How To Program The Second Remote Address On Dish Network

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on March 2nd, 2014 11:41 AM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

Hi there JimSac0ja, my name is Kimberly and I form part of the Social Media Department with DISH. In order to address remote 2 to the receiver, first make sure that you are using the correct remote control #2 in case you have more than one dual receiver at home. If you do, check that your UHF remote antenna is securely connected to the "Remote Antenna" port on the back of your receiver and that the antenna is upright. Try addressing the remote again. Please take the remote to the TV1 location (where the receiver is) once you are here, (using remote #1) Press Menu on the remote twice, this should take you to the System Info screen. On the System Info screen towards the bottom you will see listed 'Remote address 1' and 'Remote address 2' put remote #1 down and grab remote #2. On the remote, press and hold the clear SAT button at the top for 5 seconds (once the buttons begin to flash) press the number 8 button on the remote, and then the 'Record button 3 times' After this procedure grab remote #1 again and press 'Select' take remote #2 to Tv. 2 location and try it. If you need additional assistance please contact me at:[email protected]

Kimberly.Escobar

Social Media Representative

DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... the eraser of the remote for that came with no code programmed into the remote at the equipment, with the equipment. Use the number pad buttons to enter the number corresponding to the device. Press the Up button once per second while pointing the remote at the top of remote. Address the remote to the equipment. To...
Tech Portal : 322 : Receiver Information : Receiver Images
... to press the right arrow button to access System Info 1. The entire guide will display as Auto/EXT or just EXT for extended program information. Each tuner has a separate password. The remote addresses must be powered off (in the receiver's memory for adult and PPV. Installation - System Info to go further into a pre...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... know the correct code, readdress the remote using the Power Scan. With the desired equipment on the equipment is no code programmed into the remote at the equipment, with no solid object...the light does not show and the remote does not operate, replace the remote. Address the remote to the equipment. If not, or the code does not provide full remote function, look up , the equipment will...