Garmin echo 100 Support Question
Garmin echo 100 Support Question
Find answers below for this question about Garmin echo 100.Need a Garmin echo 100 manual? We have 2 online manuals for this item!
Question posted by Huwtaylor446 on December 31st, 2011
Shows. Depth At 1.8 M Constant
New garmin 100 fitted to kayak transducer fitted inside kayak shows depth atv1.8 m constant tried adjusting pretty well everything on the menu battery is fitted pretty close to the transducer otherwise ??
.
Current Answers
Related Garmin echo 100 Manual Pages
Installation Instructions - Page 1
... a location that you can see as possible.
• Do not mount the transducer behind strakes, struts, fittings, water intake or discharge ports, or anything that creates air bubbles or causes the water to become turbulent.
If you operate your echo 100/150/200/300c/500c /550c. Do not tighten the 10-32 lock nut...
Installation Instructions - Page 2
... 1 in . (16 mm) drill bit to the echo device.
• If you are routing the cable using a pass-through the transom.
10. Apply marine sealant to the included 30 mm M5 screws, and loosely attach the transducer assembly to route the cable through hole.
11. Adjust the transducer assembly so that there is aligned parallel...
Installation Instructions - Page 3
...of debris. 8.
Route the transducer cable to the installation location of the echo device while taking the following precautions. • Avoid routing the cable close to route the cables from...or without the cables installed in the center ➌.
➌➊
6. Cutting the transducer cable will not become pinched when the trolling
motor is the appropriate distance from under the...
Installation Instructions - Page 4
...;➏ ➎
8. Pull out enough slack from the swivel-mount base.
7. Fastening the Swivel Mount with marine
➋
sealant.
➎
➊
Installing the echo Device in the upward position, place the echo
100/150/300c device ➋ or the echo 200/500c/550c cradle ➌ into the
swivel mount ➍.
➋
➌
➊
➊
➍...
Installation Instructions - Page 5
... Tilt the echo device forward and lift it down to the cradle ➋.
➌
4.
Testing the Transom Mount Transducer Installation
Notice When adjusting the depth of the ...fit only in the water, turn on the echo device.
2. Connecting the Cables to an echo 200/500c/550c On an echo 200/500c/550c device, the connectors on the cables are keyed to carry the sonar signal, the transducer...
Installation Instructions - Page 6
... 2nd Road, Sijhih, Taipei County, Taiwan
www.garmin.com Garmin reserves the right to peak) echo 200/300c
100 W/800 W 200 W/1,600 W 300 W/2,400 W
echo 500c/550c
500 W/4,000 W
Freshwater Depth*
echo 100 echo 150
600 ft. (183 m) 1,300 ft. (396 m)
echo 200/300c
1,500 ft. (457 m)
echo 500c/550c
1,900 ft. (579 m)
Saltwater Depth*
echo 100 echo 150
300 ft. (91 m) 500 ft. (152...
Owner's Manual - Page 1
echo™ 100 and echo 150
owner's manual
Owner's Manual - Page 2
... the content without obligation to change without the express permission of this document is strictly prohibited. echo™ is a trademark of Garmin Ltd. or its subsidiaries
All rights reserved. © 2011 Garmin Ltd. Visit the Garmin Web site (www.garmin.com) for any person or organization of this manual may not be reproduced, copied, transmitted...
Owner's Manual - Page 3
...
Contact Garmin Product Support if you should highlight a series of items on the screen using or keys (page 2), and press the ENTER key after each item. For example, if you see "select MENU > Pause," you have any questions about this manual, the term "select" is highlighted, and then press ENTER.
echo 100 and echo 150...
Owner's Manual - Page 4
... Backlight
1. Turning On and Turning Off the Device
Press and hold . Adjusting the Contrast
1. Press and quickly release . 2. Repeat to measure temperature. 4. Selects a menu item. Select Done.
Select or . 3. Scrolls through the brightness settings.
2
echo 100 and echo 150 Owner's Manual You can use the device the first time, you must also configure these settings...
Owner's Manual - Page 5
... device to turn on when power is displayed. From the Sonar screen, select MENU > Setup > Alarms > Beeper. 2. echo 100 and echo 150 Owner's Manual
Getting Started 3 Otherwise, press to turn on the device....only when alarms are selected, the menu disappears and your previous screen is applied.
Using Quick Adjust
After adjusting a setting and returning to the Sonar screen, select or .
Owner's Manual - Page 6
... Sonar Screen Manually
You can adjust the range of the depth scale that appears on the left , indicating suspended targets ➋. From the Sonar screen, select MENU > Range. 2. From the Sonar screen, select Menu > Zoom > Manual. 2. Using the echo 100 and echo 150
Using the echo 100 and echo 150
Sonar Screen
The sonar screen shows a full-view graph of the...
Owner's Manual - Page 7
... screen. 3. echo 100 and echo 150 Owner's Manual
Using the echo 100 and echo 150
Setting the Gain to decrease the gain. From the Sonar screen, select Menu > Gain. 2. From the Sonar screen, select Menu > Zoom > Auto. 2.
To set an alarm to 10 meters above the bottom.
1. Select to increase the gain setting until you begin to show . 3.
Adjusting the...
Owner's Manual - Page 8
... alarm to sound when the battery reaches a specified low voltage.
1. Selecting a Frequency for the echo 150
When using a dual frequency transducer. The 77 kHz frequency penetrates deep water more detail, especially while moving or trolling. From the Sonar screen, select MENU > Setup > Sonar > Fish ID. 2.
The 200 kHz frequency shows better detail, has a narrower beam...
Owner's Manual - Page 9
... Source Voltage Range Fuse Freshwater Depth
Saltwater Depth
Measurement 4 in . (250 mm)
echo 100: 200 kHz echo 150: 77 kHz or 200 kHz 10-20 Vdc
AGC/3AG - 3.0 A echo 100: 600 ft. (183 m) echo 150: 1300 ft. (396 m) echo 100: 300 ft. (91 m) echo 150: 500 ft. (152 m)
Appendix
Viewing System Information
From the Sonar screen, select MENU > Setup > System > System Information...
Owner's Manual - Page 10
... the Software, for which source code is protected under the United States of Garmin and/or its subsidiaries ("Garmin") grant you a limited license to human readable form the Software or any part thereof or create any other applicable country.
8
echo 100 and echo 150 Owner's Manual You agree not to decompile, disassemble, modify, reverse assemble...
Owner's Manual - Page 12
Liberty House, Hounsdown Business Park, Southampton, Hampshire, SO40 9LR UK
Garmin Corporation No. 68, Jangshu 2nd Road, Sijhih, Taipei County, Taiwan
www.garmin.com
Part Number 190-01312-00 Rev. or its subsidiaries
Garmin International, Inc. 1200 East 151st Street, Olathe, Kansas 66062, USA
Garmin (Europe) Ltd. A
Printed in Taiwan January 2011
© 2011 Garmin Ltd.
Similar Questions
How Do I Go Into Simulation Mode On A Garmin Marine Gps Modle741xs
how do I use simulation mode on a garmin 741xs marine ver
how do I use simulation mode on a garmin 741xs marine ver
(Posted by Curthupp 6 years ago)
I Can't Get The Simulator Mode To Turn Off When I Plug In The Depth Finder.
(Posted by edgriffith 10 years ago)
541s Marine Gps. Depth Not Reading Out.
Depth has been working since installed. Now blank. Is there an on off control for this that may have...
Depth has been working since installed. Now blank. Is there an on off control for this that may have...
(Posted by therad50 11 years ago)
Why Does The Simulation Stay On. It Says No Transducer.
(Posted by sharon081162 12 years ago)