2008 GMC Canyon Support Question
2008 GMC Canyon Support Question
Find answers below for this question about 2008 GMC Canyon.Need a 2008 GMC Canyon manual? We have 1 online manual for this item!
Question posted by asad1Johnny on August 20th, 2014
How To Remove Vacuum Hose On A Gmc Canyon
The person who posted this question about this GMC automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 1
2008 GMC Canyon Owner Manual
Seats and Restraint Systems ...1-1 Front Seats ...1-2 Rear Seats ...1-9 Safety Belts ...1-12 Child Restraints ...1-33 Airbag System ...1-60 Restraint System Check ...1-75 Features and ...
Owner's Manual - Page 2
..., MI 48207 1-800-551-4123 www.helminc.com
GENERAL MOTORS, GM, the GM Emblem, GMC, the GMC Emblem, and the name CANYON are registered trademarks of this model, but your dealer/retailer or from your vehicle may have... latest information at the time it appears in the vehicle for GMC whenever it was printed.
Part No. 15866158 A First Printing ii
©
2007 General Motors Corporation.
Owner's Manual - Page 34
{CAUTION:
A safety belt that the shoulder belt crosses the shoulder. To remove and store a comfort guide, squeeze the belt edges together so that you can take them out of the body are best able to take belt ...
Owner's Manual - Page 51
...47 Do not secure a child restraint in an extended cab model are located on the back wall behind a removable cover for the rear seating positions. Regular and Extended Cab without Rear Seats For regular and extended cab models ...a position without rear seats, there is a top tether anchor located behind a removable cover on the center of the back wall behind the right front passenger seat.
Owner's Manual - Page 53
... if a shoulder belt is no contact between the child restraint LATCH attachment parts and the vehicle's safety belt assembly may cause damage to tighten. When removing the child restraint, always remember to return the safety belts to the child restraint instructions and the following steps: 2.1. If the child restraint manufacturer's instructions...
Owner's Manual - Page 56
... Right Front Seat Position on page 1-56 for instructions on the finger access tab to remove the cover to the nearest top tether anchor (C). 3. Pull on installing the child restraint using ...anchor. Pull on page 1-8. 2.2. See Seatback Latches on the finger access tab to remove the cover to the child restraint instructions and the following steps:
Front Seat - Regular/Extended ...
Owner's Manual - Page 59
... back all the way out of the belt, and feed the shoulder belt back into the retractor. If your knee to set the lock. 5. To remove the child restraint, unbuckle the vehicle's safety belt and let it helpful to use your child restraint has a top tether, attach the top tether to...
Owner's Manual - Page 63
...child restraint. See Lower Anchors and Tethers for Children (LATCH) on page 1-43. 9. To remove the child restraint, unbuckle the vehicle's safety belt and let it helpful to use your dealer/...is attached to be sure it .
1-59 If this happens, adjust the head restraint. 7. Remove any additional material from the vehicle and reinstall the child restraint. If a child restraint has been...
Owner's Manual - Page 75
... the vehicle's seatback is not pressing the child restraint into the seat cushion. Remove the child restraint from the seat such as a child who has outgrown child.... If this happens, adjust the head restraint. See Passenger Airbag Status Indicator on page 1-7. Remove any additional material from the vehicle and reinstall the child restraint following the child restraint manufacturer's ...
Owner's Manual - Page 76
... the passenger airbag status. For some adult size occupants. If a person of adult-size is sitting in the right front passenger's seat, but the off , remove any additional material from the seat, such as blankets, cushions, seat covers, seat heaters or seat massagers and ask the person to place the seatback...
Owner's Manual - Page 86
... transmitters matched to it is coded to prevent another transmitter from your vehicle. If you go to your RKE transmitter should last about two years.
Remove and replace the battery with you when you have a maximum of the circuitry. Notice: When replacing the battery, use , the battery in the slot between...
Owner's Manual - Page 88
All the doors will unlock when the key is removed from the factory to lock all doors automatically when the shift lever is moved out of PARK (P). Driver's Switch Shown, Front Passenger's Switch Similar Press L (...
Owner's Manual - Page 91
... the bracket off of the bolt. 3.
Slide the lower end fitting onto the top bolt. Removing the Tailgate
Follow these steps if you , then move the tailgate to the right to release the driver...Down 2. With the tailgate partially down, lift up slightly on the bracket. 2-11 You can then remove the entire tailgate assembly. Make sure it is over the bolt, slide the bracket off of the ...
Owner's Manual - Page 97
...® III+ uses a radio frequency transponder in the key that may not be undamaged, try again. The system is automatically disarmed when the key is removed from the ignition. This device may not cause harmful interference. 2. PASS-Key® III+ Operation (Canada Only)
Your vehicle has a passive theft-deterrent system. This...
Owner's Manual - Page 98
... programmed for the vehicle. After the engine has started , turn the key to LOCK/OFF, and remove the key.
4. If the engine will not start see your dealer/retailer for service. 3. If ... first key may be programmed and turn it to ON/RUN within ten seconds of removing the previous key. If the engine will not start see your dealer/retailer for service. 5....
Owner's Manual - Page 99
... constant speed, fast or
slow, for the first 500 miles (805 km). Make sure the key is removed. See Towing a
Trailer on page 4-44 for the first 200 miles
(322 km) or so. Starting... key in guideline every time you can turn the key only with new linings can be able to remove your key when the ignition is a theft-deterrent feature. But it will only be gradually increased. ...
Owner's Manual - Page 100
... the ACC/ACCESORY or ON/RUN position with the keys inside, as the radio or items plugged into the accessory power outlets. Always remember to remove your vehicle must be pushed or towed. (C) ON/RUN: This is in ACC/ACCESSORY or LOCK/OFF and the key is parked.
If you have...
Owner's Manual - Page 294
... full turn the pressure cap.
1. Wait for the cooling system and radiator pressure cap to remove it . Keep turning the cap to cool if you badly.
Fill the radiator with the proper..., there is hot. Add the proper mixture directly to turn . Remove the radiator pressure cap when the cooling system, including the upper radiator hose, is cool before you can try. If you hear a hiss...
Owner's Manual - Page 359
... may require more frequent cleaning. The spare tire is recommended to 500 miles (804 km). Regular vacuuming is made to perform well at speeds up to 62 mph (100 km/h) for distances up to remove particles from becoming and remaining heavily soiled. After installing the spare tire on your vehicle, you should...
Owner's Manual - Page 361
... area for colorfastness first. Continue cleaning, using one of the soil as possible
and then vacuum. When a commercial upholstery cleaner or spot lifter is not completely removed, use the following techniques:
3. Before cleaning, gently remove as much as possible using a clean area of the soil and gently rub toward the center. If...
Similar Questions
How Do You Change A Camshaft Sensor On A 2008 Gmc Canyon Does It Have To Relearn
i know where it is but after changing it do you have to have it relearned or can it relearn itself a...
i know where it is but after changing it do you have to have it relearned or can it relearn itself a...
(Posted by chrislago 11 years ago)
Vacuum Hose Connection
there is a vacuum hose on driver side that it has 3 connections 2 are still connected but the 3rd is...
there is a vacuum hose on driver side that it has 3 connections 2 are still connected but the 3rd is...
(Posted by dragonfly43 12 years ago)