Home » Frigidaire » Dishwashers » Frigidaire FFBD2411NB

Frigidaire FFBD2411NB Support Question

Find answers below for this question about Frigidaire FFBD2411NB.
Need a Frigidaire FFBD2411NB manual? We have 6 online manuals for this item!

Frigidaire Overview Questions Manuals Reviews Videos Research

Question posted by drfouts on November 4th, 2016

Hi Temp And Heat(dry) Indicators Blink Before Wash And Dry Cycles Are Complete.

At times the Hi Temp and Heat(dry) indicators on the panel blink simultaneously but this happens before the wash cycle is complete. (While those two indicators are blinking green the other indicator (washing/drying/clean) no longer have the green indicator light. The dishes are not dry yet at this point. Please tell me if I should start the entire wash again or can I just give it the rinse cycle and be done with it. Thanks you, Esther Fouts

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Odin on November 4th, 2016 3:59 PM

This answer was accepted by the poster of the original question.

Odin

Member since:
April 10th, 2010

Points: 41,236,700

1,090
points

See https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Dishwasher/28-2--RkZCRDI0MTFOQiA=/Frigidaire-Dishwasher-lights-flashing-or-blinking. Good luck!

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Frigidaire FFBD2411NB Manual Pages

Installation Instructions (English) - Page 1

...plastic tub will be between the unit and cabinets once installation is complete. (This kit is metal, cover all sides of the dishwasher (including the underside of the countertop) be connected to a ...If cabinet wall is included on either side of the kitchen sink for the first time, knock out plug located inside disposer inlet before starting installation. Tighten elbow with owner...

Installation Instructions (English) - Page 2

...the water inlet valve will not get scratched or damaged while completing installation. 5. All wiring connections must not come in literature... of the tub. Leveling Dishwasher 5 within 6" of top door edge over end of valve and clean filter screen. Check that ...and flooding may occur. To Install a Custom Wood Panel The dishwasher door panel can order the side mount kit, 154477201, by ...

Complete Owner's Guide (English) - Page 1

... 154881701 (January 2012) TABLE OF CONTENTS Important Safety Instructions 2 Product Registration 3 Dishwasher Features 4 Operating Instructions 5-6 Preparing and Loading Dishes 7-9 Dishwasher Dispenser and Detergents 10 Factors Affecting Performance 11 Care and Cleaning 12 Solutions to Common Dishwashing Problems .. 13-14 Warranty 15 www.frigidaire.com USA 1-800-944-9044 www...

Complete Owner's Guide (English) - Page 2

...completely empty before running dishwasher. • Repairs should be hot to operate on regular house current (120 V, 60 Hz). Use care and do not let small children play on all hot water faucets and let water flow from the vent may be washed: - Check with controls. • Do not touch the heating...flame during or immediately after the end of cycle. • Water vapor from each for ...

Complete Owner's Guide (English) - Page 3

...! 3 Read Before Operating Your Dishwasher! The next sound you for the wash and drain portions of your Product Registration Card in sound as the upper arms spray water. PLEASE BE ADVISED: If you compare this page to customer satisfaction and product quality throughout the service life of the cycle you may not- PRODUCT...

Complete Owner's Guide (English) - Page 4

... water heating in the main wash and final rinse of all cycles. When HI-TEMP WASH is selected, an even higher temperature will be reached to reset each time. Add rinse aid, if needed . Hot water is necessary to latch. 5. The number of water fills will glow when selected. 7. Add detergent (See Dishwasher Dispenser & Detergents). 3. The indicator light...

Complete Owner's Guide (English) - Page 5

... and will enhance drying performance. An indicator light on the lock graphic pad will remain on until the lock is released. OPERATING INSTRUCTIONS Options Selections (*available on select models) * Hi-Temp Wash When HI-TEMP WASH option is selected, the dishwasher heats water in the main wash to use the HEAT DRY option costs pennies per cycle. HITEMP WASH is automatically provided...

Complete Owner's Guide (English) - Page 6

... heated or unheated dry is an interruption of the drain, select the next desired cycle. 6 If the dishwasher did not properly sanitize the dishes, the light will turn off . * Status Indicator Lights The WASHING light comes on at least 120°F (49°C). The water temperature in a Longer cycle. 4.1 gal. 3.4 imp. To Cancel a Cycle You can happen if the cycle...

Complete Owner's Guide (English) - Page 7

... filtered wash fluid will remove remaining food particles. The upper rack is completely empty before loading. Long-handled knives and utensils can reach all inside surfaces. Unless the dishwasher is ...rinse only cycle to rinse off these food soils. • Load racks so that water can be loosened before starting dishwasher. Fold up to sit for better cleaning and draining....

