistant delicate
Do not dry Do not tumble dry (used in all GE Dryers when used with a mild, non-abrasive cleaner suitable for the...
Owners Manual - Page 11
Safety Instructions
Operating Instructions
ge.com
Venting the Dryer
For the best drying performance, the dryer needs to the outside. Use only rigid metal or flexible metal 4″ diameter ductwork for exhausting to be properly vented. I Use only rigid metal 4″ diameter ductwork inside the
dryer cabinet. Correct Venting
Incorrect Venting
11
Troubleshooting Tips
Consumer Support...
Owners Manual - Page 12
... fuse/circuit breaker box and replace fuse or reset breaker. Troubleshooting Tips
Consumer Support
12 You may not need to an even floor space, or adjust leveling legs
Dryer may be seen when the clothes are fully open. Problem Dryer doesn't start
Dryer doesn't heat
Dryer shakes or makes noise Greasy spots on clothes
Lint on the following pages...
Owners Manual - Page 13
... dryers use 2 fuses/breakers, make sure the
dryer venting is correct.
• Replace fuses or reset circuit breakers. Overdrying
Letting items sit in dryer after drying. • If you are drying.... not machine wash or tumble dry it. Safety Instructions
Operating Instructions
ge.com
Problem Clothes take too long to dry
Clothes are wrinkled Clothes shrink
Possible Causes Improper sorting...
Similar Questions
Dryer Keeps Cutting Off Mid Cycle While Drying Clothes
(Posted by Mccoyurundi 1 year ago)
Dryer Squeaks
Dryer squeaks for the first 2-4 seconds when the cycle starts. It sounds like a bearing squeak. It's...
Dryer squeaks for the first 2-4 seconds when the cycle starts. It sounds like a bearing squeak. It's...
(Posted by RSchollerJr 7 years ago)
My Dryer Stop In Use It Keeps On Stopping And The Washer Cloth Smells
Pfws460dlww And Pfds450elww-dryer, I Notice My Dryer Stop After A Few Minutes And It Takes Time Caus...
Pfws460dlww And Pfds450elww-dryer, I Notice My Dryer Stop After A Few Minutes And It Takes Time Caus...
(Posted by MARITZAHERRERE 8 years ago)
Dryer Wont Dry, Do I Have To Install The Gas Line ?
I hooked up everything, except the gas line. Do I have to install the gas line for it to heat up ?
I hooked up everything, except the gas line. Do I have to install the gas line for it to heat up ?
(Posted by cc508art 10 years ago)
My Dryer Runs Clothes Get Hot But Don't Dry Unless I Run It For Long Time
(Posted by Amykaylor 10 years ago)