2008 GMC Canyon Support Question
2008 GMC Canyon Support Question
Find answers below for this question about 2008 GMC Canyon.Need a 2008 GMC Canyon manual? We have 1 online manual for this item!
Question posted by chrislago on May 14th, 2013
How Do You Change A Camshaft Sensor On A 2008 Gmc Canyon Does It Have To Relearn
i know where it is but after changing it do you have to have it relearned or can it relearn itself after so many key cranks
Current Answers
Related Manual Pages
Owner's Manual - Page 1
2008 GMC Canyon Owner Manual
Seats and Restraint Systems ...1-1 Front Seats ...1-2 Rear Seats ...1-9 Safety Belts ...1-12 Child Restraints ...1-33 Airbag System ...1-60 Restraint System Check ...1-75 Features and Controls ...2-1 Keys ...2-3 Doors and Locks ...2-7 Windows ...2-12 Theft-Deterrent Systems ...2-15 Starting and Operating Your Vehicle ...2-19 Mirrors ...2-39 OnStar® System ...2-47 ...
Owner's Manual - Page 2
We reserve the right to make changes after that may be available in this manual in the vehicle for GMC whenever it was printed. For vehicles first sold in ..., MI 48207 1-800-551-4123 www.helminc.com
GENERAL MOTORS, GM, the GM Emblem, GMC, the GMC Emblem, and the name CANYON are registered trademarks of them. For example, more than one entertainment system may not have been...
Owner's Manual - Page 40
... the safety belts.
1-36 Infants and Young Children
Everyone in a vehicle and never allow children to some age must be thrown out of the traveler changes the need to use safety restraints. In fact, the law in every state in the United States and in a vehicle.
An infant does not weigh...
Owner's Manual - Page 70
...at a reduced level or at a level less than full deployment. Your vehicle has seat position sensors which help the sensing system distinguish between a moderate frontal impact and a more severe frontal impacts,...by what the repair costs were. See Airbag System on page 1-60. Seat position sensors provide information that is determined by the location and severity of the damage to severe ...
Owner's Manual - Page 74
... are safer if they are designed to secure the child restraint in the rear rather than the front seat. The passenger sensing system works with sensors that are large enough, using safety belts. The...
Owner's Manual - Page 78
... for you is disconnected, an airbag can affect the operation of the passenger's seat. Changing or moving any parts of the airbag system. They are probably part of the front seats...wheel, instrument panel, roof-rail airbag modules, ceiling headliner or pillar garnish trim, front sensors, or airbag wiring can still inflate during improper service. Avoid yellow connectors. ...
Owner's Manual - Page 79
... Customer Assistance. If a belt is working properly. See Safety Belt Reminders on top of the seat fabric, could either prevent proper deployment of the airbag sensors, sensing and diagnostic module and airbag wiring.
1-75 Keep safety belts clean and dry.
If you have any other loose or damaged safety belt system...
Owner's Manual - Page 84
...the Remote Keyless Entry (RKE) system, it operates on page 7-7. Notice: If you ever lock your keys in . Be sure you may have to damage the vehicle to get in your dealer/retailer
or ...you are still having trouble, see your vehicle, you have to stand closer to make new keys.
Changes or modifications to this system by other than an authorized service facility could void ...
Owner's Manual - Page 86
... matched. Notice: When replacing the battery, use , the battery in the slot between the covers of four transmitters matched to it is probably time to change the battery. Remove and replace the battery with you when you have a maximum of the transmitter housing. To replace the battery:
Battery Replacement
Under normal...
Owner's Manual - Page 88
To change the automatic door lock and unlock settings, see "Automatic Door Locks" under DIC Operation and Displays on the driver's and ...factory to lock all the doors when the vehicle speed is greater than 15 mph (24 km/h). All the doors will unlock when the key is removed from the rear seating areas.
2-8 If your vehicle has power door locks, the switches are located on page 3-38. Driver...
Owner's Manual - Page 97
... may not cause interference. 2. This device may not cause harmful interference. 2. Changes or modifications to start your vehicle. At this time, you may ... vehicle. You do not have to ON/RUN. The security light will start , and the key appears to check the fuse. The key uses a transponder that may also want to be a problem with your vehicle. This device complies...
Owner's Manual - Page 102
... gasoline. To Use the Engine Coolant Heater
1. If the engine does not start and the key is designed to work with the electronics in START for easier starting your vehicle. Operate the ...not start after starting it could change the way the engine operates. Any resulting damage would not be covered by turning the ignition switch to let the cranking motor cool down . When the...
Owner's Manual - Page 107
... the transmission. Ignore the shift light when you accelerate, it is in four-wheel low. For more than one gear at a time when you quickly change the position of your warranty. While you downshift. For the best fuel economy, accelerate slowly and shift when the light comes on page 3-30.
Owner's Manual - Page 121
... not display the correct heading
and the compass zone variance is set correctly. For more information, see your dealer/retailer. Press the button again to change the display to start. In order to calibrate, CAL must be caused by driving the vehicle in the mirror compass windows. The indicator light on...
Owner's Manual - Page 126
... Mirrors
If your vehicle has this feature, the controls are located on your shoulder before driving. Return the selector switch to the unfolded position before changing lanes. Move the selector switch to the L (left) or R (right) to move the mirror in that direction. The passenger side mirror is curved so more...
Owner's Manual - Page 147
..., roof marker lamps, and the instrument panel lights will turn on at normal brightness. Your vehicle has a light sensor located on the top of the Daytime Running Lamps (DRL) and the automatic headlamp system so that delay, the ... . The DRL and automatic headlamp system will not be affected when the light sensor detects a change to DRIVE (D). Automatic Headlamp System
When it .
Owner's Manual - Page 326
... must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this equipment.
At the same time, a ... illuminates the low tire pressure warning light located on the DIC display screen. TPMS sensors are inflated to a receiver located in flation pressure.
5-66 This device may not cause harmful...
Owner's Manual - Page 329
... pressure for 10 seconds, then stop and listen for the driver side rear tire, the sensor relearn process has not been successful. After hearing the confirming horn chirp for the driver... switch to see if the TPMS low tire warning light and the DIC LOW TIRE messages have been relearned. Put the valve caps back on the Driver Information Center (DIC). 4. The TPMS warning light should...
Owner's Manual - Page 403
...assistance is provided when the vehicle is Covered? Who is mired in Canada, call , 1-800-GMC-8782 (1-800-462-8782); (Text telephone (TTY): 1-888-889-2438). In Canada, a... your vehicle. In Canada, the vehicle registration is responsible for coverage.
• Flat Tire Change: Installation of a vehicle-disabling crash. To ensure security, the driver must present personal identi&#...
Owner's Manual - Page 405
... vehicle provides detailed warranty coverage information.
and Canada.
GMC and General Motors of course, the problem is not... Several courtesy transportation options are available to make any changes or discontinue the Roadside Assistance program at any time .... If it can help minimize your dealership/retailer, let them know this, and ask for vehicles operated on a non-public roadway...
