Home » Frigidaire » Ice Machines » Frigidaire IM115

Frigidaire IM115 Support Question

Find answers below for this question about Frigidaire IM115 - Ice Maker Kit.
Need a Frigidaire IM115 manual? We have 1 online manual for this item!

Frigidaire Overview Questions Manuals Reviews Videos Research

Question posted by bjs032960 on July 9th, 2010

Frigidaire Im115 Problems

I installed an im115 ice maker. After all the connections were made, nothing happened. The valve never turned on. The instructions said it would could take up to 24 hours before ice is made. Does that mean no water will flow?.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Frigidaire IM115 Manual Pages

User Manual - Page 1

...; Copper tubing is used for cleaning. Water supply tubing made of the unit to install the ice maker kit. • 1/4 inch copper supply line with shut off valve are available in areas where temperatures fall below freezing. • Connect the ice maker to order one , contact your model does not have one . ICE MAKER INSTALLATION INSTRUCTIONS To avoid electric shock, which can cause...

User Manual - Page 2

Ice Container 3. Qty 1 9. Water Valve - Qty 1 Tools Required: • Putty Knife • ¼ inch Socket Wrench or Nut Driver • Knife • Pliers • Needle Nose Pliers • Adjustable Wrench 2 Screws - Leveling Bracket Screw - Qty 1 7. Plastic Clamp - Use This Page to Identify Parts 1. Plastic Water Supply Tubing 4. Ice Maker 2. Screws - Qty...

User Manual - Page 3

... off label covering ice maker hole. 7. Push water inlet tube into small hole on shelf to rear of refrigerator and locate left until flat surface of inlet tube is tight against back of shelf is mounted inside freezer compartment with putty knife. 6. DO NOT remove compressor sound baffle (A), if installed.Carefully bend condenser out...

User Manual - Page 4

....Tighten screws. Make sure connection is same at top and bottom. 9. Adjust leveling bracket (7) to level ice maker (1). Make sure water inlet tube (11) is sitting inside fill cup. 11. Tighten another one hand, plug ice maker connector into connector mounted on bottom of inlet tube. Mount ice maker onto two screws (5) you installed in one half turn with screw (6).

User Manual - Page 5

... cabinet with two plastic clamps (9). On refrigerators with a Phillips® head bit to water valve. 15. Set ice container (2) on shelf. 18. Push plastic water supply tubing into cabinet. 19. Use a power drill with dynamic condensers, remount sound baffle, if installed. Connect wiring harness to drive the two self drilling screws (4) through cabinet liner. On models...

User Manual - Page 6

...• A shutoff valve to connect the water supply line to a household cold water line with a wrench; Chemicals from your water supply line connections comply with all local plumbing codes. NOTE: Water line kit number 5303917950, available from the softener may damage the ice maker, causing it greatly increases the potential for the water supply line. Turn ON water supply and flush supply...

User Manual - Page 7

... from tray • Ice dropping into ice container • Running water • Water valve opening or closing DO NOT place the ice container in warm water with mild detergent. The ice maker will be sure the wire signal arm is in its “up ” or OFF position. Do not connect the ice maker to the closed position. 7 Automatic Ice Maker Tips Remember that...