Complete Owner's Guide (English) - Page 8

...empty, you don't have to wash a wide assortment of items when ...12 place settings standard loading pattern. 8 PREPARING AND LOADING DISHES Upper Rack Cycle The UPPER RACK option can be placed along the edge so they do...the spray arm rotation. Large items should be used to wait anymore for clean glasses. STEMWARE HOLDER/CUPSHELF not available on all models. Tilt slightly for plates...

Complete Owner's Guide (English) - Page 9

... the spray arm. Adding a Dish To add or remove items after wash cycle starts: • Unlatch door and wait a few seconds until wash action stops before opening. • Add the item and wait a few seconds to allow cold air to slowly expand inside dishwasher. • Close door firmly to do so may vary from...

Complete Owner's Guide (English) - Page 10

...dishwashing detergent tabs, place one uncovered cup. Completely Full (water softener recommended) Top Rack 2 teaspoons (Main Wash cup- 1/4 full) Rinse Only No Detergent 5 teaspoons (Main Wash cup-fill to line above "Regular") Hard Water (9-12 grains) 8 teaspoons (each cup-fill to line above "Regular") No Detergent 8 teaspoons (Main Wash cup- Detergent Usage Guide Cycle Heavy Wash...

Complete Owner's Guide (English) - Page 11

... cap. Dispenser Opening Indicator IMPORTANT Before starting dishwasher. Dispenser Cap Adjustable setting 11 Water entering dishwasher should be completely dry at least 120°F (49°C) to a higher number. The energy required to use is reduced before starting a cycle, run hot water to check the temperature. • If temperature is time to dishwasher must provide water...

Complete Owner's Guide (English) - Page 12

... bleach to your built-in glass trap, grasp handle, rotate, lift out, empty and replace. For cleaning instructions see "Removing Spots and Film" section. Fill both detergent cups and run dishwasher through a HEAVY WASH/POTS & PANS cycle. 4. CARE AND CLEANING WARNING Burn Hazard Allow heating element to make sure they do the following: To Disconnect Service: 1.

Complete Owner's Guide (English) - Page 13

...Food Soils Left on Dishes • Choose another cycle for longer washing time. • Check rack loading section for proper ...Factors Affecting Performance.) • Check water hardness. Dishes not Dry • Select heat dry option. • Make sure the rinse aid dispenser is ...water temperature. Use the Rinse Only cycle or rinse by hand if not operating dishwasher at the far left of the ...

Complete Owner's Guide (English) - Page 14

... drain hose is kinked. • Make sure cycle is complete, not in a pause. Dishwasher Leaks • Use only fresh detergent designed for a number of dishware with a damp cloth. • Check to see if cycle is set correctly. (See Operating Instructions.) • Is dishwasher set for the dishwasher to pause (no heat dry option will be draining properly. (See...

Wiring Diagram (English) - Page 1

...thermal overload protector. 1. Replace control board. 6. Dishwasher water siphons out. 1. Install air gap at dishwasher junction box. 3. GPM approx. 12 Water fill time 87 sec. Detergent left in pump. 1. Instruct customer/user. 3. Exploded View of Wash System Standard Dry Air Flow When the control advances to the "dry" portion of the cycle, a linear actuator retracts a valve, which...

Wiring Diagram (English) - Page 2

... special function initiated from the use . DRYING Drying portion of cycle. CLEAN Shows completion of cycle. All LED's flashing indicates power failure has occurred. Dishwasher will advance the dishwasher to follow this product. SANITIZED The SANITIZED criteria has been met. To cancel cycle Press START/CANCEL. simultaneously press the HI-TEMP WASH and START/CANCEL pads for 3 seconds...

Product Specifications Sheet (English) - Page 1

... it won't interrupt your time at once. designed, built and engineered in : Stainless Silver Mist White (S) (M) (W) Black (B) Bisque (Q) 1 Select model only. Eco-Friendly ENERGY STAR® qualified dishwasher also features an Energy Saver Plus Cycle that are high-performing, more accessible, and more at home. Energy Saver Dry Option No heat dry option. Ready-Select®...

Product Specifications Sheet (English) - Page 2

...5 Heavy Yes Normal Yes Light Yes Delicate Favorite China / Crystal Rinse Only Yes Energy Saver Plus Yes Upper Rack Wash Only Cycle Indicator Light Yes Control Lock Yes B C D Options Heat / No Heat Dry Yes / Yes Hi-Temp Wash Yes A NSF® Certified Sanitize Rinse Yes Delay Start 2-4-6 Hour Rack System Rack Design / Rack Coating Upper Rack - Stemware / Champagne...