2013 Dodge Avenger Support Question
2013 Dodge Avenger Support Question
Find answers below for this question about 2013 Dodge Avenger.Need a 2013 Dodge Avenger manual? We have 2 online manuals for this item!
Question posted by dchell1 on March 23rd, 2014
How To Remove Check Oil.
The person who posted this question about this Dodge automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner Manual - Page 29
... Key® "Customer Key Programming." With the RKE transmitter buttons facing down, use a battery deterioration. transmitter apart. Remove and replace the battery. If you do not have a programmed RKE transmitter, contact your fingers. Skin oils may Separating RKE Transmitter Halves apply. NOTE: Perchlorate Material - special handling may cause 1. See www.dtsc.ca...
Owner Manual - Page 100
... loose connections could permit exhaust fumes a collision if they have been damaged (i.e., bent retractor, to seep into Safety Checks You Should Make Inside The the vehicle body is raised or retractor condition, replace the belt. Rear seat belt assemblies... is noticed in the sound of the exhaust Inspect the belt system periodically, checking for lubrication or oil change is immediately.
Owner Manual - Page 102
..., if not equipped from the factory. Objects can cause interference with the pedals. • Check mounting of the vehicle. Failure to prevent them from moving . Additional floor mats and other ...floor coverings on a regular basis. Always properly reinstall and secure floor mats that have been removed for cleaning.
(Continued)
WARNING! (Continued)
• Always make sure that cannot be ...
Owner Manual - Page 103
... lights on the instrument panel. Door Latches Check for excessive tread wear and uneven wear patterns. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 101
Periodic Safety Checks You Should Make Outside The Vehicle Tires Examine tires for positive closing, latching, and locking. Check for fuel, engine coolant, oil, or other objects lodged in the...
Owner Manual - Page 217
...idle the veIf the light comes on and remains on , turn it off. Also, checked by an authorized dealer. service. This can be determined using the procedure shown in "...Light flash or remain on continuously. Further overheating will come first. and the light will 10. Oil Pressure Warning Light single chime will illuminate and a 9. Do In Emergencies" for further information....
Owner Manual - Page 234
...To reset the oil change indica• Check TPM System (with an engine oil change interval. The Oil Change Required message will continue to indicate the next scheduled oil change indicator system... ON/RUN position. Trunk ajar • Remote start the engine.) with a single chime)
Oil Change Required - release the MENU button. Door ajar • Remote start aborted - If Equipped...
Owner Manual - Page 309
...the engine OFF, and remove the ignition key. As with the brake pedal released. Always apply the parking brake fully when parked to guard against unwanted movement.
(Continued)
5 Check by trying to shift out...if it is in reverse. You could injure those in PARK. Once the key is removed, the transmission is locked in PARK, securing the vehicle against vehicle movement and possible injury...
Owner Manual - Page 401
... happens, the "HOTOIL" message flashes in removing heat from the engine cooling system. The A/C system adds heat to the engine cooling system and turning the A/C off . NOTE: The vehicle speed is on a hot day, the engine oil temperature may of 53 mph (85 km/h).
Engine Oil Overheating (2.4L Engine Only) -
WHAT TO DO...
Owner Manual - Page 411
... lug nuts with wheel covers, install two lug nuts on the mounting WARNING! Check the tire pressure as soon as required. Correct the tire pressure as possible. assembly... tire in personal injury.
6 Failure to the jack assembly and stow it is Road Tire Installation free. Remove the wheel blocks and lower the jack until the vehicle has been lowered. To ease the installation process for ...
Owner Manual - Page 433
... when the engine is shut off. Do not use only the specified fluid for the flushing procedure. Engine Oil Checking Oil Level To assure proper engine lubrication, the engine oil must be maintained at regular intervals, such as the chemicals can damage your vehicle and also allow extended maintenance intervals. The best time to...
Owner Manual - Page 442
...® Spray White Lube to assure quiet, easy operation and to remove dust and grit; The external lock cylinders should be lubri- When ... ensure proper function. Apply a small 8. after lubricating excess oil and grease should be lubricated twice a year, preferably in the need to install the filter properly will remove accumulations of the wiper blades and the tailgate, sliding doors ...
Owner Manual - Page 443
...check the fluid level in the engine compartment. reservoir with blades clean.
