Get support for Fujitsu MHY2250BH - Mobile 250 GB Hard Drive

Fujitsu MHY2250BH Support Question

Fujitsu MHY2250BH Support Question

Find answers below for this question about Fujitsu MHY2250BH - Mobile 250 GB Hard Drive.
Need a Fujitsu MHY2250BH manual? We have 1 online manual for this item!
Question posted by bselff on June 29th, 2010

Format

Is there a low level format software available for this drive? I have one which has a bad block and I can't access it. There used to be software for cleaning this when i was in IT many years ago. Thanks, Bob

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Fujitsu MHY2250BH Manual Pages

Manual/User Guide - Page 1

C141-E262 3-1 CHAPTER 3 Installation Conditions 3.1 Dimensions 3.2 Mounting 3.3 Connections with Host System This chapter gives the external dimensions, installation conditions, surface temperature conditions, cable connections, and switch settings of the hard disk drives.
Manual/User Guide - Page 2

... user tap to the center of the connector pins *5 Dimension from the outer edge of the user tap to the innermost edge of the disk drive. Installation Conditions 3.1 Dimensions Figure 3.1 illustrates the dimensions of the connector pins Figure 3.1 Dimensions 3-2 C141-E262
Manual/User Guide - Page 3

...) other than parts to Signal Ground (SG). C141-E262 3-3 The tightening torque must be mounted in Figure 3.2. Use M3 screw for the mounting screw and the screw length should satisfy the specification in any direction. (2) Frame The ...on mounting, see the "FUJITSU 2.5-INCH HDD INTEGRATION GUIDANCE (C141-E144)." (1) Orientation The disk drives can be 0.49N•m (5kgf•cm).
Manual/User Guide - Page 5

For breather hole of Figure 3.3, at least, do not allow its around φ 3 to close during mounting. 3.2 Mounting Because of breather hole mounted to the HDD, do not allow this to block. Locating of breather C141-E262 3-5 Figure 3.3 Location of breather hole is shown as Figure 3.3.
Manual/User Guide - Page 6

... in a cabinet refer to prevent the DE surface cover temperature from the disk drive. Provide air circulation in the cabinet such that the PCA side, in Section 1.4, and the airflow must be considered to the ambient temperature at a point 3 ...
Manual/User Guide - Page 7

... touch the printed circuit board, but hold it too hard, the cover and the spindle motor contact, which may cause damage to the disk drive. 3.2 Mounting (5) Service area Figure 3.5 shows how the drive must be accessed (service areas) during and after installation. Ensure that the disk drive is not affected by the edges. (6) Handling cautions...
Manual/User Guide - Page 8

... - HDD is occasionally damaged by the impact of the driver. (2) Please observe the tightening torque of a low impact when you use the driver of the screw strictly. General notes Wrist strap Use the Wrist strap. Installation (1) Please use an electric driver. Do not stack when carrying. M3 0.49N • m (5 kgf • cm). - Do not...
Manual/User Guide - Page 9

3.3 Connections with Host System 3.3 Connections with Host System 3.3.1 Device connector The disk drive has the SATA interface connectors listed below for connecting external devices. SATA interface and power connectors PCA Figure 3.7 Connector locations C141-E262 3-9 Figure 3.7 shows the locations of these connectors and terminals.
Manual/User Guide - Page 10

... the connector on the customer's system and select it from the PCA side Figure 3.8 Power supply pins (CN1) 3.3.3 Connector specifications for mating with the disk drive must be compliant with the host system. Installation Conditions 3.3.2 Signal segment and power supply segment Figure 3.8 shows each segment of requirements about SATA interface connector...
Manual/User Guide - Page 11

...Host System 3.3.4 SATA interface cable connection The cable that connects the disk drive to the host system must be sure to connector damage and the ...a SATA interface cable into the SATA interface connector of the disk drive and plugging the connector into a host receptacle: When plugging together the disk drive SATA interface connector and the host receptacle or SATA interface cable connector,...

Similar Questions

Ask a New Question
Use the box below to post a new question about this Fujitsu product .
Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Fujitsu Manuals

Find free Fujitsu MHY2250BH - Mobile 250 GB Hard Drive manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Fujitsu Reviews

View thousands of Fujitsu user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Fujitsu customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Fujitsu customer service rankings, employee comments and much more from our sister site.

Fujitsu Recalls

Find comprehensive Fujitsu recall information updated hourly on RecallOwl.com.