Electrolux EI30ES55JS Support Question
Electrolux EI30ES55JS Support Question
Find answers below for this question about Electrolux EI30ES55JS.Need a Electrolux EI30ES55JS manual? We have 3 online manuals for this item!
Question posted by endres on December 26th, 2011
What Is Fault Code 11
Our control panel was beeping and flashing F11. What does F11 mean?
Current Answers
Answer #1: Posted by Odin on December 26th, 2011 5:01 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,680
Member since:
April 10th, 2010 Points: 41,236,680
Serial communication error, which requires replacement of a failed part. More here.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Answer #2: Posted by OnlineOutreachSpecialist on December 27th, 2011 1:27 PM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
If you experience any of these codes, (F11, 12, & 13) disconnect power, wait 30 seconds and reapply power. If fault returns upon power-up, replace EOC - which is the Electronic Oven Control Board. The brains of the unit. If you have to go this route, it is not a typical DIY job. You would need to then contact your manufacturer, Electrolux, at 1-877-435-3287 M-F 8a-8p EST.
Online Outreach Specialist
Related Electrolux EI30ES55JS Manual Pages
Installation Instructions (All Languages) - Page 1
... call the Service Center for
31 1/2"
(80 cm)
Wide
Cooktop Rim.
HEIGHT
B. 30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
United States
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. TOTAL DEPTH TO FRONT OF RANGE
28 5/16" (71,9 cm)
E. Grounded Junction Box or Wall Outlet Should Be Located 8" to 17" (20...
Installation Instructions (All Languages) - Page 2
...cm) clearance for cutout width (E dimension) of the
B
cabinet.
5. 30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
NOTE:
1. Do not pinch the power supply cord or the
flexible gas conduit between
...than 30 1/16" (76,4 cm), make sure the appliance is unprotected.
4. C A D
Side Panel
*** IMPORTANT: To avoid cooktop breakage for
door depth when it . Raise leveling legs and the rear ...
Installation Instructions (All Languages) - Page 3
...Remove the protective channels on illustration 1).
Level the unit if needed. To successfully install the range, the initial level height from floor to the cooktop
voiding the warranty.
Make sure the center... in place to the underside
Space for a 31½" (81 cm) Wide Cooktop. Level the range using
Shave
the two (2) front leveling Raised
1 ½" Max. (3.8 cm Max.)
legs and the...
Installation Instructions (All Languages) - Page 4
...reduce by installing a range hood that project horizontally a minimum of 5 inches beyond the bottom of all controls to the range.
• Do not store items of the range, the range must be certain ...Setups), ANSI Z225.1/NFPA 501Alatest edition, or with local codes in United States and with range. Never leave the oven door open when the range is installed properly, grasp the top rear edge of...
Installation Instructions (All Languages) - Page 5
... installed by means of permanent "hard wiring";
Do not loosen the nuts which secure the factory-installed range wiring to...local code may be connected to terminal block while connecting range. Cord must be either 3 (when local code ...range is required, punch out the knockout. Failure to the connection block located behind the back panel access cover. 30" ELECTRIC SLIDE-IN RANGE...
Installation Instructions (All Languages) - Page 6
... of the frame grounding conductor to remove the supplied grounding strap. Cord Kit Hole. Silver Colored Terminal
Red Wire
Four Conductor Wire Connection to Range
Where local codes does NOT permit connection of the copper power supply cord (see Figure 4). 4. Direct Connection Hole. Punch Out Knockout for 1 3/8" (3.5cm) Dia. Remove the 3 screws...
Installation Instructions (All Languages) - Page 7
...the neutral (white) wire.
listed strain-relief at each end of the appliance. Where local codes permit connecting the appliancegrounding conductor to 4-wire electrical system (see Figure 6): 1.
Supply a U.L....cable wire, and the neutral (white) wire together.
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
Direct Electrical Connection to the Circuit Breaker, Fuse Box or Junction Box...
Installation Instructions (All Languages) - Page 8
... eliminate the risk of your countertop.
• If you have cabinet storage space above range, reduce risk by installing a range hood that projects horizontally a minimum of 5" (12.7 cm) beyond the bottom of ....7 cm) :
2 3/16" (5.56 cm)
2 3/16" (5.56 cm)
29" (73.7 cm)
4 3/8" Min. (11.4 cm)
1¼" (3.2 cm)
You must be level. The oven must also clear 2 3/16" (5.56cm) of material from ...
Installation Instructions (All Languages) - Page 9
...sure the two front leveling legs and the rear
5 leveling wheels (see page 11) are setup higher than the height of the cabinet opening are adjacent to the Use...leveling legs, they are 6 only in the "Installation without side panels" section.
Follow the
instructions under "Leveling the Range".
13 Slide the range into the cutout opening in "Countertop Preparation" section (see section ...
Installation Instructions (All Languages) - Page 10
... you time and expense. It may be level, contact a carpenter to the Use and Care Manual packaged with an electronic oven control.
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
6. Open the range drawer. b.Remove the rear legs using a wrench on and off alternately and the convection fan will stop turning when the oven...
Installation Instructions (All Languages) - Page 11
...
Instructions
To reduce the risk of tipping of the range, the range must be drilled into place making sure structure of the range is trapped by adjusting the 4 levelling legs until the underside of Range
Range
Wall
Floor Floor Mount
Screws
Figure 12
Figure 11
SLIDE BACK
11 Failure to tip over if excessive weight is properly...
Installation Instructions (All Languages) - Page 12
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS NOTES:
12
Product Specifications Sheet (English) - Page 1
...Ranges
Freestanding Ranges
Microwaves
Electric Built-In Range
EI30ES55J S
Luxury-Glide® Oven Rack With a ball bearing system, oven rack is functional.
30" ELECTRIC BUILT-IN RANGE
Control Panel Features
IQ-Touch™ Electronic Oven Control
Yes
Glide-2-Set™ Element Controls...electric codes. Specifications subject to Product Installation Guide for Part Numbers
Included...
Product Specifications Sheet (English) - Page 2
... only. Electrolux Major Appliances, N.A.
Electric Built-In Range
EI30ES55J S
30" Electric Built-In Range Specifications
• Product Weight - 238 Lbs.
• Single phase 3-
or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz, fused on both sides of line with ground. (If local code permits, range may need cut back 3/4" from each front corner...
Similar Questions
Fault Code E 35
I was cooking and suddenly the range stop working and it show a E 35 trouble code. What is the probl...
I was cooking and suddenly the range stop working and it show a E 35 trouble code. What is the probl...
(Posted by pierrerousseau 8 years ago)
My Power Went Out And My Control Panel Will Not Start
(Posted by gadomsch 9 years ago)
Beeping
range (model EI30Es55js OR ew30es65gs) is beeping constantly it is not on HELP
range (model EI30Es55js OR ew30es65gs) is beeping constantly it is not on HELP
(Posted by marilyncaufield 11 years ago)
Control Panel Alarm Went Off - Now Cooktop Won't Respond
My husband was cooking on the stovetop and dripped some water on the control panel and didn't wipe i...
My husband was cooking on the stovetop and dripped some water on the control panel and didn't wipe i...
(Posted by eleclx 11 years ago)
Electrolux Oven Euee63as Will Not Heat. Control Panel Works But No Heat
(Posted by Anonymous-38902 12 years ago)