They could ignite and burn you. This mance of blades may cause deterioration of use washer fluid when using the wiper blades to remove... lines or wet spots. present, clean the wiper blades or replace as engine oil, gasoline, etc. This will help blade performance. WARNING!
Fill the
Operation of...
Owner Manual - Page 450
...are a safety precaution. To prevent ingestion by a child or pet, seek emergency assistance immediately. Check (antifreeze) in puddles on the bottle when the engine is adequate. 448 MAINTAINING YOUR VEHICLE
... up any ground spills immediately. If ingested by animals or children, do not remove the pressure cap while the system is Six-Cylinder Engines - Coolant Level Four-Cylinder...
Owner Manual - Page 451
... vapor will soon dissipate. • Do not overfill the coolant expansion bottle. • Check the coolant freeze point in the radiator and in the coolant expansion bottle. Advise your engine...only be safely driven. This is satisfactory, the coolant bottle need to remove the radiator cap unless checking for proper corrosion ized when the thermostat opens, allowing hot engine protection...
Owner Manual - Page 453
...brake fluid. Brake fluid in the system. Using the wrong type of the master cylinder area before removing the cap.
However, low fluid level may be caused by a leak and a checkup may cause ...information. Fluid level can severely damage your vehicle is not recommended because it may be checked when pads are replaced. MAINTAINING YOUR VEHICLE 451
Clean the top of brake fluid can...
Owner Manual - Page 456
Remove the dipstick and determine if the fluid is at least 15 miles (24 km). Cold fluid is hot or cold. Check for the oil to fully engage in each gear position (allowing time ...176; F (82° C), which is the normal operating temperature after checking or replenishing fluid, make sure that the holes in PARK. 5. Then, remove the dipstick and note the fluid level on both sides. Do not ...
Owner Manual - Page 462
... Use soap and warm water to maintain the original condition. Stubborn soils can be removed promptly with a damp taken to clean if absolutely necessary. Application of dirt undesirable...which minimizes reflections in the windshield. Do not use polishes, oils, cleaning fluids, lent, then MOPAR® Spot & Stain Remover or equivalent solvents, detergents, or ammonia-based cleaners to ...
Owner Manual - Page 474
...lower fascia cutout is 1. Rotate the bulb and connector ¼ turn counterclockwise. 4.
Access to allow access and remove 2. Do not touch the new bulb with a new one. Open the trunk and gently pull back the ... an oily surface, clean the bulb with rubbing alcohol. Oil contamination will severely shorten bulb life. 472 MAINTAINING YOUR VEHICLE
Fog Lamps
Backup Lamps
1. housing. 3.
Owner Manual - Page 480
..." in for scheduled maintenance. Based on engine operation conditions, the oil change indicator message will reset the oil change indicator message after completing the scheduled oil change. Once A Month Or Before A Long Trip: • Check engine oil level • Check windshield washer fluid level • Check the tire inflation pressures and look for further information NOTE: Under...
Owner Manual - Page 481
... fluid levels of the coolant reservoir, brake master cylinder, power steering and transmission as needed • Check function of irregular wear, even if it occurs before the oil indicator system turns on the following page for the required maintenance intervals. Rotate at the first sign of all interior and exterior lights Required...
Similar Questions
Malfunction Indicator Light
My malfunction indicator light all of a sudden came on what could be the problem
My malfunction indicator light all of a sudden came on what could be the problem
(Posted by stw1158 7 years ago)
Check Oil Light
Check oil light came on. checked oil and was 1/2 qt low. added and light went out. Couple days later...
Check oil light came on. checked oil and was 1/2 qt low. added and light went out. Couple days later...
(Posted by dougb44968 8 years ago)
Check Engine Light Stuck On
My check engine light is on. The light is steady yellow. What should I do?
My check engine light is on. The light is steady yellow. What should I do?
(Posted by camisuewho 10 years ago)
How To Check The Brake Oil In A 2008 Dodge Avenger
(Posted by bizzyVIR 10 years ago)
Having More Trouble Out Of My Car And Frustrated. Noticed Oil On Spark Plugs
My car has been hesitating when the gas is pressed since we got it and we bought it new from the lot...
My car has been hesitating when the gas is pressed since we got it and we bought it new from the lot...
(Posted by custermaryann 11 years ago)