Fujitsu MHV2100AT Support Question
Fujitsu MHV2100AT Support Question
Find answers below for this question about Fujitsu MHV2100AT - Mobile 100 GB Hard Drive.Need a Fujitsu MHV2100AT manual? We have 1 online manual for this item!
Question posted by timhouseofpain on February 6th, 2012
Installation Guides Fujitsu Mhv2100at Hardrive
The person who posted this question about this Fujitsu product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by kcmjr on February 6th, 2012 12:51 PM
kcmjr
Member since:
May 5th, 2011 Points: 4,254,255
Member since:
May 5th, 2011 Points: 4,254,255
Grab a copy here:
Licenses & Certifications: Microsoft, Cisco, VMware, Novell, FCC RF & Amateur Radio licensed.
Related Fujitsu MHV2100AT Manual Pages
Manual/User Guide - Page 2
... without further notice and without the express written permission of all information in this manual handy, and keep it carefully. All Rights Reserved, Copyright FUJITSU LIMITED 2004 Keep this manual, its updates or supplements, whether such errors or omissions result from suffering damage to prevent users and bystanders from being...
Manual/User Guide - Page 5
... does not perform the procedure correctly. Preface
This manual describes the MHV2120AT, MHV2100AT, MHV2080AT, MHV2060AT, MHV2040AT 2.5-inch hard disk drive with the ATA interface. This manual assumes that damages to the product or other property may be referred to maintain the disk drives. An alert message consists of an alert symbol and a signal word...
Manual/User Guide - Page 6
...
C141-F072 The following is an example:
(Example)
Don't install or remove a PCA or connect or disconnect a cable or connector plug when the drive is designed to the address described in the sheet.
Preface
In...alert message begins and ends. Attention
Please forward any other causes outside the disk drive. Fujitsu is not liable for users to the Product Manual (C141-E218). A wider line...
Manual/User Guide - Page 7
...or moderate personal injury if the user does not perform the procedure correctly. Avoid dangerous detergent when the disk drive is powered. Also, damage to the predate or other property, may occur if the user does not perform...the key alert messages given below. Alert message
Page
Static, Damage
1. Don't install or remove a PCA or connect or disconnect 1-2 a cable or connector plug when the...
Manual/User Guide - Page 8
...
The DE is not responsible for repair, save all boards installed.
4. Fujitsu Limited is completely sealed.
iv
C141-F072 Don't install or remove a PCA or connect or disconnect a cable or connector plug when the drive is always connected to overheat.
6. Before touching a PCA or the drive, wear a wrist strap
1-2
and perform the human body grounding...
Manual/User Guide - Page 9
... Maintenance
Important Alert Items
Alert message
Page
Damage or Device damage
1. C141-F072
v The cable must not be
disconnected and the screws that attach the drive must
not be removed with the power ON.
2. Perform the human body grounding to discharge any removal after the power is
2-2
completely disconnected. Perform any...
Manual/User Guide - Page 11
... 3. Operations
MHV2120AT, MHV2100AT MHV2080AT, MHV2060AT
MHV2040AT
DISK DRIVE MAINTENANCE MANUAL
1. Device Overview 2. Maintenance and Diagnosis 2. Theory of Device Operation 5. Removal and Replacement Procedure
C141-F072
vii Manual Organization
MHV2120AT, MHV2100AT MHV2080AT, MHV2060AT
MHV2040AT
DISK DRIVE PRODUCT MANUAL
(C141-E218)
1. Installation Conditions 4. Interface...
Manual/User Guide - Page 13
... and test equipment 1-8 Self-diagnostics 1-8 Test...1-8
1.2 Operation Confirmation 1-10 1.2.1 Operation test 1-10 1.2.2 Diagnostic test 1-11
1.3 Troubleshooting Procedure 1-11
1.3.1 Troubleshooting procedure 1-11 1.3.2 Troubleshooting disk drive replaced in field 1-11 1.3.3 Troubleshooting at factory 1-13
CHAPTER 2 Removal and Replacement Procedure 2-1
2.1 Spare Parts 2-2 2.2 Disk...
Manual/User Guide - Page 14
Contents
Illustrations
Figures Tables
Figure 1.1 Disk drive revision number label 1-6 Figure 1.2 Display of disk drive revision number 1-7 Figure 1.3 Test flowchart 1-9
Table 1.1 Table 1.2 Table 1.3
Status register contents 1-10 Disposition for error register contents 1-10 System level and field troubleshooting 1-12
Table 2.1 Model and parts numbers 2-2
x
C141-F072
Manual/User Guide - Page 15
...following are explained: • Rules for regular maintenance and troubleshooting • Display of maintenance level (field and factory) • Display of the disk drive. CHAPTER 1 Maintenance and Diagnosis
1.1 Maintenance 1.2 Operation Confirmation 1.3 Troubleshooting Procedure
This chapter describes the maintenance, diagnosis, operation check, and troubleshooting of machine revision number...
Manual/User Guide - Page 16
... to discharge static electricity from mechanical assemblies in the unit during troubleshooting or maintenance. Keep all boards installed. 4. Before touching a PCA or the drive, wear a wrist strap and
perform the human body grounding to the disk drive. 3. This will prevent irreparable damage to the cover under any detergent which may cause short circuits...
