Programming Dish Remote Volume Does Not Work For Tv

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BeckiBwithDISH on April 26th, 2014 7:23 PM

This answer was accepted by the poster of the original question.

BeckiBwithDISH

Member since:
December 23rd, 2010

Points: 144,270

1,100
points

I would be happy to help you get this resolved! What brand TV do you have? What model remote do you have? You can find this on the back at the top of the remote and it will be a number between 3.0 and 20.0. The following link gives you information on programming the remote to the TV. Please email me at [email protected] for further assistance!

http://www.mydish.com/support/program-to-tv-code-non-basic

Becki Barned
DISH Internet Response Team
[email protected]

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : 942 : Install : 942 Initial Install
...Cable) as each remote TV to view satellite programming. Connect 942 to TV2(s): Connect each remote TV. Find three side-by -side channels you can see a picture from the Point Dish/Signal screen and ...and correct resolution for Remote Control 2 to the same channel as the three side-by -side channels on each remote TV that the Recover button works for each remote TV to the off -air...
Tech Portal : Remotes : How To : SAT TV Autotune
... be used for TV1, channel 3 or 4 should be programmed into the remote control the correct TV channel used for 5.3 and 6.3 remote controls). The steps in VCR mode to program the channel sent to the TV, not an input. Disabling SAT Auto–Tune Press STAR (*), then press VOLUME DOWN. Removing SAT Auto–Tune Press STAR (*), then...
Tech Portal : (choose receiver model) : How To : Setting Internal Volume Control
... © Highlight and select DISH Receiver Remote Volume Control or TV Remote Volume Control. This is a good tool to use a universal remote with the receiver's internal volume control, address the TV mode to 222 and address the AUX mode to adjust the volume through the receiver. Press View on the remote. The TV's volume control should be turned up the Internal...