Manual/User Guide - Page 17
... Section 1.7 and 3.2 in Product Manual.
(3) Exchangeable parts in field
The PCA and the DE cannot be changed. Replace the whole disk drive.
(4) Service system and repair
Fujitsu Limited has a disk drive service system and repair facility. When the DE surface temperature exceeds 48°C, the life is completely sealed. Device damage The DE...
Manual/User Guide - Page 18
...drive unit comes to a complete stop after the device is up and be careful not to the interface connector section. Fujitsu... unnecessarily. Do not place the device directly on a hard table, place it on the following precautions, be careful...do not change the switch setting, or connecting, or disconnecting connectors.
Installation
a) When the power is required to wait more severe than 30 ...
Manual/User Guide - Page 19
...that the whole disk drive be used, use a shock absorbent box that will replace the drive.
(2) Factory maintenance (parts replacement)
• Only Fujitsu can perform maintenance at...prevent condensation, do not subject the device to Section 3.2 of the MHV2120AT, MHV2100AT, MHV2080AT, MHV2060AT, MHV2040AT Disk Drives Product Manual. 1.1 Maintenance
b) It is recommended that you use the shock ...
Manual/User Guide - Page 20
... as described above.
1-6
C141-F072
The level is indicated by a single alphanumeric character. Note:
For a change of revision number after delivery, Fujitsu issues a "Change Request/Notice" and the disk drive revision number after the change is stuck on the DE and marked on the revision number label. When a change . Figure 1.1 shows the...
Manual/User Guide - Page 26
...If the AC voltage level is abnormal, or if there is a lot of the MHV2120AT, MHV2100AT, MHV2080AT, MHV2060AT, MHV2040AT Disk Drives Product Manual for normal operation with the system.
1-12
C141-F072 For suggestions to isolate ...at the power supply section and recheck the DC voltage level at the disk drive control PCA is less than 100 mV peak to peak and 200 mV peak to be done, execute the ...
Manual/User Guide - Page 30
...MHV2100AT MHV2080AT MHV2060AT MHV2040AT
Capacity (user area)
120GB 100GB 80GB 60GB 40GB
Mounting screw
Order No.
The cable must not be disconnected and the screws that attach the drive and remove the drive...procedures, with notes, are as follows.
b) Remove the screws that attach the drive must be removed with section 1.1.2 (5) d. Removal and Replacement Procedure
2.1 Spare Parts...
Manual/User Guide - Page 31
... DWF
D
dB A-scale weighting Direct current Disk enclosure Device/head register Drive ready Data request bit Drive seek complete Drive write fault
E
ECC Error checking and correction
ER
Error register
ERR Error
F
FR
Features register
G
GB
Giga byte
HA HDD
H
Host adapter Hard disk drive
IDNF IRQ14
I
ID not found Interrupt request 14
L LED Light emitting...
Manual/User Guide - Page 33
... 1-5 Delivery 1-5
revision number marking 1-6
Diagnostic test 1-11 Disk drive
replaced, troubleshooting 1-11 replacement 1-5 revision number 1-6 revision number label...Firmware code and revision 1-6
G
General note 1-4
H
Handling, note 1-4
I
Initial self-diagnostics 1-8 Installation 1-4
L
Level, maintenance 1-5
M
Maintenance 1-1
level 1-5 requirement 1-3
Maintenance and diagnosis 1-1 Model 2-2
...
Manual/User Guide - Page 35
....
Date issued:
Name: Company or organization:
Manual name:
MHV2120AT, MHV2100AT, MHV2080AT MHV2060AT, MHV2040AT DISK DRIVE MAINTENANCE MANUAL
Manual code: C141-F072-01EN
Address:
Comments:
Page
Line...Technical level:
Too high
Appropriate
Too low
Overall rating of distribution in FUJITSU. READER'S COMMENT FORM
Your comments or suggestions on this form to the section in ...
Similar Questions
Fujitsu Mhw2080at - Mobile 80 Gb Hard Drive
How many cylinders, heads and sectors have the mobile hard drive Fujitsu MHW2080AT???
How many cylinders, heads and sectors have the mobile hard drive Fujitsu MHW2080AT???
(Posted by elkohrastralro 6 years ago)
Where Can I Download A User Guide For A Fujitsu Mhy2160b Usb Drive?
(Posted by billhowes 9 years ago)
How To Delete A (mac) Segment Once Installed?
my MHZ2320 BJ was split into 2 segments MAC and WIN; now I need more space for the WINDOWS so I want...
my MHZ2320 BJ was split into 2 segments MAC and WIN; now I need more space for the WINDOWS so I want...
(Posted by tomhoekstra 11 years ago)
L Need The Driver For The Hard Drive Fujitsu Mhv2080ah 80 Gb Driver
fujitsu MHV2080AH 80 GB l need the driver for it thanks
fujitsu MHV2080AH 80 GB l need the driver for it thanks
(Posted by pauls144 12 years ago)
Where Can I Find A Driver For Fujitsu Mhy2250bh Cd-rom Drive?
(Posted by hlw 12 years ago)